November 22, 2010
REPLACING THE ARMREST
HT-5020
It is imperative that Human Touch® products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 3
Tools Required: 5-mm Allen wrench, flat-head screwdriver. NOTE: SAVE ALL PARTS FOR USE DURING REASSEMBLY.
REMOVING THE ARMREST
1. Power off the chair, then unplug it.
2. Remove all pads from the chair (Fig.1).
3. Using a 5-mm Allen wrench, remove the two Allen screws/washers that secure the armrest to the seat frame (Fig.2).
4. Lift up on the armrest to remove it from the chair (Fig.2).
Allen bolt
Armrest
Washer
5-mm Allen wrench
(Fig.2)
(Fig.1)
1
|