06/01/08
X1103
REPLACING THE FOOT AND CALF MASSAGER
HT-270
To ensure that Human Touchproducts are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 3
Nail clipper or other instrument suitable for cutting zip ties, Phillips-head screwdriver, flat-head
screwdriver, vice grip, small hammer.
NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
REMOVING THE MASSAGER
1. Locate
massager (Fig.1).
2. Using a Phillips-head screwdriver, remove the two screws that secure the
connector box cover, remove the cover, then disconnect the red connector.
3. Cut any zip ties that secure the cable that runs from the backrest to
the foot and calf massager, to free the cable from the chair base.
4. Standing in front of the foot and calf massager, detach the upholstered flap that
covers the massager frame (Fig.2).
(Fig.1)
NOTE: It is helpful to flip the upholstered flap up onto the seat cushion and place an
object on top of it to hold it out of the way.
(Fig.2)
1
INSTALLING THE NEW MASSAGER
1. Place the new massager into position, then insert pin A just far enough into the left side of bracket A to hold it in place.
2. Line up the actuator bracket with the mounting point on Bracket A, then push the pin through the bracket as far as it will go by hand.
3. Line up the left side of the massager with Bracket B, then insert Pin B through the bracket as far as it will go by hand.
4. Use a small hammer to push both pins until the pin heads are flush with the bracket.
5. Using a Phillips-head screwdriver, replace the two brackets on the front of the massager frame and secure them using the screws you
removed earlier.
6. Reinstall the upholstered flap, by wrapping it around the massager frame and securing it using the hook and loop fasteners.
7. Reconnect the red connectors on the lower left-hand side of the backrest.
8 Replace the connector box cover and secure it, using a Phillips-head screwdriver and the two screws you removed earlier.
9. Install new zip ties to replace those you removed earlier, to secure the massager cabling to the chair base, out of sight.
Pin B Bracket B
Brackets
Bracket A
Please send any questions or comments regarding these instructions to: [email protected]
© 2008 Human Touch LLC.
3
|