Havis Shields P REAR 1 W User Manual

INSTALLATION INSTRUCTIONS

P-REAR-1 W/P-MFK-9

REAR PARTITION W/FILLER PANEL MOUNTING KIT

1997-2008 CHEVROLET PASSENGER VANS

Always!

ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.

ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

ꢀ Use hardware provided with install kit

TOOLS REQUIRED:

Power drill

Drill bit set

Standard socket set

Ratcheting wrench

COMPONENTS:

QTY DESCRIPTION

PART #

Partition

Mounting Filler Kit

P-REAR-1

P-MFK-9

P-MFK-9 COMPONENTS:

QTY DESCRIPTION

Passenger Side Filler Panel

Driver Side Filler Panel

HARDWARE:

QTY DESCRIPTION

PART #

¼” x 1 ½” Hex Head Lag bolts

¼” x 3” Hex Head Lag bolts

GSM33062

GSM33094

INSTALLATION:

• Place and position partition with spring clips facing towards rear of vehicle.

• Bottom frame of partition will be approximately 8 ½” from edge of door Frame.

• Partition will contour trim just inside rear doors of vehicle.

• Drill 3/16” pilot holes into floor of vehicle.

• Loosely bolt partition to vehicle using ¼” x 1 ½” Hex head lag bolts.

• Pre-drill top mounting holes with 3/16” bit. Attach to vehicle using ¼” x 3” Hex head

lag bolts.

• Tighten all loose hardware

• Install seat back to its original position.

P-REAR-1^MFK-9_INST_9-07