Fujitsu FJBC GP User Manual

Fujitsu Computer Systems Corporation  
Battery Charger User’s Guide  
This user’s guide contains information on your battery charger.  
We strongly recommend that you read this guide before using  
the battery charger even if you are already familiar with computers.  
BATTERY CHARGER COMPONENTS  
Battery  
Connector 2  
Battery  
Connector 1  
Power  
Indicator  
LED  
AC Adapter  
Connector  
Charge Indicator LEDs  
Figure 1. Battery Charger Components  
Power Indicator LED  
The Power Indicator LED is on when power is being supplied from  
the AC adapter.  
1
BATTERY CHARGER OPERATION  
The Power Indicator LED is on when the battery charger is  
connected to a plugged-in AC adapter. The two Charge Indicator  
LEDs show the charging status of the battery connected to the  
charger or the condition of the charger itself, as shown in Table 1.  
Charge Indicator  
Flashes orange  
Steady orange  
Steady green  
Steady red  
Charging Condition  
Standing by for charging  
Charging  
Charging is complete  
Battery failure  
Flashing red  
No light  
Charger failure  
Battery not connected  
Table 1. Indicator Status  
• If the charger detects that something is  
wrong with the battery, the Charging  
Indicator LED will turn a steady red. If this  
happens, immediately remove the battery  
from the charger.  
• If the battery charger detects a failure in its  
charging circuit, the Charging Indicator LED  
will blink red. If this happens, immediately  
disconnect the AC adapter and remove the  
battery from the charger.  
3
The following items can affect the battery charger’s performance:  
After a battery has been charging for a period (as noted below),  
the battery charger will stop charging (regardless of the charge  
level) and the Charge Indicator LED will turn green. This is a  
safety feature to prevent damage to the battery.  
Battery Capacity  
Less than 2500 mAh  
2500 mAh to 4100 mAh  
Over 4100 mAh  
Charging Time  
5 hours  
8 hours  
12 hours  
When a battery has been left unused for a long time, it will take  
longer to charge.  
When the ambient temperature is low, it will take longer to  
charge a battery.  
If the temperature of a battery connected to the charger is  
extremely high or low, the battery charger will standby for charg-  
ing until the battery returns to normal temperature. This is a  
safety feature designed to prevent damage to the battery.  
USING THE BATTERY CHARGER  
To charge a battery, follow these steps:  
1. Connect the battery charger to the AC adapter.  
2. Plug the AC adapter into an AC outlet. (Figure 2)  
3. The Power Indicator LED will light up and the Charging Indi-  
cator LED(s) will flash orange once.  
4. When the Charging Indicator LED(s) turns off, align the plastic  
key pin of the battery connector with the corresponding guide  
in the battery socket. Be very careful to align the battery and  
charger properly. (Figure 3)  
4
• The charger can have two batteries con-  
nected at the same time, but it charges only  
one at a time. The battery that was con-  
nected first is charged first. The second bat-  
tery is held in a wait status until the first  
battery is completely charged.  
• Charging time varies depending on the  
environmental conditions (such as tempera-  
ture) or deterioration of the battery(s).  
5. The Charging Indicator LED(s) will turn orange when the  
battery(s) is being charged.  
6. The Charging Indicator LED(s) will turn green when charging  
is completed.  
Figure 2. Connecting the AC Adapter  
5
Note that the  
battery shown is for  
illustration only; your  
battery may appear different.  
Figure 3. Connecting the battery  
CARE AND MAINTENANCE  
Never connect the battery charger to a physically defective  
battery or use a defective charger.  
When the battery charger is not being used for charging, be sure  
to disconnect the AC adapter and remove any battery connected  
to the charger to avoid the chance of fire or equipment failure.  
When disconnecting the AC adapter, do not pull on the cable to  
remove the adapter. Always remove by grasping the plug body.  
If the battery charger smokes, smells strange, heats abnormally,  
or makes noise, immediately disconnect the AC adapter, and  
contact your Fujitsu reseller (see “Fujitsu Computer Systems  
Contact Information” below). It is normal for the charger to  
become slightly warm during charging.  
Do not use the battery charger in humid, dusty, or poorly  
ventilated places.  
Do not use the battery charger if any foreign substance, such as  
water, dirt, etc. has gotten inside.  
6
TECHNICAL SUPPORT  
Fujitsu Computer Systems Contact Information  
If you have problems you are unable to resolve, consult your  
support representative, toll free at:  
1-800-8FUJITSU (1-800-838-5487)  
SPECIFICATIONS  
Specification  
Details  
16V/40W  
This unit is to be powered by  
the power supply, UL Listed  
and class 2 adapter, rated 16  
Vdc, 2.5A  
Power Requirements  
Operating Temperature  
Operating Humidity  
5°C – 35°C  
10% to 90%  
Maximum Outer  
Dimensions  
3.9" x 3.54" x 1.2" (100 mm x  
90 mm x 30 mm)  
Weight  
0.5 lbs. (230g)  
7
DECLARATION OF CONFORMITY  
according to FCC Part 15  
Responsible Fujitsu Computer Systems Corporation  
Party Name:  
Address: 1250 E. Arques Avenue (M/S 122),  
Sunnyvale, California 94085  
Telephone: (408) 746-6000  
Declares that product: Battery Charger Model FJBC-GP  
(FCS Part Number FPCBC26)  
Complies with Part 15 of the FCC Rules.  
This device complies with Part 15 of the FCC rules. Operations are subject  
to the following two conditions:(1) This device must not be allowed to cause  
harmful interference, (2) This device must accept any interference received,  
including interference that may cause undesired operation.  
Declaration of Conformity  
Model Name: Battery Charger FJBC-GP  
Conformance to Directive(s)/Product Standard:  
89/336/EEC and 73/23/EEC  
8
FCC Notices  
Notice to Users of Radios and Television  
These limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses, and  
can radiate radio frequency energy and, if not installed and used in accor-  
dance with the instructions, may cause harmful interference to radio commu-  
nications. However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful interference to  
radio or television reception, which can be determined by turning the equip-  
ment off and on, the user is encouraged to try to correct the interference by  
one or more of the following measures:  
Reorient or relocate the receiving antenna.  
Increase the separation between the equipment and receiver.  
Connect the equipment into an outlet that is on a different circuit than  
the receiver.  
Consult the dealer or an experienced radio/TV technician for help.  
Shielded interconnect cables must be employed with this equipment  
to ensure compliance with the pertinent RF emission limits  
governing this device.  
DOC (Industry Canada) Notices  
Notice to Users of Radios and Television  
This Class B digital apparatus meets all requirements of the Canadian Inter-  
ference-Causing Equipment Regulations.  
CET appareil numérique de la class B respecte toutes les exigence du Régle-  
ment sur le matérial brouilleur du Canada.  
Notice to All Users  
The Battery Charger can only be operated at a maximum ambient tempera-  
ture of 35° C (95° F).  
9
10  
11  
Warning  
Handling the cord on this product will expose  
you to lead, a chemical known to the State of  
California to cause birth defects or other  
reproductive harm.  
Wash hands after handling.  
Fujitsu Computer Systems Corporation  
1250 E. Arques Avenue, (M/S 122)  
Sunnyvale, California 94085  
For more information, call 1-800-FUJITSU  
or visit our Web site at:  
For technical support call:1-800-8FUJITSU (1-800-838-5487) or e-mail  
Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu Ltd. All other  
trademarks mentioned herein are the property of their respective owners.  
Product description data reflects Fujitsu design objectives and is provided for  
comparative purposes; actual results may vary based on a variety of factors.  
Specifications are subject to change without notice.  
© 2008 Fujitsu Computer Systems Corporation. All rights reserved.  
B5FY-8881-01EN-00  
12  

AdobeAir RF093948 User Manual
Briggs Stratton Automobile Parts 290000 User Manual
Briggs Stratton VANGUARD 588447 User Manual
Chauvet Automobile Accessories F 1700 User Manual
Fisher Price LIL& #39; QUAD K4565 User Manual
Friedrich HA24K25L User Manual
FujiFilm Phaser 7750DFX User Manual
Genie Air Conditioner AG_05 User Manual
Haier JF U40B User Manual
Heat Controller PD 91B User Manual