Epson AcuLaser CX11N User Manual

Epson AcuLaser^®CX11N/CX11NF

Packing Instructions

If you need to ship the Aculaser CX11N/CX11NF, follow these steps to package it to

prevent damage during transit:

1. Make sure the CX11N/CX11NF is turned on, then press the

Setup button

The Setup light turns on and the LCD screen displays Setup Mode for a few

seconds, then changes to the Setup menu screen.

2. Use the u or d button to select Scan Settings, then press the r button.

3. Use the u or d button to select Carriage Lock, then press the r button.

4. Set the transportation lock on the left side of the document table to the

position.

locked

5. Slowly flip back the scanner until it

stops.

6. Close the output tray extension, then

Cover B

lift up cover B.

7. Pull up the orange lever inside

cover B.

8. Lift out the photoconductor using its

handle.

9. Package the photoconductor in a

separate box or bag large enough to

hold it.

Note:

Do not remove the toner cartridges.

10. Flip down the orange lever, then close cover B.

11. Slowly push down the scanner to its original position.

15. Attach foam to the top corners of the CX11N/CX11NF as shown below:

16. Lower the top of the original box and attach the four white handles, turning them

to the closed (locked) position. Then tape the top of the box closed with shipping

tape.

OPEN

CLOSED

CPD-20616

Printed in XXXXXX XX.XX-XX XXX