NOTE:
Please read all instructions
carefully before using this
product
Safety Notice
Hardware Identifier
Assembly Instruction
Parts List
POWERHOUSE CLUB
PHC 710
Warranty
Ordering Parts
Model
PHC 710
Retain This
Manual for
Reference
07-17-01
OWNER'S
MANUAL
IMPEX FITNESS PRODUCTS
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire
manual before you assemble or operate your machine. In particular, note the following
safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE
AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended this machine to be assembled by two
or more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Rear Upright Beams (#1) by a Cross Brace (#5) in the mid-span. Align the
holes and secure them with one Triangle Bracket (#12), one Bent Bracket (#13), two
M10 x 3 ½” Carriage Bolts (#34), two M10 x 2 3/8” Carriage Bolts (#36), four ∅ ¾”
Washers (#43), and four M10 Aircraft Nuts (#42) on each end of the Cross Brace.
B.) Attach the Front Stabilizer (#2) to the front of the Main Seat Support (#3). Secure it with
one M10 x 2 ½” Carriage Bolt (#47), two M10 x 2 ¾” Carriage Bolts (#35), ∅ ¾”
Washers (#43), and M10 Aircraft Nuts (#42).
C.) Attach the back of the Main Seat Support (#3) to the Cross Brace (#5). Secure it with
one Bracket (#14), two M10 x 2 3/8” Carriage Bolts (#36), ∅ ¾” Washers (#43), and
M10 Aircraft Nuts (#42).
D.) Insert two Crutches (#7) into the top openings on the Upright Beams. Secure them with
two Lock Knobs (#33) through selected holes to obtain desired height of the Supports.
E.) Place Backrest Adjustment Bar (#8) between the two Upright Beams on the selected bar
holder to obtain desired incline of Backrest.
DIAGRAM 1
4
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the Seat Bracket (#4) to the short pivot tube on the Main Seat Support (#3).
Secure it with one M10 x 4 ¾” Allen Bolt (#39) and M10 Aircraft Nut (#42). Place
the Seat Pad (#16) onto the Seat Bracket (#4). Secure it with four M6 x 5/8” Philips
Head Screws (#38) and ∅ ½” Washers (#44). Insert a L-shaped Pin (#31) into the
selected hole on the Seat Bracket to obtain the desired incline of the Seat.
B.) Attach the side-holes of Backrest Supports (#6) to the long pivot tube on the Main
Seat Support (#3). Secure it with one M10 x 7 ¼” Hex Bolt (#46), two ∅ ¾” Washers
(#43), and one M10 Aircraft Nut (#42). Place the Backrest Board (#17) onto the
Backrest Supports (#6). Secure it with four M6 x 1 3/8” Philips Head Screws (#37)
and ∅ ½” Washers (#44).
DIAGRAM 2
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Insert the Leg Developer Holder (#9) into the top opening on the Front Stabilizer
(#2). Secure it with a Lock Knob (#33).
B.) Attach the Leg Developer (#10) to the bracket on the Leg Developer Holder (#9).
Secure it with an Axle (#18), two ∅ ¾” Washers (#43), and two M10 x 5/8” Allen
Bolts (#40). Insert one Foam Roll Tube (#11) halfway through the hole on the Leg
Developer Holder (#9). Insert two Foam Roll Tubes (#11) halfway through the holes
on the Leg Developer (#10). Push six Foam Rolls (#27) onto the Tubes from both
sides. Plug six Foam Roll End Caps (#26) into the ends.
C.) Slide the Olympic Sleeve (#15) onto the weight post on the Leg Developer (#10).
Attach a Spring Clip (#32) onto the Olympic Sleeve. NOTE: When using the
decline position to do Ab exercise, place at least 30lbs of weights on the post to hold
down the Leg Developer.
ꢀ
ꢀ
DIAGRAM 3
6
Download from Www.Somanuals.com. All Manuals Search And Download.
ꢀ
7
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO. DESCRIPTION
Q’ty
1
2
3
4
5
6
7
8
Rear Upright Beam
Front Stabilizer
Main Seat Support
Seat Bracket
Cross Brace
Backrest Support
Crutch
Backrest Adjustment Bar
Leg Developer Holder
Leg Developer
Foam Roll Tube
Triangle Bracket
Bent Bracket
2
1
1
2
2
2
2
1
1
1
3
2
2
1
1
1
1
1
2
2
1
2
1
2
1
6
6
1
2
2
1
1
3
4
2
6
4
4
1
2
4
14
16
8
2
1
1
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
Bracket
Olympic Sleeve
Seat Pad
Backrest Board
Axle
Leg Developer Bushing
2 3/8” End Cap
1 ¾” Square End Cap
1” Square End Cap
∅ 1” End Cap
∅ 1 1/8” End Cap
∅ 1” Cone-shaped Cap
Foam Roll End Cap
Foam Roll
2” Leg Developer Holder Sleeve
Inner Cap
3” Sleeve
L-shaped Pin
Spring Clip
Lock Knob
M10 x 3 ½” Carriage Bolt
M10 x 2 ¾” Carriage Bolt
M10 x 2 3/8” Carriage Bolt
M6 x 1 3/8” Philips Head Screw
M6 x 5/8” Philips Head Screw
M10 x 4 ¾” Allen Bolt
M10 x 5/8” Allen Bolt
3/8” Philips Head Screw
M10 Aircraft Nut
∅ ¾” Washer
∅ ½” Washer
Bushing
M10 x 7 ¼” Hex Bolt
M10 x 2 ½” Carriage Bolt
8
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase.
This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to
replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights on products returned to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused by
or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided by
an IMPEX authorized service center or for products used for commercial or rental purposes. No other
warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the
above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line at www.impex-fitness.com
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
9
Download from Www.Somanuals.com. All Manuals Search And Download.
|