solar spotlight with led
bulbs
Model 95388
asseMbly and operation instructions
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
to preVent serious injury, read and understand
all warnings and instructions before use.
©
®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
for technical questions or replacement parts, please call 1-800-444-3353.
Download from Www.Somanuals.com. All Manuals Search And Download.
11.
12.
warning: nicd batteries must be disposed of properly. Do not incinerate. Batteries
may burst, causing personal injury and/or property damage. Contact your local hazardous
waste disposal authority for proper disposal.
People with pacemakers should consult their physician(s) before using this product. Elec-
tromagnetic fields in close proximity to a heart pacemaker could cause interference to or
failure of the pacemaker.
unpacKing
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
asseMbly and operating instructions
note: For additional information regarding the parts listed in the following pages, refer to the As-
sembly Diagram near the end of this manual.
1.
2.
WARNING! Make sure the Power Button at the back of the Lamp Housing (5) is in its
“OFF” position before making any adjustments to the Spotlight. See Figure 1.
Decide where you want to place the Solar Spotlight. Choose a location that receives full,
direct sunlight a minimum of six hours a day. The location should not be near nighttime
light sources such as porch lights or streetlights as this may trigger the lights to turn off or
flicker.
3.
4.
The Solar Spotlight will need to charge for at least 6 hours before using it for the first
time.
The light is powered by two “AA” batteries. For directions on how to replace the batteries,
refer to the Replacing the Batteries section on the following page.
Figure 1
Power Button
Lamp Housing (5)
5.
6.
Press the Power Button to the “On” position-see Figure 1.
Pressing the Power Button will automatically turn on the Solar Spotlight during the
night. After the initial charge is set, check to see that the LED Lights (2) are on by
viewing the light at night or in a dark location.
SKU 95388
for technical questions, please call 1-800-444-3353.
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
note: During the day, the Solar Panel converts sunlight into electricity, recharging the
batteries. The amount of light the Solar Panel receives depends on placement of
the Solar Spotlight, geographic location and weather. If the weather is cloudy and
the panel did not receive a full charge, the Solar Spotlight may not achieve the full
hours of operating time. It will catch up on its own after two to three days of full
sun.
inserting the ground stake (11):
1.
Insert the Connecting Shaft Screw (7) into the hole on the Connecting Shaft (6).
Slide the Connecting Shaft 2 (9) onto the Shaft Screw (7) so that Connecting Shaft
(6) and Connecting Shaft 2 (9) are fitted together. Thread on Nut (10) to secure in
place.
2.
3.
Insert Ground Stake (11) up into the Connecting Shaft 2 (9).
warning: Before inserting the Solar Spotlight into the ground, make certain to
choose an area where there are no underground pipes, cables or other obstructions.
Make certain that the ground is soft enough to accept the Ground Stake (11). Gently
insert the Ground Stake (11) into the ground making certain that it is in solid. Make
certain that the Stake is completely inserted into the ground to assure full stability
for the Solar Spotlight.
4.
The Lamp Housing (5) rotates up and down to obtain the best lighting situation.
The Solar Panel (1) pivots on a ball and can be set to a number of different angles
to obtain the best angle for solar power.
replacing the batteries
1.
2.
It is recommended that you replace the batteries every 12 months. Before perform-
ing any maintenance on the Spotlight, make certain that the Power Button is in the
OFF position.
To access the batteries, twist the Lamp Cover (22) and remove it from the Lamp
Housing (5). Then remove the Transparent Cover (21) and Reflecting Bowl (20)
from the Housing (5). The Battery Housing (17) and Batteries (16) are attached to
the Reflecting Bowl (20). See Figure 2, next page.
3.
Remove the old Batteries (16). Make certain that the new batteries are “AA” , Ni-Cd
rechargeable. Install the new batteries into the Battery Housing (17). Make certain
that the batteries are placed according to the correct polarity. Insert the Battery
Housing (17) and Reflecting Bowl (20) back into the Lamp Housing (5). Place the
Transparent Cover (21) back over the Reflecting Bowl (20) and screw the Lamp
Cover (22) back over the Lamp Housing (5).
SKU 95388
for technical questions, please call 1-800-444-3353.
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
Lamp Cover (22)
Reflecting Bowl (22)
Figure 2
Batteries (16)
Maintenance
1.
Clean regularly with a damp towel. Do not use any type of solvent for cleaning. Do
not put too much pressure on the light or components while cleaning. Dry thor-
oughly.
parts list
Part
1
Description
Solar Panel
Q’ty Part
Description
Button Cover
Power Button
Circuit Board
Q’ty
1
1
1
2
2
12
13
14
2
Solar Panel Frame
Screw 1
1
3
1
4
Rotation Bracket
15 Circuit Board
Screw
1
5
6
Lamp Housing
Connecting Shaft 1
Connecting Shaft Screw
Screw 2
1
1
1
1
1
1
16
17
18
19
20
Batteries
Battery Housing
Screw 3
2
1
1
3
1
1
7
8
LED
9
Connecting Shaft 2
Nut
Reflecting Bowl
10
21 Tr a n s p a r e n t
Cover
11
Ground Stake
1
22
Lamp Cover
1
SKU 95388
for technical questions, please call 1-800-444-3353.
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
please read the following carefully
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEM-
BLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
asseMbly diagraM
SKU 95388
for technical questions, please call 1-800-444-3353.
Page 6
Download from Www.Somanuals.com. All Manuals Search And Download.
|