200 LB. Capacity Wood Cart
Model 44599
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright © 2000 by Harbor Freight Tools®. All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Download from Www.Somanuals.com. All Manuals Search And Download.
9. Stay alert. Watch what you are doing, use common sense. Do not operate
any product when you are tired.
10. Check for damaged parts. Before using any product, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and binding
of moving parts; any broken parts or mounting fixtures; and any other
condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician.
11. Do not operate product if under the influence of alcohol or drugs.
Read warning labels on prescriptions to determine if your judgment or
reflexes are impaired while taking drugs. If there is any doubt, do not operate
the product.
Warning:The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Unpacking
When unpacking, check to make sure all parts shown on page 4 are included. If
any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Assembly Instructions
NOTE: All parts below refer to the parts listed on page 4 of this manual.
1. As shown in the diagram on page 5, position the U-Handle [1] inside the
grooves of the Axle & Frame [4]. Attach the U-Handle to the Axle & Frame
using two Bolts [10] on each side of the U-Handle. Add Washer (14) and
secure the Bolts with Nuts [13] provided.
2. Position the Left Frame [7] inside the left groove of the Axle & Frame,
opposite the end with the U-Handle attached. Secure the Left Frame using
two Nuts and Bolts as shown in the diagram. Repeat for the Right Frame [8].
3. Attach the Bracket [9] to the Left and Right Frame pieces using the
remaining Nuts and Bolts. Be sure that the folded edge of the Bracket points
in toward the U-Handle.
4. To attach the Wheels [3], slide one of the Bushing [5] pieces over the Axle
[11], followed by one of the Wheels. Secure the Wheel using a Washer [2]
and Cotter Pin [6]. Repeat for the other Wheel.
5. Insert Caps [12] into the open ends of the tubing in the U-Handle, and the
Left and Right Frame pieces.
SKU 44599
Page 3
REV 12/03
Download from Www.Somanuals.com. All Manuals Search And Download.
Operation
Use your woodcart to carry heavy loads of firewood or other objects without having
to make multiple trips. Place objects in holding area between the handle and the
bracket. As always, be careful when lifting heavy objects, and do not attempt to
carry objects weighing more than 200 lbs. with this product.
Parts List
No.
1.
2.
Description
U-Handle
Washer
Qty.
1
2
20
3.
Wheel Kit
2
4.
5.
Axle & Frame
Bushing
1
2
6.
7.
8.
9.
Cotter Pin
Left Frame
Right Frame
Bracket
2
1
1
1
10.
11.
12.
13.
14.
Bolt M6 x 35
Axle
Cap
Nut M6
Flat Washer 6M
12
1
4
12
12
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THat ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 44599
Page 4
REV 12/03
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly Drawing
14
NOTE: Some parts are listed and shown for illustration purposes only and are not
available individually as replacement parts.
SKU 44599
Page 5
REV 12/03
Download from Www.Somanuals.com. All Manuals Search And Download.
|