Harbor Freight Tools Clothes Dryer 67326 User Manual

Four Post  
Boot & Glove Dryer  
67326  
set uP anD oPeratinG instructions  
®
Distributed exclusively by Harbor Freight tools .  
3491 Mission Oaks Blvd., Camarillo, CA 93011  
visit our website at: http://www.harborfreight.com  
read this material before using this product.  
Failure to do so can result in serious injury.  
save tHis manual.  
©
®
Copyright 2009 by Harbor Freight Tools . All rights reserved. No portion of this manual or any artwork  
contained herein may be reproduced in any shape or form without the express written consent of  
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing  
improvements, actual product may differ slightly from the product described herein. Tools required for  
assembly and service may not be included.  
For technical questions or replacement parts, please call 1-800-444-3353.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
6. Use appliance only for it’s intended  
use, Household use only. Do not use  
outdoors.  
throw rugs, runners or similar  
coverings. Arrange cord away from  
traffic area and where it will not be  
tripped over.  
7. To reduce the risk of electric shock,  
do not immerse the appliance in  
water or other liquids.  
16. Use only in dry environments. Do not  
use in bathrooms, laundry area, near  
sinks or other sources of water.  
8. Never yank cord to disconnect from  
outlet; instead, grasp plug and pull  
to disconnect. Do not use cord as  
a handle or pull cord around sharp  
edges or corners. Keep cord away  
from heated surface. Loop cord  
loosely around appliance when  
storing.  
17. This product is not a toy. Keep it out  
of reach of children.  
18. WARNING: Handling cord on this  
product will expose you to lead,  
a chemical known to the State of  
California to cause cancer, and birth  
defects or other reproductive harm.  
Wash hands after handling.  
9. Always disconnect from electrical  
outlet when not in use.  
(California Health & Safety Code §  
25249.5, et seq.)  
10. Do not operate with a damaged cord,  
or if the appliance has been dropped  
or damaged. To reduce the risk of  
electric shock, do not disassemble  
or attempt to repair the appliance,  
take it to a qualified service person  
for examination and repair. Incorrect  
re-assembly or repair could cause  
a risk of fire, electric shock, or injury  
to persons when the appliance  
19. The warnings, precautions, and  
instructions discussed in this  
instruction manual cannot cover all  
conditions and situations that may  
occur. It must be understood by  
operator that common sense and  
caution are factors which cannot be  
built into this product, but must be  
supplied by operator.  
is used. Use only manufacturer’s  
recommended accessories.  
save tHese  
11. Do not put any object into openings.  
instructions.  
12. This appliance is not for space  
heating purposes.  
13. DO NOT IMMERSE IN WATER. NE  
PAS IMMERGER.  
14. Maintain labels and nameplates on  
the tool. If unreadable or missing,  
contact Harbor Freight Tools for a  
replacement.  
15. Do not run Power Cord under  
carpeting. Do not cover cord with  
SKU 67326  
For technical questions, please call 1-800-444-3353.  
Page 3  
Download from Www.Somanuals.com. All Manuals Search And Download.  
sPeciFications  
120 V~ / 60 Hz / 230 W  
Electrical Requirements with heat, 30 W without  
heat  
Rocker Switch:  
No Heat / Heat  
Timer Switch:  
Off, variable to 3  
hours, with 10 minute  
increments, up to 180  
minutes  
Control  
Knob  
(13)  
Settings  
HouseHolD use only  
Heat  
Switch  
(14)  
e224797  
Figure 2  
unPackinG  
When unpacking, make sure that the  
item is intact and undamaged. If any parts  
are missing or broken, please call Harbor  
Freight Tools at 1-800-444-3353 as soon  
as possible.  
set uP & oPeration  
read the entire rules For  
saFe oPeration section at  
the beginning of this manual  
including all text under  
subheadings therein before set  
up or use of this product.  
comPonents & controls  
Long Tube (2)  
to Prevent  
serious injury  
Wind Tube (17)  
From acciDental  
oPeration or electric  
sHock:  
Control Knob (13)  
Before assembly, cleaning or  
adjustment, make sure the  
cord is unplugged, and the  
unit has cooled.  
Toe Support (3)  
note: For additional information regarding  
parts listed, refer to Assembly  
Diagram at back of manual.  
This dryer is for drying socks, gloves  
and mittens as well as footwear and  
boots.  
Short Tube (1)  
(Inside Long Tube)  
Heat Switch (14)  
Figure 1  
SKU 67326  
For technical questions, please call 1-800-444-3353.  
Page 4  
Download from Www.Somanuals.com. All Manuals Search And Download.  
5. When the items are dry, remove  
them, unplug the unit and store in a  
dry location away from children.  
set up  
For smaller items, place the item  
directly over the Wind Tube (17).  
Pull the wrist area of gloves up over  
the gloves to prevent them from  
restricting airflow.  
note: Drying time will vary depending on  
temperature and humidity.  
Smaller items will dry faster than  
larger items.  
For tall items, such as boots, set up  
the two Long Tubes (2) as follows:  
Footwear should be dried after every  
use to prevent bacteria or fungus  
growth.  
a. Slide the Short Tube (1) inside the  
large end of the Long Tube (2).  
b. Fit the Toe Support (3) onto the  
remaining end of the Long Tube,  
sliding the Tube edge into the slot on  
the Toe Support.  
c. To Safely balance the unit, slide the  
Tube assemblies over diagonally  
opposite Wind Tubes (17). The Short  
Tube holes are off center, so check  
to make sure that the thinner side  
of the tube is closest to the center  
of the unit so you will have plenty of  
room to slide the boot in place.  
d. Slide the boot over the Tube  
assemblies, making sure that the  
entire unit is balanced so it will not  
tip over during use.  
operation  
1. Place the dryer on a flat, level  
surface. Set the control knob to the  
off position.  
2. Plug the unit into a 120V outlet.  
3. Select Heat or No Heat with the Heat  
Switch (14).  
4. Set the Control Knob (13) to the  
desired drying time. To set the time  
to less than one hour, turn the Knob  
past the one hour mark, then return it  
to the desired time.  
SKU 67326  
For technical questions, please call 1-800-444-3353.  
Page 5  
Download from Www.Somanuals.com. All Manuals Search And Download.  
insPection anD  
maintenance  
to Prevent  
serious injury  
From acciDental  
oPeration or electric  
sHock:  
Before appliance inspection or  
maintenance, make sure the  
cord is unplugged, and the unit  
has cooled completely.  
to Prevent serious injury  
From aPPliance Failure:  
Do not use damaged  
appliances. if abnormal noise  
or vibration occurs, have the  
problem corrected before  
further use.  
1. BeFore eacH use, inspect  
condition of the dryer. Check for loose  
screws, cracked or broken parts, and  
any other condition that may affect its  
safe operation.  
2. Clean regularly to prevent dust from  
accumulating on surfaces. Use a  
damp cloth to clean, then dry before  
use.  
3.  
WarninG! if the supply cord  
of this tool is damaged, it must  
be replaced only by a qualified  
service technician.  
SKU 67326  
For technical questions, please call 1-800-444-3353.  
Page 6  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Parts list  
Part  
Description  
Qty  
2
2
2
1
1
1
1
1
Part  
Description  
Qty  
1
4
1
1
1
1
1
2
1
2
3
4
5
6
7
8
9
Short Tube  
16 Wire Mesh  
Long Tube  
17 Wind Tube  
18 Top Stand  
Toe Support  
Power Cord  
Right Enclosure  
Power Cord Connector  
Motor Bracket  
Motor  
19 Bottom Stand  
20 Right Plate  
21 Right Mica Plate  
22 Heating Element  
23 Side Mica Plate  
24 Side Plate  
Fan  
1
2
10 Left Enclosure  
11 Timer  
12 Control Panel  
13 Control Knob  
14 Heat Switch  
15 Heater Assembly  
1
1
1
1
1
1
25 Middle Mica Plate  
26 Thermostat  
27 Fuse  
28 Left Mica Plate  
29 Left Plate  
2
1
1
1
1
10  
9
8
7
4
5
6
3
11  
12  
13  
14  
15  
2
16  
17  
29  
28  
27  
26  
25  
1
24  
23  
22  
21  
18  
20  
Heater Assembly (15)  
19  
SKU 67326  
For technical questions, please call 1-800-444-3353.  
Page 7  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Please reaD tHe FolloWinG careFully  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLy DIAGRAM  
IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES  
ANy REPRESENTATION OR WARRANTy OF ANy KIND TO THE BUyER THAT HE OR SHE IS qUALIFIED  
TO MAKE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS qUALIFIED TO REPLACE ANy PARTS  
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR ExPRESSLy STATES THAT  
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN By CERTIFIED AND LICENSED  
TECHNICIANS, AND NOT By THE BUyER. THE BUyER ASSUMES ALL RISK AND LIABILITy ARISING OUT OF  
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT  
OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.  
Parts list anD assemBly DiaGram  
record Products serial number Here:  
note:If product has no serial number, record month and year of purchase instead.  
note:Some parts are listed and shown for illustration purposes only, and are not available individually as  
replacement parts.  
SKU 67326  
For technical questions, please call 1-800-444-3353.  
Page 8  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Greenheck Fan Smoke Alarm SMD 401M User Manual
Grizzly Drill G0643 User Manual
GSI Outdoors Electric Heater VHC User Manual
HANNspree Flat Panel Television DT02 10H1 User Manual
Hans Grohe Indoor Furnishings 10020XX User Manual
Heat Glo LifeStyle Indoor Fireplace XLR PLUS N AU User Manual
Honeywell Scanner MS7180 User Manual
Hypertec Mouse KYBAC260 PS2BLKUSHY User Manual
Ice O Matic Outdoor Storage B100 User Manual
Image Home Gym IMTL39620 User Manual