GE Telephone 20909690 User Manual

FOLD  
FOLD  
FOLD  
2-9120 /2-9130  
Color Series  
MODULAR JACK REQUIREMENTS  
WALL MOUNT INSTALLATION  
FCC REGISTRATION INFORMATION  
Your GE telephone equipment is registered with the Federal Communica-  
tions Commission and is in compliance with parts 15 and 68, FCC Rules  
and Regulations.  
You need an RJ11 (CA11) type modular  
jack, which is the most common type of  
phone jack and might look like the one  
pictured here. If you don’t have a modular  
jack, call your local phone company to  
find out how to get one installed.  
1a. If the modular phone jack is in  
the base plate on the wall  
where you're going to mount  
your phone, just plug the  
telephone line cord into the  
jack; mount the phone on the  
posts; and set the RINGER  
switch and PULSE/TONE  
switch (described in detail  
below).  
1b. If the modular phone jack is  
near the floor and you want  
to mount the phone on the  
wall, remove the telephone  
line cord from the pocket that  
is on the bottom of the phone.  
Unscrew the circular cord  
cover on the bottom of the  
phone with a Philips screw-  
driver. Wrap the phone cord  
around the circular guide and  
screw the circular cord cover  
in place.  
1a  
1
Notification to the Local Telephone Company  
Telephone  
User's Guide  
On the bottom of this equipment is a label indicating, among other  
information, the FCC Registration number and Ringer Equivalence  
Number (REN) for the equipment. You must, upon request, provide  
this information to your telephone company.  
The REN is useful in determining the number of devices you may  
connect to your telephone line and still have all of these devices ring  
when your telephone number is called. In most (but not all) areas, the  
sum of the RENs of all devices connected to one line should not  
exceed 5. To be certain of the number of devices you may connect to your  
line as determined by the REN, you should contact your local telephone  
company.  
INSTALLATION  
2
3
2-9120  
2-9121  
2-9122  
2-9123  
2-9124  
2-9126  
2-9127  
2-9130  
DESKTOP OR TABLETOP INSTALLATION  
1
2
Notes  
2-9131  
2-9133  
2-9134  
2-9136  
2-9137  
• This equipment may not be used on coin service provided by the  
telephone company.  
1b  
• Party lines are subject to state tariffs, and therefore, you may not  
be able to use your own telephone equipment if you are on a party  
line. Check with your local telephone company.  
• Notice must be given to the telephone company upon permanent  
Mounting  
holes  
disconnection of your telephone from your line.  
Rights of the Telephone Company  
2
Should your equipment cause trouble on your line which may harm  
the telephone network, the telephone company shall, where  
practicable, notify you that temporary discontinuance of service may  
be required. Where prior notice is not practicable and the  
circumstances warrant such action, the telephone company may  
temporarily discontinue service immediately. In case of such  
temporary discontinuance, the telephone company must: (1) promptly  
notify you of such temporary discontinuance; (2) afford you the  
opportunity to correct the situation; and (3) inform you of your right to  
bring a complaint to the Commission pursuant to procedures set forth  
in Subpart E of Part 68, FCC Rules and Regulations.  
The telephone company may make changes in its communications  
facilities, equipment, operations of procedures where such action is  
required in the operation of its business and not inconsistent with  
FCC Rules and Regulations. If these changes are expected to affect  
the use or performance of your telephone equipment, the telephone  
company must give you adequate notice, in writing, to allow you to  
maintain uninterrupted service.  
3
4
ON  
RINGER  
OFF  
Screw-  
driver  
M
W
D
2
O
#
0
0
J K  
5
6
T
T
0
A
1
G
4
P
*
0
0
Screw  
Coiled  
handset  
cord  
2. Plug telephone line cord into  
the modular jack.  
3. Slip mounting holes on the  
bottom of the telephone over  
the wall plate posts and slide  
the base down until the  
phone is firmly in place. (Wall  
plate is not included.)  
4. Slide the RINGER switch (on  
the side of handset) to ON.  
Telephone  
line cord  
1. Remove telephone line cord from the pocket on the  
bottom of the phone.  
2. Run telephone line cord through the guides on the  
bottom of the phone.  
4
5
A
B
C
D
E
F
1
2
3
3. Connect the telephone line cord to a modular  
telephone jack.  
GHI  
J
K
L
MNO  
4
5
6
PRS  
TUV  
WXY  
7
8
9
T O N E  
TONE  
OPER  
0
#
*
P U L S E  
0000  
0000  
5. Set PULSE/TONE switch (on  
the side of the handset) to  
TONE for touch-tone service,  
or set it to PULSE for rotary  
service. If you don’t know  
4. Slide the RINGER switch (on the side of the handset)  
to ON.  
5. Set PULSE/TONE switch (on the side of the handset)  
to TONE for touch-tone service, or set it to PULSE for  
rotary service.If you don’t know which type of  
which type of service you have,  
check with the phone company.  
service you have, check with the phone company.  
We bring good things to life.  
FOLD  
FOLD  
INTERFERENCE INFORMATION  
USING THE TELEPHONE FEATURES  
LIMITED WARRANTY  
This device complies with Part 15 of the FCC Rules. Operation is subject  
to the following two conditions: (1) This device may not cause harmful  
interference; and (2) This device must accept any interference received,  
including interference that may cause undesired operation.  
What your warranty covers:  
AUTOMATIC REDIAL  
To automatically redial the last number you called:  
Any defect in materials or workmanship.  
For how long after your purchase:  
One year. (The warranty period for rental units begins with the first  
rental or 45 days from date of shipment to the rental firm, whichever  
comes first.)  
This equipment has been tested and found to comply with the limits for a  
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection against harmful  
interference in a residential installation.  
This equipment generates, uses, and can radiate radio frequency  
energy and, if not installed and used in accordance with the  
instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a  
particular installation.  
If this equipment does cause harmful interference to radio or television  
reception, which can be determined by turning the equipment off and  
on, the user is encouraged to try to correct the interference by one or  
more of the following measures:  
1. Pick up the handset to get a dial tone.  
2. Press REDIAL.  
ABC  
JKL  
DEF  
What we will do:  
1
4
7
2
5
8
0
3
6
9
#
Provide you with a new or, at our option, a refurbished unit.  
The exchange unit is under warranty for the remainder of the original  
product’s warranty period.  
GHI  
MNO  
WXYZ  
FLASH  
Press the FLASH button instead of the hook switch to activate custom calling services  
such as call waiting or call transfer. Custom calling services are provided by the phone  
company.  
PQRS  
TONE  
TUV  
OPER  
How to make a warranty claim:  
Properly pack your unit. Include any cables, etc., which were  
originally provided with the product. We recommend using the original  
carton and packing materials.  
*
FLASH  
REDIAL  
Include in the package evidence of purchase date such as the bill of  
sale. Also print your name and address and a description of the defect.  
Send standard UPS or its equivalent to:  
TEMPORARY TONE  
Reorient or relocate the receiving antenna (that is, the antenna for  
radio or television that is “receiving” the interference).  
Reorient or relocate and increase the separation between the  
telecommunications equipment and receiving antenna.  
Connect the telecommunications equipment into an outlet on a  
circuit different from that to which the receiving antenna is  
connected.  
If you have pulse service, you can temporarily change from pulse to tone service in order  
to access services that require tone dialing (such as getting information from a local bank).  
After dialing the telephone number, press and release the tone button, marked with an  
asterisk (*). When you hang up, your phone returns to pulse service.  
REDIAL  
button  
Thomson Consumer Electronics, Inc.  
Product Exchange Center  
32 Spur Drive  
FLASH  
button  
El Paso, Texas 79906  
Pay any charges billed to you by the Exchange Center for service not  
covered by the warranty.  
Consult the dealer or an experienced radio/TV technician for help.  
Insure your shipment in case of loss or damage. Thomson accepts no  
liability in case of damage or loss.  
A new or refurbished unit will be shipped to you prepaid freight.  
What your warranty does not cover:  
If these measures do not eliminate the interference, please consult your  
dealer or an experienced radio/television technician for additional  
suggestions. Also, the Federal Communications Commission has  
prepared a helpful booklet, “How To Identify and Resolve Radio/TV  
Interference Problems.” This booklet is available from the U.S.  
Government Printing Office, Washington, D.C. 20402. Please specify  
stock number 004-000-00345-4 when ordering copies.  
TROUBLESHOOTING TIPS  
Customer instruction. (Your Owner’s Manual provides information  
regarding operating instructions and user controls. For additional  
information, ask your dealer.)  
Problem  
Solution  
Installation and set-up service adjustments.  
Batteries.  
No dial tone.  
Won't dial out  
Check hook switch to make sure it pops up.  
Make sure PULSE/TONE is set to correct position.  
HEARING AID COMPATIBILITY  
Damage from misuse or neglect.  
This telephone system meets FCC standards for Hearing Aid  
Compatibility.  
Products which have been modified or incorporated into other  
products.  
Phone doesn’t ring  
Make sure RINGER switch is set to ON.  
You might have too many phones on one line.  
Products purchased or serviced outside the USA.  
FCC NUMBER IS LOCATED ON THE CABINET BOTTOM  
REN NUMBER IS LOCATED ON THE CABINET BOTTOM  
Acts of God, such as but not limited to lightning damage.  
Product Registration:  
Please complete and mail the Product Registration Card packed with  
your unit. It will make it easier to contact you should it ever be  
necessary. The return of the card is not required for warranty  
coverage.  
Feedback when  
dialing in PULSE mode.  
This is normal. Power fluctuates with phone outpulsing.  
How state law relates to this warranty:  
Can’t be heard by  
other party  
Make sure phone cord is securely plugged in.  
Make sure other phones aren't off the hook at the same time you're using the phone. It is  
normal for the volume to drop when additional phones are used at the same time.  
This warranty gives you specific legal rights, and you may have other  
rights which vary from state to state.  
If you purchased your product outside the USA:  
This warranty does not apply. Contact your dealer for warranty  
information.  
© 1998 Thomson Consumer Electronics, Inc.  
P.O. BOX 1976, Indianapolis, IN 46206  
Trademark(s) ® Registered  
2-9120/21/22/23/24/26/27  
2-9130/31/33/34/36/37  
20909690 (Rev. 2 E/S)  
98-08  
Marca(s) ® Registrada(s)  
Printed in Philippines  
2-9120/2-9130 Color Series (Folded size 80 x 158 mm)  
20909690 (Rev. 1 E/S)  
Sht 1 of 2 (4 Folds)  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Earthquake Sound Car Amplifier T1000W 2 User Manual
Edimax Technology Network Card EW 7126 User Manual
Ericsson Two Way Radio MTL SX User Manual
Euro Pro Oven XSP21H User Manual
Extron electronic Switch FOXBOX 4G DVI User Manual
Fellowes Chipper SB 80 User Manual
Fortinet Network Hardware 5103b User Manual
Fostex Car Speaker FT7RP User Manual
Fujitsu Computer Accessories F2 MC 16 User Manual
FUNAI CRT Television CR202EM9 User Manual