zbd6880NSS/zbd6800NWW/bb
GE Monogram® Fully Integrated built-In dishwasher
Dimensions and Specifications (in inches)
• The dishwasher must be installed so that the drain hose
is no more than 10 feet in length for proper drainage.
• Water and power supply should enter in the
shaded area.
• Electrical and water connections are at the right front
of the dishwasher. The hot water line should extend
forward 30" to 40" from the rear wall. The electrical must
extend forward at least 24" to reach the junction box.
• To prevent siphoning, an air gap must be used when
the waste tee or disposer connection is less than 18"
above the floor.
Electrical Requirements
This Wall Area
must be Free of
Pipes or wires
The dishwasher must be supplied with 120V, 60Hz, and
connected to an individual properly grounded branch
circuit protected by a 15- or 20-amp circuit breaker or
time-delay fuse.
Cabinets
Square
and
24"
Min.
34-1/2" Min.
Underside of
Countertop
to Floor
5"
5"
4"
4"
Plumb
6"
24" Min.
34"
Adjustable
to 35"
Floor MUST
be Even with
Room Floor
*24"
24"
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
As an EnErgy StAr®
Listed by
Underwriters
Laboratories
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
Specification Revised 2/08
150044
Download from Www.Somanuals.com. All Manuals Search And Download.
|