reference). Remove the old chime.
2. Install new chime
a. Remove the front cover from the chime.
b. Pull the pushbutton and transformer wires through the slot in the base of chime.
c. Mark the 4 holes using the base as a template with the arrow pointing up.
d. If using the screw anchors, drill 4 - 5/32”holes and insert the plastic screw anchors.
Otherwise drill a 3/64” pilot hole for the screws.
Chime Tune Setting
The following instructions explain how to
change the tune on the wired chime.
1. Remove the chime cover and locate the
two 3 position dip switches shown below.
Wired Chime
Installation Instructions for
Wired Chime
Front Door Dip Switch
e. Mount the chime base using the 4x25mm screws.
f. Attach the two wires from each pushbutton as shown in the wiring diagram. For each push
button, one wire should be connected to the “Common” screw and one wire should be
connected to the “Front” or “Rear” screw.
g. Attach the wires from the chime transformer to the “transformer connections” as shown in
the wiring diagram. (There is no polarity requirement).
h. Slide the front cover on the back plate of the chime.
Power Requirement: 16VAC @ 180mA
maximum
Rear
Door
Button
Front
Door
Button
Wiring Diagram
Rear Door Dip Switch
Chime
2. Select the desired chime sound from
the table below.
Included hardware:
(1) Chime
(4) Plastic screw anchors
(4) 4x25mm screws (for anchors)
Chime Sound Table
Position
1
2
3
Required Tools:
Westminster
Ding Dong
Knock
Bronze Chime
Cuckoo Clock
Foghorn
OFF
OFF
ON
OFF
ON
ON
ON
OFF
ON
OFF
ON
OFF
ON
ON
ON
OFF
OFF
ON
ON
OFF
ON
Wire stripper/cutter, small flat blade
screwdriver, Phillips screwdriver, drill,
and drill bit (5/32”)
Removing Front Cover
The following instructions explain how to
remove the front cover of the wired
chime.
Gong
For technical support contact Jasco
Products Company at 1-800-654-8483
Made in China
ON: Switch On (up)
OFF: Switch Off (down)
1. With the cover face down hold the
front cover while sliding the back plate
to the left.
2. Using your finger gently pry up on the
back cover plate. The back plate with
the paper product label should come
away easily.
Hecho en China
WARNING: Do not exceed 16VAC
input to the chime.
is a trademark of General Electric Company and is used under license to
Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114.
Installation
1. Remove the cover from the old door
chime, disconnect the transformer and
Rev. 08-13-08
Download from Www.Somanuals.com. All Manuals Search And Download.
19214-2
pushbutton wires (label them fo
r
|