G5912
Product features and decorations may vary from picture above.
WARNING
IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Please read these instructions before assembly and use of this product.
Adult assembly is required.
Tool needed for battery installation: Phillips Screwdriver (not included).
Requires four LR14 alkaline batteries for operation (not included).
Weight Limit: 9 kg (20 lbs).
e
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts
Pad
Seat Back Tube
Frame
Lower Swing Arm Assembly
(with Restraint System)
3 Link Toys
Front Tube
2 Frame Tubes
#6 x 1.9 cm Screws - 4
Shown Actual Size
NOTE: Tighten and loosen all
screws with a Phillips screwdriver.
Do not over-tighten the screws.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
IMPORTANT! Before assembly, inspect this product for
damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and instructions
if needed. Never substitute parts.
Press Button
on Front Tube
Press Button on
Lower Frame Tube
Upper Frame Tube
Rubber Feet Down
1
2
• Rotate the upper frame tube until it "snaps" into an upright
position, as shown.
• Position the front tube so that the rubber feet are flat on
the surface.
• While pressing the button on the lower frame tube, insert it
into an end of the front tube. Continue to insert the lower
frame tube into the front tube until you hear a "click".
• While pressing the button on the front tube, insert it into
the end of the lower frame tube. Continue to insert the
front tube into the lower frame tube until you hear
a "click".
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Frame
Lower Frame Tubes
Press Button
on Upper
Frame Tube
Pull Front Tube
3
• Pull the front tube to be sure it is secure to each lower
frame tube.
4
• While pressing the buttons on the upper frame tubes,
insert them into the holes in the underside of the frame.
• Continue to insert the upper frame tubes into the frame
until you hear a "click" on both sides.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Upper Swing Arms
Upper Frame
Tube
Frame
Upper Frame
Tube
Lower Swing Arm Assembly
(with Restraint System)
5
6
• Fit the lower swing arm assembly to the outer side of the
upper swing arms.
• Check to be sure the upper frame tubes are secure in the
frame. If you can remove the upper frame tubes from the
frame, you have not properly inserted the tubes into the
frame. Remove the upper frame tubes from the frame and
repeat Assembly step 4.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Seat Back Tube
Buttons
#6 x 1.9 cm Screws - 4
7
Shown Actual Size
• Insert two #6 x 1.9 cm screws through the upper swing arm
and into the lower swing arm. Tighten the screws.
Swing Arm Short Tubes
8
• Position the seat back tube so that it curves toward the back
of the swing.
• While pressing the buttons on the seat back tube, fit the
seat back tube into the short tubes on the swing arms.
• Push the seat back tube until it “clicks” into place.
• Pull up on the seat back tube to be sure it is secure to the
swing arms.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Pad Top Pocket
Slot
Slot
Pad Lower Pocket
Fastener
ꢀ
ꢁ
Waist Belts
Seat Bottom Tube
Seat Back Tube
9
• Fit the top pocket on the pad over the seat back tube ꢀ.
• Lift the seat bottom tube and fit the lower pocket on the
pad over the seat bottom tube ꢁ.
10
• From behind the seat, insert the waist belts into the slots in
the pad.
• Push to fasten the restraint system to the pad.
Assembly is now complete.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
Hint: We recommend using alkaline
batteries for longer battery life.
1.5V x 4
LR14
SHOWN ACTUAL SIZE
Battery Holder
2
Battery Compartment Door
• Open the battery holder.
• Insert four LR14 alkaline batteries as indicated inside the
battery holder.
• Close the battery holder.
Battery Holder
1
• Locate the battery compartment door on the frame.
• Loosen the screws in the battery compartment door.
Battery Compartment Door
• Remove the battery compartment door and the battery
holder from the battery compartment.
Battery Holder
3
• Align the ridge on the battery holder with the groove in the
battery compartment.
• Slide the battery holder back into the battery compartment.
• Replace the battery compartment door and tighten
the screws.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Safety Information
Set-Up & Use
Batteries may leak fluids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
WARNING
To prevent serious injury or death
from falls and being strangled in
the restraint system:
- Always use the restraint system.
- Not recommended for children
who can sit up by themselves
(6 months approximately, until
9 kg, 20 lbs).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of batteries in a fire. The
batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• Never leave child unattended.
• If removeable, rechargeable batteries are used, they are
only to be charged under adult supervision.
• It is dangerous to use this product
on an elevated surface.
IMPORTANT! Before each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and
instructions if needed. Never substitute parts.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
Securing Your Child
Anchored End
Waist Belt
Restraint
Free End
Tighten
Anchored End
Free End
Loosen
2
To tighten the restraint straps:
• Feed the anchored end of the restraint strap up through
the buckle to form a loop ꢀ. Pull the free end of the restraint
strap ꢁ.
Waist Belt
To loosen the restraint straps:
Crotch Belt
• Feed the free end of the restraint strap up through the buckle
to form a loop ꢀ. Enlarge the loop by pulling on the end of
the loop toward the buckle. Pull the anchored end of the
restraint strap to shorten the free end of the restraint strap ꢁ.
1
• Place your child in the seat. Position the crotch belt between
your child’s legs.
• Fasten the waist belts to the crotch belt. Make sure you
hear a “click” on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
Power Dial
Starting the Swing
Power Dial
• Turn the power dial to any of eight settings.
• Give the seat a light push to start the swinging motion. Adjust the swing power dial to the desired swing motion setting.
Hint: As with most battery-powered swings, a heavier child will reduce the amount of swinging motion on all settings. In most cases,
the low setting works best for a smaller child while the high setting works best for a larger child.
• If swinging stops while using a lower setting, try a higher setting. Give the seat a light push to start the swinging motion again.
• Be sure to turn this product off when not in use. Turn the power dial to the off setting
.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
Hint: Your baby can enjoy lights and music with or without swinging.
Baby Activated
Parent Activated
Lights and
Music Switch
Lights and
Music Switch
Volume Dial
• Slide the lights and music switch to:
When baby pulls either toy on the arch, one tune plays along with twinkling lights.
On this setting, six tunes (approximately 10 minutes) play along with dancing lights.
On this setting, music plays for about 10 minutes.
Turns lights and music off.
• Turn the volume dial to a comfortable listening level.
IMPORTANT! Low battery power may cause this product to operate erratically (no sounds/movement) and the product
may not turn off. Remove and throw away all four batteries and replace with four, new LR14 alkaline batteries.
13
Download from Www.Somanuals.com. All Manuals Search And Download.
Set-Up & Use
Room-to-Room Portability
WARNING
• To prevent serious injury or death
from falls and being strangled in the
restraint system, always use the
restraint system.
• It is dangerous to use this product
on an elevated surface.
3 Link Toys
• Fit the link toys to either of the hanging toys on
the swing.
• Make sure your child is properly secured in the swing seat.
• With baby facing forward and outward, lift the swing using
the handle.
• Carefully carry the swing to another room. Be sure to set the
swing down on a non-elevated, flat surface.
14
Download from Www.Somanuals.com. All Manuals Search And Download.
Take Along
Lift Seat Back
Lift Seat Bottom
Seat Back
Press Tabs
2
1
• Tip the swing backwards with the seat back down.
• Press both tabs on the frame at the same time to release the
frame base.
• Lift the seat back and seat bottom together.
15
Download from Www.Somanuals.com. All Manuals Search And Download.
Take Along
Care
• The frame, pad, liner and toys may be wiped clean using a
mild cleaning solution and a damp cloth. Do not immerse
the frame.
Lower Frame Tube
• This product has no consumer serviceable parts. Do not
take this product apart.
IMPORTANT! Never use this product without the
provided pad.
3
• Rotate the lower frame tube around to the top of frame,
as shown.
To set the swing back up for use:
• Rotate the lower frame tube around until it snaps
into place.
• Place the swing on a non-elevated, flat surface.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
© 2004 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA
G5912pr-0726
Download from Www.Somanuals.com. All Manuals Search And Download.
|