Assembled Parts
IMPORTANT! Please remove all parts from the package and identify them before assembly.
Tray
Rear Base
Front Base
Hint: Do not remove the plastic inserts
inside the tubes of the front base.
Seat with Restraint
Seat Support
Footrest
Seat Back with Restraint
Seat Back Pad
2 Frames
Seat Pad
Hint: Do not remove the plastic
insert inside the tube in each frame.
FASTENERS SHOWN ACTUAL SIZE
#8 x ¾" Screw with Plastic Retainer – 4
#8 x ¾" Screw – 4
Note: Tighten and loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
CAUTION
This package contains small parts
in its unassembled state.
Adult assembly is required.
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or
sharp edges. DO NOT use if any parts are missing or broken.
Contact Fisher-Price® for replacement parts and instructions
if needed. Never substitute parts.
2
• Fit a #8 x ¾" screw with retainer into the rear base and tighten.
• Repeat steps 1 and 2 to assemble the other frame to the rear base.
Tapered Frame Tube
Seat Support
Frame Tubes
Rear Base
Frame Latches
1
• With the Fisher-Price® logo facing out, fit the tapered frame tube
into the rear base.
Frame Assembly
3
• Lay the frame assembly down with long frame tubes up.
• Position the seat support with the frame latches down.
• Slide the seat support onto the frame tubes.
Hint: Push the seat support all the way to the top of the assembly.
You will hear several "clicks".
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Seat Support
Footrest
Front Base
4
• Fit the front base into the frame tubes.
6
• Lift the frame assembly upright.
• Fit the footrest onto the seat support, as shown.
5
• Insert two #8 x ¾" screws with retainers into the holes in each
frame tube and tighten.
Hint: If you cannot insert the screws into the frame tubes, you have
assembled the front base backwards. Remove it, turn it around and
re-assemble it to the frame tubes.
Footrest
7
• Insert two #8 x ¾" screws into the holes on each side of the
footrest and tighten.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Pegs
Tab
Tab
Slot
Seat Pad
Slot
Elastic Straps
8
• At an angle, fit the tabs on the seat back into the slots in the seat.
• Push the seat back to “snap” in place.
• Pull on the seat back to be sure it is secure to the seat bottom.
10
• Pull the waist restraint ends through the slots in the seat pad.
• Fit the elastic loops on the seat pad down through the slots in
the seat.
• Turn the seat upside down.
• Pull the elastic straps through the slots in the seat and fit the
elastic straps to the pegs.
9
• Unbuckle the lower restraint.
11
• Pull the shoulder restraint ends through the slots in the seat pad.
• Fit the straps on the back of the seat back pad into the slots in the
seat back.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Lower Shoulder
Belt Slots
Straps
12
14
• Press to fasten the straps to secure the seat back pad.
Smaller Baby
• Insert the ends of the shoulder belts through the lower slots in the
pad and seat back.
Upper Shoulder
Belt Slots
13
15
• To adjust the restraint height for baby, push to remove the
shoulder restraints from the seat back.
Larger Baby
• Insert the ends of the shoulder belts through the upper slots
in the pad and seat back.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Securing Your Child
WARNING
Prevent serious injury or death from
falls or sliding out:
• Only use for a child capable of sitting
upright unassisted.
• NEVER leave child unattended.
High Chair Use:
• ALWAYS secure child with restraint
belts adjusted to fit your child snugly.
The tray is not designed to hold child
in the product.
When attached to adult chair:
• Use restraint belts until child is able to
get in and out of the product without
help (about 21/2 years old).
Slots
16
• Fit the "T" end of each shoulder belt through the slots in the
lower restraint.
Seat Assembly
Frame Assembly
17
• Place the seat assembly on the frame assembly and push to lock
in place. You should hear a "click".
Note: The seat assembly will only fit on the frame assembly if the
chair attachment strap door is closed. If the seat assembly does not
lock onto the frame assembly, check to make sure the sliding door
under the seat is completely closed.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Securing Your Child
Adjuster
Adjuster
Waist/Shoulder
Belt
Waist/Shoulder
Belt
Crotch Belt
TIGHTEN
3
• To tighten the waist straps: Feed the anchored end of the waist
1
A
strap up through the buckle to form a loop
. Pull the free end
B
of the waist strap
.
• Place your child in the seat. Position the crotch belt between your
child’s legs.
• To tighten the shoulder straps: Hold the adjuster and pull the
C
shoulder strap down
.
• Fasten both waist/shoulder belts to each side of the crotch belt.
Make sure you hear a "click" on both sides.
• Check to be sure the restraint system is securely attached by
pulling it away from your child. The restraint system should
remain attached.
LOOSEN
4
• To loosen the waist straps: Feed the free end of the waist strap
A
up through the buckle to form a loop
. Enlarge the loop by
pulling on the end of the loop toward the buckle.
• Pull the anchored end of the waist strap to shorten the free end
B
of the waist strap
.
2
C
• To loosen the shoulder straps: Lift the adjuster
.
Note: After adjusting the restraint system to fit your child, make sure
• Tighten each waist belt/shoulder belt so that the restraint system
is snug against your child. Please refer to the next section for
instructions to tighten the waist belts/shoulder belts.
you pull on it to be sure it is securely fastened.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Using the Tray
WARNING
Release Bar
Prevent serious injury or death from
falls or sliding out: ALWAYS secure
child with restraint belts adjusted to
fit your child snugly. The tray is not
designed to hold child in the product.
Tray
2
Armrest
• While pushing the release bar on the front of the tray, adjust the
tray forward or backward.
1
• Fit the tray onto the seat armrests. Push down until the tray
"snaps" into place.
Hint: Before use, thoroughly wash all parts (the tray) that may
contact food. The tray is not dishwasher or microwave safe.
Release Bar
3
• While pushing the release bar on the front of the tray, pull the
tray away from the armrests.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Adjusting the Seat
Attaching To An Adult Chair
WARNING
Prevent serious injury or death from
falls or sliding out:
• Only use for a child capable of sitting
upright unassisted.
PRESS
• NEVER leave child unattended.
• Use restraint belts until child is able to
get in and out of the product without
help (about 21/2 years old).
Seat Height Adjuster
• NEVER use in motor vehicles.
• ALWAYS secure the product on a
chair using bottom and back attach-
ment straps. NEVER use on a stool
or bench that does not have a
seat back.
To adjust the seat height:
• Press the levers on both seat height adjusters and lift or lower the
seat to any of five different heights.
• Make sure both sides of the seat are adjusted to the
same height.
• Push the seat to be sure the seat is locked in place.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Attaching To An Adult Chair
A
B
Chair
Attachment
Straps
Door
3
Latch
• Turn the seat over.
• Slide the door open and pull out the chair attachment straps.
1
Openings
A
B
• While sliding the switch
pull the latch towards you
.
Openings
4
• Match the buckle on each strap to the matching buckle icon near
each slot in the seat. Feed each strap through the matching slot
on the seat.
2
• Lift the seat off the base.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Attaching To An Adult Chair
Remove the Seat Back and
Shoulder Straps
5
• Turn the seat over and place the seat on a chair.
1
A
• Wrap the bottom straps around the bottom of the chair
.
B
Buckle the straps
. Make sure you hear a "click". Pull the free
• Pull the shoulder belts out of the waist restraint buckle slots.
C
end of each strap to tighten on the chair
.
Seat Back
Tab
Seat Bottom
2
6
• Pull the tab on the seat back. Lift to remove the seat back from
the seat.
• Store the seat back, seat back pad and shoulder belts in a safe
place for future use.
D
• Wrap the back straps around the back of the chair
.
E
Buckle the straps
. Make sure you hear a "click". Pull the
F
free end of each strap to tighten on the chair
.
• Pull up on the seat to be sure it is secure to the chair.
13
Download from Www.Somanuals.com. All Manuals Search And Download.
Attaching the Seat To the Frame
Chair
Attachment
Straps
Door
1
• Turn the seat over and open the door. Carefully fit the chair
attachment straps into the compartment.
3
• Fit the seat onto the high chair frame. Push to "snap" into place.
Pull up on the seat to be sure it is secure to the high chair frame.
2
IMPORTANT! Close the door completely. If you do not close the door,
the seat will not fit on the high chair base.
14
Download from Www.Somanuals.com. All Manuals Search And Download.
Storage
Care
• The bib, toy, tray, pad, seat, seat back and restraint straps may be
wiped clean using a mild cleaning solution and damp cloth.
Do not use bleach. Do not use harsh or abrasive cleansers.
Rinse clean with water to remove residue.
To remove the pad:
• Push to remove the shoulder belts, waist belts and crotch belt
from the seat and pads.
• Unfasten the straps on the seat back.
• Remove the pads from the seat.
• To replace the pad and restraint straps, refer to the assembly
instructions in this manual.
IMPORTANT! Be sure to replace the restraint system. Never use
this product without the restraint system when used as a high chair
or when attached to an adult chair (until your child cannot get in
and out of the product without help).
• Pull the frame release latches forward and push the rear legs
toward the front legs.
15
Download from Www.Somanuals.com. All Manuals Search And Download.
CANADA
Mattel Canada Inc., 6155 Freemont Blvd.,Mississauga, Ontario L5R 3W2.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.
©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN MEXICO
P9043pr-0920
Download from Www.Somanuals.com. All Manuals Search And Download.
|