Help Line
Fellowes
Australia
Canada
+ 1-800-33-11-77
+ 1-800-665-4339
+ 1-800-234-1185
+ 1-800-955-0959
México
United States
Australia
Benelux
+ 61-3-8336-9700
+ 31-(0)-76-523-2090
+ 1-905-475-6320
Canada
Deutschland
France
+ 49-(0)-5131-49770
+ 33-(0)-1-30-06-86-80
+ 39-(0)-71-730041
+ 81-(0)-3-5496-2401
+ 82-(0)-2-3462-2884
+ 60-(0)-35122-1231
+48-(22)-771-47-40
+34 91 748 05 01
Italia
Japan
Korea
Malaysia
Polska
Spain
Singapore
United Kingdom
United States
+ 65-6221-3811
+ 44-(0)-1302-836836
+ 1-630-893-1600
C14
Please read these instructions before use.
Download from Www.Somanuals.com. All Manuals Search And Download.
© 2005 Fellowes, Inc. Printed in China. Form No. 400409B
Set-Up
Product Profile
•Pull waste basket drawer (A) completely out of cabinet.
•Put waste bag in basket (sample bags provided). Allow edges to overhang. Contact
Fellowes to order more bags. (Part #36053).
This product is built to shred paper, staples, small paper clips,
credit cards, CDs, and DVDs (CDs and DVDs in designated slot).
It is not built to shred transparencies, adhesive labels, newspaper,
cardboard, large paper clips, or plastic (other than items noted
above). Attempting to shred items not intended for this shredder
may cause damage.
•Slide waste basket drawer (A) into cabinet. The shredder will not operate if drawer is not
pushed all the way into cabinet.
•Casters have been added for your convenience.
•Plug power cord into a convenient outlet.
Confetti-cut
(C14)
15 sheets
Operation
Control Switches
Sheet capacity*
CD capacity
1
Paper shred size
5/32" x 1 1/2" (3.9 x 38 mm)
9" (230 mm)
100-200 shredding passes
25 minutes
Control Switch (E)
F
Maximum paper width
Recommended daily capacity
Maximum running time
Automatic cool-down period
Voltage
I
AUTOMATIC
Turns on the auto-
matic-start sensor
and the green
Ready light.
O OFF
Turns off the auto-
matic-start sensor
and the green
Ready light.
R REVERSE
Runs shredder in
reverse mode.
Press and hold to
activate.
E
40 minutes
120V-60Hz 6.0A
*Based on 20 lb., 8-1/2" x 11" paper with shredder operating at rated voltage; heavier paper, high humidity, or other than
rated voltage may reduce sheet capacity.
H
IMPORTANT SAFETY INSTRUCTIONS
I
J
Troubleshooting Lights
READ ALL INSTRUCTIONS BEFORE USING
Ready Light (F)
(Green)
Shredder is in
automatic start
mode.
Basket Ajar (H)
Waste basket
Paper Jam (I)
Overheat Light
(J)
Shredder has
overheated (e.g.
shredder has been
used for more
than 25 minutes).
While setting up shredder
•Check shredder for damage or defects; some paper particles in the basket are normal
due to product testing and does not indicate a defect.
•If the cord is damaged do not replace cord or use the machine. Return machine for a
replacement.
•Avoid touching exposed blades on underside of confetti-cut shredder head.
•Plug power cord in an outlet that can easily be reached. The plug is the primary electrical
disconnect.
Shredder is
drawer is open.
jammed (e.g.,
too much paper
fed at one time).
Basket Full (H)
Waste basket is
full or paper has
collected under
cutting cylinders.
For convenience and energy savings, your shredder is equipped with an automatic-start
sensor (K). This means that when the control switch (E) is in the automatic [I] position, the
shredder will start running when paper is fed into it. The shredder stops a few seconds
after the paper has passed through.
•Make sure the electrical rating listed on the serial label (located inside, just below top of
shredder) matches the available electric power.
•Do not place shredder near or over a heat or water source.
While operating shredder
CAUTION: The automatic-start sensor cannot tell the difference
between paper and other objects. This feature can also be a hazard.
Always turn off the shredder when it is not in use. Unplug the shredder
if it will not be used for an extended period.
•Keep hands and hanging objects (jewelry, ties, loose clothing,
long hair, etc.) away from paper entry.
•Keep children and pets away from the shredder.
When not in use
•Always turn off and unplug shredder.
•Unplug before emptying basket.
To shred
• Press control switch (E) to automatic [I] position. Green ready light (F) should turn on.
•Do not open shredder head: Danger of electric shock.
Opening shredder head will void the warranty.
PAPER
• Feed paper straight into entry (C), releasing when shredder begins shredding; see Product
Profile for limits on paper width, shreddable items, sheet capacity, etc.
• Shred no more than 25 minutes; shredding longer will cause shredder to turn itself off for
40 minutes to cool down.
NOTE: Do not use flammable synthetic oil, petroleum-based products
or aerosols of any kind on or near product at any time.
• Press control switch to off [O] position after cutting has stopped.
3
4
Download from Www.Somanuals.com. All Manuals Search And Download.
CDs, or DVDs
Troubleshooting
•Slide safety cover (L) to the right to expose the CD entry (M).
•Hold CD, or DVD at the edge and feed one at a time, straight into entry (M) releasing
when shredding begins. Shredder will stop when item has passed through entry. CDs and
DVDs will be shredded into small particles.
If there is a problem with your shredder, check these symptoms and remedies. If you cannot
solve the problem, contact Fellowes customer service. Do not open shredder head to
attempt repair. You could be exposed to serious electric shock and will void the warranty.
•Slide cover (L) to the left when done shredding media.
CAUTION: Do not hold CD or DVD with finger through the center ring while feeding into
shredder.
tSymptom
Ready Light (F) will not light
Remedy
To empty waste basket
If basket full light (I) is on, follow these steps until light turns off.
Make sure shredder is plugged in and
the control switch (E) is in the automatic [I]
position.
1
2
•Press control switch (E) to the off [O] position.
•Open the waste basket drawer (A) and remove full bag.
•Place new bag in basket, then slide drawer into cabinet (Fellowes plastic bag 36053).
Shredder does not start or stops
while shredding
• Make sure shredder is plugged in and
control switch (E) is in the automatic [I]
position.
•Press and hold control switch (E) in the reverse [R] position for a few seconds to clear
paper shreds that have collected under cutting cylinders.
•Alternate between automatic [I] and reverse [R] for a few seconds in each position.
CAUTION: The shredder may be damaged if you alternate too rapidly between automatic
and reverse.
• Shredder is jammed. Follow the
instructions under Operation.
Basket ajar/basket full
light (H) is on
Make sure the waste basket (A) is all the way
into the cabinet. Empty the waste basket.
Follow the instructions under Operation.
3
•Unplug shredder and remove wastebasket drawer (A).
– Carefully clear any paper shreds that have collected on under side of paper entry (C).
CAUTION: Confetti-cut shredders have exposed blades.Use care when removing paper
shreds on underside of paper entry.
Paper jam light (I) is on
Clear the paper jam. Follow the
instructions under Operation.
To clear a paper jam
If paper jam light (I) is on, follow these steps until light turns off.
Overheat light (J) turns on and
shredder will not operate.
Wait 40 minutes for shredder to cool down
before trying again.
•Check the waste basket and empty if full.
Shredder sheet capacity decreases,
noise level increases, or cutting cylinders
stop with a squeak or rubbing sound
Oil the cutting cylinders. Follow the
instructions under Maintenance.
•Press and hold control switch (E) in the reverse [R] position to back paper out of paper
entry (C). Try pulling gently on paper to remove it from shredder.
•Alternate between automatic and reverse, if needed:
– Move control switch to automatic [I] and run for 1-2 seconds.
– Press and hold control switch (E) in the reverse [R] position for a few seconds.
– Continue alternating between automatic and reverse until the jam clears.
CAUTION: The shredder may be damaged if you alternate too rapidly between
automatic and reverse.
Shredder runs for a few seconds after the
paper has cleared the cutters
No action required. This is a self-cleaning
function.
Supplies
Item
Maintenance
The following items for the C14 shredders are available from Fellowes:
Empty waste basket regularly to ensure the smooth functioning of the cutting cylinders.
The shredder will not operate when the basket is full.
Quantity
Part Number
Oil regularly to ensure proper operation.
Waste bags (in dispenser)
Powershred Lubricant
100/roll
36053
35250
If used at or near daily capacity, apply oil every time you empty the basket.
Use Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-based oil in
a long-nozzle container (sample oil provided).
12 oz. bottle
To purchase supplies, contact Fellowes at the appropriate location listed on the back page
of this instruction manual, or visit us at www.fellowes.com
.
CAUTION: Do not use flammable synthetic oil, petroleum-based products, or
aerosol lubricants of any kind.
To oil the cutting cylinders
•Apply oil over full width of cutting cylinders through the paper entry (C).
•Move control switch (E) to automatic [I] and run for 1-2 seconds.
•Press and hold the control switch (E) in reverse [R] for at least 3 seconds.
•Repeat the automatic/reverse sequence 3 or more times.
5
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Limited Warranty
Fellowes, Inc. (“Fellowes”) warrants the cutting cylinders of the machine to be free from
defects in material and workmanship for 7 years from the date of purchase by the
original consumer. Fellowes warrants all other parts of the machine to be free of defects in
material and workmanship for 1 year from the date of purchase by the original consumer.
If any part is found to be defective during the warrant period, your sole and exclusive
remedy will be repair or replacement, at Fellowes’ option and expense, of the defective
part.
This warranty does not apply in cases of abuse, mishandling or unauthorised repair. ANY
IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WAR-
RANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any conse-
quential or incidental damages attributable to this product. This warranty gives you specific
legal rights. You may have other legal rights that vary. The duration, terms and conditions
of this warranty are valid worldwide, except where different limitations, restrictions or con-
ditions may be required by local law.
For more details or to obtain service under this warranty, please contact us (see back
cover) or your dealer.
Warrantor: Fellowes, Inc.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|