®
POWERSHRED
M-8C
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
Download from Www.Somanuals.com. All Manuals Search And Download.
BASIC SHREDDING OPERATION
PAPER/CARD
4
1
2
3
Continuous operation:
Up to 5 minutes maximum
Plug in and put
Set to Auto-On (
)
Feed paper/card
straight into paper
entry and release
When finished shredding
NOTE: Shredder runs briefly
disconnect power
set to OFF (
)
after each pass to clear entry.
switch in ON (I) position
Continuous operation beyond
5 minutes will trigger a
30-minute cool down period.
Safety Lock prevents accidental operation.
To set, wait for shredding to stop, push black button down and slide towards front of shredder.
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
PRODUCT MAINTENANCE
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
1
2
3
Set to Reverse (
for 2-3 seconds
)
Set to Off (
)
*Apply oil
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1
2
3
4
5
6
Set to Reverse
Alternate slowly back and forth
Set to Auto-On (
)
Set to Off (
and unplug
)
Gently pull uncut
paper from paper
entry. Plug in.
and resume shredding
(
)
for 2-3
seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
defects in material and workmanship and provides service and support for 2 years from the date of sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
from defects in material and workmanship for 3 years from the date of purchase by the original WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
consumer. If any part is found to be defective during the warranty period, your sole and exclusive or incidental damages attributable to this product. This warranty gives you specific legal rights.
remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This The duration, terms, and conditions of this warranty are valid worldwide, except where different
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage limitations, restrictions, or conditions may be required by local law. For more details or to obtain
standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer.
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The
benefits under Fellowes’ Warranty are in addition to other rights and remedies under a law in relation to the shredder.
Download from Www.Somanuals.com. All Manuals Search And Download.
®
POWERSHRED
M-8C
Declaration of Conformity
Fellowes Manufacturing Company
Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the product Model M-8C conforms with the requirements of the Restriction of Hazardous Substances
Directive (2011/65/EU), the Low Voltage Directive (2006/95/EC), the Electromagnetic Compatibility Directive (2004/108/EC), the WEEE directive (2002/96/EC), and below harmonized European
EN Standards:
Safety: EN 60950-1
EMC Standard: EN55014-1
Year Affixed: 12
EN55014-2
EN61000-3-2
EN61000-3-3
Itasca, Illinois, USA
January 1, 2013
James Fellowes
W.E.E.E.
This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical
and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive.
For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE
Questions or Concerns?
Customer Service & Support
Troubleshooting
Troubleshooting
Registration
Replacement parts
General questions
Manuals
Australia
Europe
+61-1-800-33-11-77
00800-1810-1810
+44-(0)-1302-836800
+1-800-955-0959
United Kingdom
United States
©2013 Fellowes, Inc. Part No. 407095 Rev D
Download from Www.Somanuals.com. All Manuals Search And Download.
|