Extron electronic Network Hardware FOX AEX 104 User Manual

PowerCageFOX AEX 104 • Setup Guide  
This guide provides instructions for an experienced installer to set up and operate the  
Extron PowerCage FOX AEX 104 fiber audio extractor. The PowerCage FOX AEX 104 is  
a double slot board for the PowerCage 1600 enclosure that provides up to 4 extraction  
points.  
NOTE: The PowerCage FOX AEX 104 is compatible with all Extron FOX  
products except for FOX 3G HD-SDI transmitter and receiver products.  
Installation  
Step 1 Input Data Rate Selection  
The DIP switch on the main board switches the PowerCage FOX AEX 104  
O
N
1
2
between 2G and 4G input data rates. Using an Extron Tweeker or small  
screwdriver, move DIP switch 2 up (on position) for 2G input data rates or down  
(off position) for 4G input data rates. DIP switch 1 is a spare. The default rate is  
4G (off or down).  
NOTE: 4G and 2G data rates apply to all inputs. These selectable rates are  
not for individual inputs.  
CAUTION: Ensure all fiber extenders are compatible with the desired data  
rate.  
Step 2 Board Installation  
NOTE: The PowerCage FOX AEX 104 is hot-swappable; they can be installed  
or removed without turning off or disconnecting the power to the  
PowerCage enclosure.  
CAUTION: Use ESD precautions when installing a board to avoid  
damaging it. Keep the board in the anti-static bag until it is needed.  
Use proper grounding techniques during installation.  
a. If applicable, remove as many blank plates or  
previously installed boards from the rear of the  
PowerCage enclosure as necessary to fit the  
16 available single board slots or  
8 double board slots  
PowerCage FOX AEX 104.  
b. With the connectors facing away from the  
PowerCage enclosure, align the PowerCage FOX  
AEX 104 vertically with the top and bottom slide  
posts in the selected enclosure slot.  
Power  
Supply  
Screws  
c. Carefully slide the board into the slot and push it  
z
100-240VMAX5.0/60H  
5
A
firmly into place.  
d. Tighten the screws to secure the board to the  
enclosure.  
NOTE: Use a tool to fully tighten the screws after initial installation and  
subsequent removal and replacement of the boards.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Eagle Electronics Fish Finder 642c iGPS User Manual
EdgeStar Fan EAC420 User Manual
Extron electronic Switch 60 728 01 User Manual
Fisher Price Motorized Toy Car R8526 User Manual
Flymo Trimmer 450 User Manual
FujiFilm Printer 40002 User Manual
Gigabyte Computer Hardware GA 8I915GM User Manual
Gigabyte Laptop M1405 User Manual
Gigabyte Network Card GA 8S661GXMP User Manual
Goodman Mfg Air Conditioner Split System Air Conditioner User Manual