M9523
Please keep this instruction sheet for future
reference, as it contains important information.
Requires three LR44 button cell alkaline
batteries (included) for bear toy operation.
Adult assembly is required.
Tool needed for assembly: Phillips
screwdriver (not included).
Doll sold separately.
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Back Brace
Frame
3
2
•Fit the back brace onto the same frame.
•Fit the other frame onto the braces.
Hint: The back brace will only fit on the frame one way. If it does
not seem to fit, turn it around and try again!
•Insert three M3,5 x 15mm screws into the holes in the frame
and tighten.
•
Insert an M3,5 x 15mm screw into the hole in the frame and tighten.
Seat
Frame
Assembly
SIdE VIEW
BOttOM VIEW
7
8
•Fit the seat onto the frame assembly. Push down on the seat to
fit in place.
•While holding the seat in place, turn the assembly face down.
•Insert two M4,5 x 18mm washer head screws into the holes in
the back of the seat, as shown.
•Tighten the screws.
Download from Www.Somanuals.com. All Manuals Search And Download.
Seat
Support Bar
Frame Assembly
tray
5
4
•"Snap" the tray handles into the holes in the seat.
IMPORtANt! This step must be completed before attaching
the seat to the frame assembly.
•"Snap" the support bar onto the pegs on the top of the
frame assembly.
10
9
•Insert two M4,5 x 18mm washer head screws into the holes on
the bottom of the seat, as shown.
•"Snap" the bear toy into the slot in the seat.
•Tighten the screws.
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Replacement
FCC Statement
United States Only
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician
for help.
1,5V x 3
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
LR44 or Equivalent
•Locate the battery compartment on the back of the bear.
•Loosen the screw in the battery compartment door with a Phillips
screwdriver screwdriver and remove it.
•Replace the batteries with three, new LR44 button cell
alkaline batteries.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
•Replace the battery compartment door and tighten the screw.
•If this toy begins to operate erratically, you may need to reset the
electronics. Remove the batteries and reinstall.
•When sounds become faint or stop, it’s time for an adult to
change the batteries!
ICES-003
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
NMB-003
Battery Safety Information
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada. L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes: (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter
tout brouillage radioélectrique reçu, meme si ce brouillage est
susceptible de compromettre le fonctionnement du dispositif.
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
•Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
•Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the product before charging.
•If removable, rechargeable batteries are used, they are only to
be charged under adult supervision.
Download from Www.Somanuals.com. All Manuals Search And Download.
Sit 'n Play
TNCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Press the button
on the bear
for musical tunes.
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Care
•Wipe with a clean cloth dampened with a mild soap and water
solution. Do not immerse this toy.
Sturdy Walker
•Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
M9523a-0920
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINtEd IN CHINA
Download from Www.Somanuals.com. All Manuals Search And Download.
|