Model T4444
Model M7596
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembled Parts
Note: Label sheet not shown.
Rear Axle
2 Front Axles
Roof
2 Axle Mounts
4 Wheels
4 Hubcaps
Sounds and Lights Box
2 Rear Bushings
Retainer
Cup Holder
4 Roof Posts
4 Wheel Covers
Steering Wheel
2 Cap Nut Covers
2 Front Bushings
Key
3
/
16” Washer – 4
.354” Cap Nuts – 5
#6 x 1/2” Screw – 3
#8 x 3/4” Screw – 11
ALL SHOWN ACTUAL SIZE
Note: Tighten and loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
Frame
For your convenience, we’ve included extra cap nuts!
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
1,5V x 3
“AAA” (LR03)
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
• Locate the battery compartment on the bottom of the sounds
and lights box.
• Loosen the screw in the battery compartment door. Remove
the battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
• If the toy begins to operate erratically, you may need to reset
the electronics. Remove and replace the batteries inside the
battery compartment.
• When sounds or lights from this toy become faint or stop, it’s
time for an adult to change the batteries.
Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities (Europe only).
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Sounds and
Lights Box
2
2
1
3
”
/16
Front Axle
Washer
Front
Bushing
Retainer
• Slide a 3/16” washer onto the front axle labeled 2.
Frame
• Then, slide a front bushing, flat side first, onto the front axle.
BOTTOM VIEW
• Turn the frame on its side.
• Fit the sounds and lights box onto the dash on the topside of
the vehicle.
• Then, fit the retainer over the battery compartment door on the
underside of the frame. Insert four #8 x 3/4” screws into the retainer
and tighten.
• Turn the frame upright.
3
4
Cap Nut
Wheel
Hubcap
Front Axle
Wheel
Cover
• Slide a wheel, smooth side first, onto the front axle.
• Then, slide a hubcap, post side first, onto the front axle and into
the wheel.
• Fit a cap nut onto the end of the front axle.
• Tap the cap nut with a hammer. Gently pull the wheel to make
sure the cap nut is securely attached to the front axle.
• Fit a wheel cover onto the hubcap, and push to “snap” in place.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
5
6
Cap Nut
Front Axle
Frame Front End
3
”
/16 Washer
Front Axle
2
• Fit a cap nut onto the end of the front axle, as shown.
• Tap the cap nut with a hammer.
• Gently pull the front wheel down to be sure the cap nut is
securely attached to the front axle.
FRONT VIEW
• Repeat assembly steps 2-6 to assemble the front axle labeled 1,
a wheel, a front bushing, a 3/16” washer, two cap nuts and a
wheel cover.
• First, slide a 3/16” washer onto the front axle.
• Then, insert the front axle labeled 2 up through the hole in the
front end of the frame also labeled 2.
Rear Bushing
Axle Mounts
9
10
Wheel
Hubcap
Rear Axle
Rear Axle
• Slide the rear axle through the holes in the axle mounts.
• Slide a hubcap, post side up, onto the rear axle.
• Next, slide a wheel, smooth side up, onto the rear axle.
• Then, slide a rear bushing, short end down, onto the rear axle.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Axle Mount
Cap Nut Covers
7
8
BOTTOM VIEW
• Fit a cap nut cover over each cap nut on the front end of the
frame. Push to “snap” in place.
• Turn the frame upside down on a flat surface.
• Fit an axle mount onto the pegs near the rear of the frame.
Hint: Each axle mount only fits on one side of the vehicle. If it does
not line up with the pegs on the frame, try fitting it to the other side.
• Insert three #8 x ¾” screws into the axle mount and tighten.
• Repeat this procedure to assemble the other axle mount to the
rear of the frame.
12
11
Rear Bushing
Cap
Nut
Wheel
Hubcap
• Slide a rear bushing, long end first, onto the rear axle.
• Next, slide a wheel, smooth side first, onto the rear axle.
• Then, slide a hubcap, post side first, onto the rear axle.
• Fit a cap nut onto the end of the rear axle.
• Tap the cap nut with a hammer. Gently pull the wheel to make
sure the cap nut is securely attached to the rear axle.
Hint: You may need the help of another adult to hold the rear axle
in place while you tap the cap nut.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Cap Nut Cover
13
14
Steering Wheel
Sounds and
Lights Box
• Fit a cap nut cover onto each rear wheel and push to “snap”
in place.
• Turn the frame upright.
• Fit the steering wheel onto the sounds and lights box.
• Insert three #6 x ½” screws into the steering wheel and tighten.
17
18
Cup
Holder
Roof Assembly
• Fit the cup holder onto the side of the frame.
• Insert a #8 x ¾” screw into the cup holder and tighten.
• Fit the roof assembly onto the frame. Push near each post to
“snap” in place.
Hint: The roof assembly is designed to only fit one way. If it does
not seem to fit turn it around and try again.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Posts
16
15
Key
Roof
• Fit the key into the hole in the dash. Push to “snap” in place.
• Turn the roof upside down on a flat surface.
• Fit the four posts into the roof and push to “snap” in place.
Hint: Each post is labeled (1, 2, 3 or 4). Match the number on the
post to the number on the roof.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Decoration
• Before applying the labels, wipe the surface of the vehicle with
a clean, dry cloth to remove any dust or oils.
• Place the labels exactly as shown in the illustrations. For best
results, avoid repositioning a label once it has been applied to
the vehicle.
• After applying a label, rub the label firmly with a clean, dry
cloth to make sure the label is adhered to your vehicle. Start at
the center of a label, and smooth towards the outer edges to
remove air bubbles.
2
5
6
(M7596 Only)
(T4444 Only)
1
5
5
(T4444 only)
(M7596 Only)
1
4
FRONT VIEW
9
10
(T4444 Only)
(T4444 Only)
7
6
(T4444 Only)
(M7596 Only)
7
8
3
(M7596 Only)
(T4444 Only)
BACK VIEW
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Use
Press the horn on the steering wheel
for fun car songs and lights!
Real working door!
11
Download from Www.Somanuals.com. All Manuals Search And Download.
TNCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052 U.S.A.
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN MEXICO
M7596aa-0920
Download from Www.Somanuals.com. All Manuals Search And Download.
|