K2566
WARNING
IMPORTANT! KEEP INSTRUCTIONS
FOR FUTURE REFERENCE.
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts
IMPORTANT! Please remove all parts from the package and identify them before assembly.
Some parts may be packed in the pad.
Seat Back Tube
Toy Bar
2 Retainers
Pad
Footrest with Soothing Unit
Base Tube
2 Feet
Left Base Wire
Right Base Wire
#8 x 1,9 cm Screw – 2
M5 x 20 mm Screw - 2
Note: Tighten or loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
Assembly
IMPORTANT! Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges.
DO NOT use if any parts are missing or broken. Contact Mattel for
replacement parts and instructions if needed. Never substitute parts.
Hint: We recommend using alkaline batteries for
longer battery life.
Base Tube
1,5V x 4
“D” (LR20)
Left Base Wire
1
Right Base Wire
• Place the base tube on a flat surface.
• Position the left and right base wires as shown.
• Fit the left base wire and right base wire into the base tube.
• Loosen the screws in the soothing unit battery
compartment door. Remove the battery compartment door.
• Insert four“D”(LR20) alkaline batteries.
•
Replace the battery compartment door.Tighten the screws.
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice
and facilities (Europe only).
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product. To
avoid battery leakage:
Feet Holes
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
2
• Insert batteries as indicated inside the battery compartment.
• Position the feet so the holes are toward you and the
non-skid surface is down.
• Fit the feet on the base tube, as shown.
• Remove batteries during long periods of non-use.Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Retainers
Seat Back Tube
Base Wire
Base Wire
3
• Insert an M5 x 20 mm screw through each foot and tighten.
Flex Base Wires Inward
Pull Up
Tabs
5
• Position the seat back
tube above the base
assembly.
• Fit the seat back tube
completely onto the
base wires.
• Fit a retainer (rounded
side inward) to one
4
end of the seat back tube.
• Insert a #8 x 1,9 cm screw through the outside hole in
• While flexing the base wires toward each other, hook the
footrest onto the ends of the base wires.
the seat back tube and into the retainer.
• Push the footrest down completely to the tabs on the base
wires.
• While holding the retainer in place, tighten the screw.
• Repeat this procedure to secure the other side of the
seat back tube to the base assembly using the remaining
retainer and #8 x 1,9 cm screw.
• Pull up on the seat back tube to be sure it is secure. If you
can remove either end of the seat back tube, you have not
assembled it correctly. Remove the screws and retainers.
Re-read and repeat Assembly step 5.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Latch
Tab
6
7
• Fit the pad upper pocket onto the seat back tube.
• Fit the pad lower pocket onto the footrest.
• Fit the toy bar ends into the sockets in the footrest.
Hint: The square end of the toy bar fits into the square
socket and the circular end of the toy bar fits into the
circular socket.
• Make sure the toy bar latches are secure.The small tabs on
the sockets should be visible in the opening in the latches.
Assembly is now complete.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Setup and Use
TIGHTEN
Buckle
Free End
WARNING
To prevent serious injury or death:
• Fall Hazard – It is dangerous to use
this reclined cradle on an elevated
surface, since child’s movement may
cause product to slide or tip over. Use
only on a floor.
• Suffocation Hazard – Never use on
a soft surface (bed, sofa, cushion),
since product can tip over and cause
suffocation in soft surfaces.
Anchored End
LOOSEN
Buckle
Free End
• Always use the restraint system.
• Never leave child unattended.
• Never use as a car seat.
• Never use as a carrier or lift while
child is seated. Never use the toy bar
as a handle.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/ 20 lbs).
2
Anchored End
To tighten the belts:
Feed the anchored end of the belt up through the buckle
to form a loop
• Pull the free end of the belt
• Repeat this procedure to tighten the other belt.
•
.
A
B
.
To loosen the belts:
• Feed the free end of the belt up through the buckle to
form a loop A . Enlarge the loop by pulling on the end of
the loop toward the buckle.
• Pull the anchored end of the belt to shorten the free end
B
of the belt
.
• Repeat this procedure to loosen the other belt.
Note: After adjusting the belts to fit your child, make sure you
pull on them to be sure they are securely fastened.
Restraint Pad
1
Buckle
Restraint Belt
3
Securing your Child
Calming Vibrations
• Make sure your child is properly secured in the seat.
• To turn vibrations on, slide the power switch on the
• If the toy bar is attached, remove it before placing your
child in the seat. Place your child in the seat. Position the
restraint pad between your child’s legs.
soothing unit to the on position
• To turn vibrations off, slide the power switch on the
soothing unit to the off position
.
• Fasten both restraint belts to the buckles on each side
of the restraint pad. Make sure you hear a “click” on both
sides.
.
• Check to be sure the restraint is securely attached by
pulling it away from your child.The restraint should
remain attached.
IMPORTANT! If vibrations become faint, or if there are no
vibrations, remove the“D”(LR20) batteries from the soothing
unit and dispose of them properly. Replace the batteries with
four, new“D”(LR20) alkaline batteries.
• Attach the toy bar, if desired (see Assembly step 7).
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Setup and Use
Latch
5
Remove the Toy Bar
• Pull the ends of the latches and lift the toy bar.
Care
The pad is machine washable.Wash the pad separately in
cold water on the gentle cycle. Do not use bleach.Tumble
dry separately on low heat and remove promptly.The frame,
toy bar can be wiped clean using a mild cleaning solution and
damp cloth. Do not use bleach. Do not immerse the soothing
unit or toy bar.
4
Mode Switch
Rainforest Sounds
or Music Switch
Volume Button
Rainforest Sounds or Music
• Slide the switch to rainforest sounds or music
.
Child-activated (Short Play)
• Slide the mode switch to
for child activated mode.
• When baby bats the monkey or the toucan, baby is
rewarded with rainforest sounds or music along with
motion and lights.
Parent-activated (Long Play)
•
Slide the mode switch to
for parent activated mode.
Baby enjoys 10 minutes of rainforest sounds or music,
a light show and motion.
Off
• Slide the mode switch to to turn off sounds, lights,
and motion.
Volume
• Push the volume button once for low volume
press again for high volume ; press again for off
;
.
IMPORTANT! If lights dim or sound or movement become
faint or stop all together, remove the "D" (LR20) batteries
from the soothing unit and dispose of them properly.
Replace the batteries with four, new "D" (LR20)
alkaline batteries.
©2007 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052, U.S.A.
PRINTED IN CHINA
K2566b-0726
8
Download from Www.Somanuals.com. All Manuals Search And Download.
|