HDMI 101 Plus • Setup Guide
Overview
The Extron HDMI 101 Plus is a cable equalizer that extends HDMI signals up to 250 feet
(76 m) at resolutions up to 1080p or 1920x1200. This setup guide provides instructions
for a basic installation by an experienced installer. For complete instructions, see the
Front Panel
2
Power and signal status LED — lights
amber when power is connected, lights green
a
when there is an active HDMI signal
HDMI input
b
1
HDMI INPUT
Rear Panel
3
HDMI output
c
HDMI 101 Plus
Power input — Connect the 12 VDC, 1 A
power supply to this power input.
POWER
12V
0.2A MAX
d
4
Alternatively, the HDMI 101 Plus can draw
power from the source device over the HDMI
cable but this reduces the maximum cable
length (see the table on the next page).
HDMI OUTPUT
Installation
Long HDMI Cable
250' (76 m) Max.
1. Place the HDMI 101 Plus at
the end of a long cable run
from the source device and
close to the output device.
2. Connect the source device to
the input of the equalizer.
See the table below for the
maximum cable distances.
HDMI 101 Plus
Short HDMI Cable
15' (5 m) Max.
POWER
X
12V
0.4A MA
HDMI OUTPUT
Extron
3. Connect the display device to
the output of the equalizer.
This cable should be a
HDMI 101 Plus
Equalizer
DVD with HDMI
Output
maximum of 15 feet (5 m).
Display
NOTE: Use the LockIt™ HDMI lacing brackets provided to secure the HDMI
connectors (see the LockIt HDMI Lacing Bracket Installation Guide at
Download from Www.Somanuals.com. All Manuals Search And Download.
|