Extron electronic Stereo System 15HD User Manual

MTP 15HD A Series • Setup Guide  
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and audio transmission  
systems.  
Installation  
Step 1 — Mounting  
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers  
as required.  
Step 2 — Transmitter Inputs  
AUDIO  
INPUT  
Connect a computer (VGA) video source to the Input connector.  
Connect a VGA monitor to the Monitor connector.  
Plug a 3.5 mm stereo audio plug into the audio jack.  
MONITOR  
Step 3 — TP Cables Between Units  
Terminate a TP cable as shown at right. Connect it between the transmitter’s Output port and  
the receiver’s Input port.  
T568A  
Pin Wire color  
T568B  
Pins:  
12345678  
Wire color  
1
White-green  
Green  
White-orange  
Orange  
NOTE: If the unit is labeled “C7,” only CAT 7 cable should be used.  
2
3
4
5
White-orange White-green  
For daisy-chaining, connect up to eight TP cables between a receiver’s Buffered Output port  
and a daisy-chained receiver’s Input port.  
Blue  
Blue  
White-blue  
White-blue  
6
7
8
Orange  
Green  
Step 4 — Receiver Outputs  
Insert Twisted  
Pair Wires  
White-brown  
Brown  
White-brown  
Brown  
Connect a VGA monitor to the Output connector.  
Connect a mono audio device to the Mono Audio connector. Wire the connectors as shown  
below.  
NOTE: If you are using Enhanced Skew-Free™ AV  
cable, use the TIA/EIA T568A standard only.  
MONO AUDIO  
ATTENTION: Connect the sleeves to ground (Gnd).  
1
2
Connecting the sleeve to a negative (-) terminal will damage the audio  
output circuits.  
Mono output 1+  
Mono output 1-  
Sleeve(s)  
Mono output 2+  
Mono output 2-  
Mono output 1  
NO GROUND.  
Sleeve(s)  
Mono output 2  
NO GROUND.  
OUTPUT  
Do not tin the wires!  
Balanced Output  
Unbalanced Output  
Step 5 — Receiver DIP Switches  
H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.  
Composite Sync, (SOG), and Video switches — Set these switches as shown in the table below to  
output the indicated format.  
ON  
1
2
3
4
5
6
Output Format  
RGBHV  
C Sync  
SOG  
Video  
RGBS  
RGsB  
Component*  
S-Video*  
Composite*  
NOTE: * Input video format must match.  
End Unit switch — Set this switches up if either of the following is true:  
The receiver being configured is the only receiver connected to the transmitter.  
The receiver being configured is the last receiver in a daisy-chained system.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cisco Systems Network Hardware OL 12812 01 User Manual
Craftsman Chipper 247797855 User Manual
Craftsman Dust Collector SP5373 User Manual
Curtis Portable DVD Player DVD1044 User Manual
CyberHome Entertainment DVD Player CH DVD500 User Manual
Eagle Electronics Portable Radio EVR 150 User Manual
Electro Voice Portable Speaker MTS 1 User Manual
Fisher Price Cell Phone X14969 User Manual
Fundex Games Games 2729 User Manual
GE Oven 164D2966P126 User Manual