Setup Guide — P/2 DA8 and DA12 Series
The Extron® P/2 DA8 and P/2 DA12 series of distribution
amplifiers distribute video (all models) and stereo audio
(P/2 DA8 A and P/2 DA12 A models only). Unless
otherwise stated, these instructions apply to all four
models.
These instructions provide a quick setup
guide for experienced installers. Installation
and service must be performed by authorized
personnel only.
W
MUTE
7
8
5
3
1
A
6
4
2
S
R
R
7
8
L
L
IO OUTP
UD
A
R
R
5
L
R
R
6
3
4
L
L
L
R
1
2
L
L
7
8
5
PUTS
T
VIDEO OU
3
4
1
2
A8
A
D
P/2
A
.6
INPUTS
0
V
0
4
-2
0
0
1
Sound
System
Hz
0
-6
0
5
Video In
Audio In
Plasma
Display
Projector
Installation
Step 1
Local Monitor
PC
Turn all the equipment off and disconnect all cables.
Step 2
Place the unit on a convenient table top or mount it in a rack, under a desk, or on a projector
mounting system. Follow the instructions included with the appropriate mounting kit.
Step 3
Use the provided IEC connector to connect the unit to a convenient power socket. The internal
power supply supports 100-240 VAC, 50-60 Hz.
Always use a power supply specified by Extron for this unit. Use of an unauthorized
power supply voids all regulatory compliance certification and may cause damage to the
supply and the distribution amplifier.
C
Step 4
Connect a video source to the video input, using a female DB-15 connector. Acceptable input
formats include: RGBHV, RGBS, RGsB, RsGsBs, YUV (tri-level and bi-level sync), S-video, and
composite video.
Step 5 (P/2 DA8 A and P/2 DA12 A models only)
Connect an unbalance audio source to the female 3.5 mm TRS connector.
Step 6
Connect up to eight (P/2 DA8 series) or twelve (P/2 DA12 series) display devices using female
DB-15 connectors. The output signal format follows that of the input.
Output 1 is used for DDC reference.
N
(Continued on reverse side)
Download from Www.Somanuals.com. All Manuals Search And Download.
|