EverFocus Security Camera EHD360 User Manual

EVERFOCUS  
High Resolution Vandal Proof  
Weather Resistant 3-Axis IR Dome Camera  
Operation Instructions  
Model No. EHD360  
Please read this manual first for correct installation and operation. This manual should be retained  
for future reference. The information in this manual was current when published. The  
manufacturer reserves the right to revise and improve its products. All specifications are therefore  
subject to change without notice.  
PRECAUTIONS  
1. Do not install the camera near electric or magnetic fields.  
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers  
and audio speakers since the electromagnetic fields generated from these devices may distort  
the video image or otherwise interfere with camera operation.  
2. Never disassemble the camera beyond the recommendations in this manual nor  
introduce materials other than those recommended herein.  
Improper disassembly or introduction of corrosive materials may result in equipment failure  
or other damage.  
3. Try to avoid facing the camera toward the sun.  
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or  
internal circuits, as well as creating unbalanced illumination beyond the capability of the  
camera to compensate.  
4. Keep the power cord away from water and other liquids and never touch the power  
cord with wet hands.  
Touching a wet power cord with your hands or touching the power cord with wet hands may  
result in electric shock.  
5. Never install the camera in areas exposed to oil, gas or solvents.  
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.  
6. Cleaning  
For cameras with interchangeable lenses, do not touch the surface of the sensor directly with  
the hands. Use lens tissue or a cotton tipped applicator and ethanol to clean the sensor and  
the camera lens. Use a damp soft cloth to remove any dirt from the camera body. Please do  
not use complex solvents, corrosive or abrasive agents for cleaning of any part of the camera.  
7. Do not operate the camera beyond the specified temperature, humidity or power source  
ratings. This camera is suitable for indoor and outdoor operation.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Camera Unit x 1  
Mounting kit includes:  
-Screws x 4  
-Security wrench for housing screws x 1  
-Expanding Screws x 4  
-Washers x 4  
Operation Instructions (this document) x 1  
Weatherproof bushing x 1  
Power cable x 1  
Video cable x 1  
Power adapter pigtail (for NTSC model only) x 1  
Mounting template x 1  
SPECIFICATIONS  
Pickup Device  
Video Format  
Picture Elements  
Horizontal Resolution  
Sensitivity  
1/3" SONY Super HAD CCD Sensor  
NTSC or PAL (depends on model selected)  
768 x 494 (NTSC), 752 x 582 (PAL)  
540 TVL  
0.12 LUX / F1.6 ; 0 LUX (IR LED ON)  
Over 48dB (AGC off)  
1/60(1/50)s~1/100,000s  
BNC 1.0Vp-p 75  
S/N Ratio  
Electronic Shutter  
Video Output  
Gamma Correction  
Lens Type  
0.45  
Vari-Focal 3.7~12mm / F1.4 DC Drive Auto Iris Lens  
True day/night with motorized IR cut filter  
Automatic  
Day/Night  
Gain Control  
White Balance  
Sync. Mode  
ATW (2500°K~9500°K)  
Internal Sync.  
IR LED  
11 Units High Efficiency IR LED  
850nm  
IR Wavelength  
IR Distance  
25m (~80ft.) nominal; depends on environment  
IP 66  
Weather Resistant  
Vandal Proof  
Yes  
Power Source  
Power Consumption  
Operating Temperature  
Dimensions (O.D. x H)  
Weight  
12VDC  
283mA @12VDC  
-10°C~50°C / 14°F~122°F  
142mm x 115.5mm / 5.6” x 4.55”  
979 g / 2.16 lbs  
Certifications  
CE / FCC  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
DIMENSIONS  
C
B
D
A
Bottom View  
Dimensions  
Front View  
E
F
G
Top View  
Bottom View  
A. Lens  
B. IR-LED  
E. Inner plate mounting holes  
F. BNC Connector  
C. Side conduit entry  
D. Back conduit entry  
G. DC Connector  
INSTALLATION INSTRUCTIONS  
Drill the Holes  
1. Locate the desired mounting location; position housing with camera pointed generally in the  
desired direction and mark location.  
2. Use template to fix hole locations. Drill 4 holes for mounting screws and insert plastic anchors  
into holes after drilling.  
Mounting Steps  
1. Use the security wrench provided to loosen the 4 screws holding the dome cover.  
2. Remove the dome cover. Attach the camera body to the mounting surface with the mounting  
screws provided  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
3. Tighten the 4 mounting screws to secure the camera body to the mounting surface.  
3. If you need to wire cable through side conduit hole, use a coin to remove the conduit plug;  
save the plug as it will be used to close the rear conduit hole.  
Back conduit  
hole  
Conduit plug  
Side conduit hole  
4. Disconnect the power and video wire from the camera board end of the wire. Gently pull the  
wire out from under the plate until it is free. Using wrench or pliers, remove the weather tight  
bushing from the rear conduit hole. Using the plug removed in step 3 above, close the rear conduit  
hole (additional caulk or other sealant recommended).  
5. Pass the camera end of the power/video cable through side conduit hole. Using wrench or  
pliers, carefully tighten the weather tight bushing into the side conduit hole.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
6. (Optional) Pass the power/video wire under the base plate and up through the center hole.  
7. Position the power/video wire so that it does not interfere with the camera module and carefully  
attach the connector to the camera board, being sure to position the connector so it fit properly  
onto the tiny pins within. Failure to properly align this connector may permanently damage the  
camera.  
General Connection and Setup  
1. Connect the power cord to DC 12V power supply (observe polarity for power – connecting  
reverse polarity will damage the camera and void the warranty).  
2. Connect the camera to a monitor with 75ohm type coaxial cable.  
3. Loosen the screws which lock the tilt mechanism. Rotate the pan and tilt mechanisms to point  
the camera in the desired direction. Rotate the camera module on its axis if necessary to align  
the image ‘upright’. Loosen the lens adjusting screws and adjust the lens to obtain the desired  
field of view and focus.  
Tilt lock  
2 places  
Lens adjustment  
Focus adjustment  
4. Lock the lens and tilt screws. Put the dome cover back and align the clear window in the dome  
cover with the lens. Attach the dome cover to dome base with the 4 mounting screws.  
NOTE: The cover only goes on in ONE direction. There is a key and slot; if not aligned, cover  
will not close properly.  
NOTE: If you move the camera module, it is necessary to loosen the dome and liner and  
reposition the liner so the lens points out through the slot, and the rubber seal presses onto the  
clear part of the dome and not the liner. Loosen 4 Philips screws, reposition liner, TIGHTEN four  
screws (else seal and vandal resistance is compromised).  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
EverFocus Electronics Corp.  
EverFocus Taiwan:  
EverFocus Europe - Germany:  
12F, No.79, Sec. 1, Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
Albert-Einstein-Strasse 1, D-46446  
Emmerich, Germany  
TEL: +886 2 2698 2334  
TEL: +49 2822 93940  
FAX: +49 2822 939495  
FAX: +886 2 2698 2380  
EverFocus China - Shenzhen:  
4F, No. 2, D4 Building, Wan Yelong  
Industrial Park, Tangtou Road, Shiyan,  
Baoan, Shenzhen, Guangdong 518101, China  
TEL: +86 755 2765 1313  
EverFocus China - Beijing:  
Room 609, Technology Trade Building,  
Shangdi Information Industry Base,  
Haidian District, Beijing 100085, China  
TEL: +86 10 6297 3336~39  
FAX: +86 755 2765 0337  
FAX: +86 10 6297 1423  
EverFocus USA - California:  
EverFocus USA - New York:  
1801 Highland Avenue, Unit A, Duarte, CA 91010,  
USA  
415 Oser Avenue, Unit S, Hauppauge, NY 11788, USA  
TEL: +1 631 436 5070  
TEL: +1 626 844 8888  
FAX: +1 626 844 8838  
FAX: +1 631 436 5027  
EverFocus Japan:  
EverFocus Europe - UK:  
5F, Kinshicho City Building, 2-13-4  
Koto-Bashi,Sumida-Ku, Tokyo, 130-0022, Japan  
TEL: +81 3 5625 8188  
Unit 12, Spitfire Business Park,  
Hawker Road, Croydon Surrey, CR0 4WD, UK  
TEL: +44 20 8649 9757 / +44 845 430 9999  
FAX: +44 20 8649 9907  
FAX: +81 3 5625 8189  
EverFocus India:  
Suite 803, Housefin Bhavan, C-21, Bandra Kurla  
Complex, Bandra (East), Mumbai 400051, India  
TEL: +91 22 6128 8700  
FAX: +91 22 6128 8705  
Ihr EverFocus Produkt wurde entwickelt  
und hergestellt mit qualitativ  
hochwertigen Materialien und  
Komponenten, die recycelt und wieder  
verwendet werden können.  
Dieses Symbol bedeutet, dass  
elektrische und elektronische Geräte am  
Ende ihrer Nutzungsdauer vom  
Hausmüll getrennt entsorgt werden  
sollen.  
Bitte entsorgen Sie dieses Gerät bei  
Ihrer örtlichen kommunalen  
Your EverFocus product is designed  
and manufactured with high quality  
materials and components which can  
be recycled and reused.  
This symbol means that electrical and  
electronic equipment, at their  
end-of-life, should be disposed of  
separately from your household waste.  
Please, dispose of this equipment at  
your local community waste  
collection/recycling centre.  
In the European Union there are  
separate collection systems for used  
electrical and electronic product.  
Please, help us to conserve the  
environment we live in!  
Sammelstelle oder im Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu  
erhalten, in der wir leben
Rev 2.0 – February 2012  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  

Coleman Camping Equipment 2000001081 User Manual
Compaq Network Card everywhere85 User Manual
Crane Merchandising Systems Hot Beverage Maker 670 User Manual
Creda Air Conditioner NP100 75 772902 User Manual
CTX Computer Monitor M730V User Manual
Cub Cadet Lawn Mower SLT1550 SLT1554 User Manual
Cypress Computer Hardware CY7C1019BN User Manual
Elation Professional Work Light 250 Pro User Manual
Extron electronic Speaker S1 26W User Manual
Gaggia Espresso Maker Espresso User Manual