Installation and Operating Instructions
INDCLTS7RG Issue 1
Dimplex Skirting Heaters
Models : DXLAT75, DXLAT150 & DXLAT150Ti
Dimensions
(millimetres)
Models
Specification
A
B
DXLAT75
DXLAT150
0.75kW Switch / Thermostat / Neon
1.5kW Switch / Thermostat / Neon
250
305
120
165
DXLAT150Ti 1.5kW 24Hour Timer / Thermostat
305
165
Fig. 1
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLYAND RETAINED FOR FUTURE REFERENCE
IMPORTANT : If the plug is not suitable for your socket, the 13
amp plug should be removed. Before wiring the appropriate plug,
please note that the wires in this mains lead are coloured in
accordance with the following code :
Important Safety Advice
If the appliance is damaged, check immediately with the
supplier before installation and operation.
GREENANDYELLOW:
BLUE:
EARTH
NEUTRAL
LIVE
WARNING – THIS APPLIANCE MUST NOT BE USED IN A
BATHROOM.
WARNING - DO NOT USE THIS HEATER IN THE IMMEDIATE
SURROUNDINGS OF ABATH, A SHOWER OR A SWIMMING
POOL.
BROWN :
Connect the GREEN AND YELLOW wire to the terminal marked
‘E’ or by the earth symbol
YELLOW.
, or coloured GREEN or GREEN AND
WARNING – THIS HEATER MUST NOT BE LOCATED
IMMEDIATELY BELOWAFIXED SOCKET OUTLET.
Connect the BROWN wire to the terminal marked ‘L’ or coloured
RED.
DO NOT USE THE HEATER UNTIL THE FEET ARE FITTED
CORRECTLY.
Connect the BLUE wire to the terminal marked ‘N’ or coloured
BLACK.
FOLLOW these instructions carefully.
NEVER cover or obstruct in any way the heat outlet slots at
the top of the heater or the air inlet slots in the base of the
heater.
Positioning the heater
Always ensure that the heater is stood on a firm, level base near
to, but not directly beneath, a suitable mains supply socket,
ensuring at least 300mm clearance from any shelf above.
The heater carries the Warning symbol, indicating that
it must not be covered.
Warning: In order to avoid overheating, do not cover the
heater
Ensure that curtains and furniture are not positioned close to the
chosen position, as this would create a potential fire hazard.
Caution: In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on
and off by the utility.
See also ‘Important Safety Advice’.
Fitting Feet
NEVER USE THE HEATER FREE STANDING WITHOUT THE FEET
FITTED.
This appliance is not intended for use by children or other
persons without assistance or supervision if their physical,
sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure that they do
not play with the appliance.
If young children, the aged or infirm are likely to be left in the
vicinity of the heater, we advise that adequate precautions
should be taken. We recommend that a guard be fitted to
ensure contact with the heater is avoided and objects cannot
be inserted into the product.
If the mains lead is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
Electrical connection
WARNING – THISAPPLIANCE MUST BE EARTHED
Fig. 2
This heater must be used on an ~ supply only and the voltage
marked on the heater must correspond to the supply voltage.
This heater is fitted with a rewireable plug incorporating a 13
amp fuse. In the event of replacing the fuse in the plug supplied,
a 13 amp fuse approved by ASTA to BS 1362 must be used. If any
other type of plug is used, a 15 amp fuse must be fitted in the
plug, the adaptor, or at the distribution board.
Lay the heater on its back, and locate the foot fixing screw (see ‘a’
in Fig. 2). Remove the screw using an X–head screwdriver, then
align foot over slots and holes in base and slide home. Finally
take the foot fixing screw, insert and tighten using a screwdriver
to secure the foot.
Note - Timer Memory Back Up Batteries - Once the heater has
been left plugged in with the socket switched on for at least 72
hours the timer’s memory back up batteries will be fully charged.
Once the timer batteries are fully charged, if there is a power cut
or if the heater is disconnected from the mains for less than six
months, then the timer will continue to keep time & the settings in
the memory will remain intact.
Safety – overheat protection
For your safety, this appliance is fitted with a thermal cut-out. In
the event that the product overheats for some reason, the cut-out
prevents excessive temperatures on the product by cutting the
power to the heater. Once the heater has cooled down, it will
reset automatically, it will continue to cycle on and off automatically
until the reason for overheating has been removed.
Important Notes
Although this heater is manufactured to comply with the relevant
safety standards, certain types of carpets could become
discoloured by the temperatures under a portable heater. If you
are concerned about this, we recommend that you contact the
carpet manufacturer for guidance. Alternatively, either stand the
heater on a suitable base to shield the carpet – call our Helpline
for further advice.
You may notice some parts of the element appearing to be hotter
from time to time because of the variable airflow through the
heater. This does not cause a safety hazard.
The heat outlet grille may become discoloured with use – this is
caused by airborne pollution and is not a fault.
Download from Www.Somanuals.com. All Manuals Search And Download.
Cleaning and User Maintenance
WARNING –ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORECLEANINGTHEHEATER.
Do not use detergents, abrasive cleaning powder or polish of
any kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove dust
and a damp cloth (not wet) to clean off stains. Be careful not to
allow moisture into the heater.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice in your country.
After Sales Service
Your product is guaranteed for three years from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge provided it has been installed and
operated in accordance with these instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales service you should contact our
customer services help desk on 0845 600 5111. It would assist
us if you can quote the model number, series, date of purchase,
and nature of the fault at the time of your call.
Please do not return a faulty product to us in the first instance as
this may result in loss or damage and delay in providing you with
a satisfactory service.
Please retain your receipt as proof of purchase.
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336
Glen Dimplex UK Limited
Millbrook House
Grange Drive
Hedge End
Southampton
UK customer help line 8.00am–5.00pm Mon-Fri and 8:30am-1.00pm Sat (Autumn–Winter only)
Customer Services:
Republic of Ireland
Tel.
0845 600 5111
01489 773053
Fax.
e-mail [email protected]
Hampshire. SO30 2DF
Tel. 01 8424833
[c] Glen Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.
Download from Www.Somanuals.com. All Manuals Search And Download.
|