RG.MA.124
-
V.1.0
Download from Www.Somanuals.com. All Manuals Search And Download.
Cyclades-PR4000
Step Four:
Digital Modems
Attach the wrist-strap to your wrist.
Step Five:
Remove the PR4000’s cover. Be careful to not touch any components inside the PR4000’s
case, as they also can be damaged by static electricity.
Step Six:
Open the clamps on the slot where the board will be installed, as shown in the figure.
The slots are numbered from 0 to 7. The software does not depend on the board being
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Digital Modems
Cyclades-PR4000
installed in a particular slot, but installing the first board in slot 0, the second in slot 1,
and so on makes the installation of each succeeding board easier. It is important that
each board be handled as few times as possible.
Step Seven:
Confirm that the wrist-strap is grounded. Remove the modem board from its anti-static
packaging, being careful to not touch the components or metal parts of the board (see
the figure).
Step Eight:
Insert the board carefully into the slot, aligning the indentations in the board with the
guides of the slot. Forcing the board or pushing it in at an angle can damage the board
and the slot.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Cyclades-PR4000
Step Nine:
Digital Modems
Push the board into the slot until the clamps close around the board.
Step Ten:
Replace the PR4000’s cover and replace the screws. Now you can remove the wrist-
strap.
Step Eleven:
Reconnect the PR4000’s cables, including the console cable. Start up the terminal
program used to access the PR4000. Plug in the power cable and turn the PR4000 on.
When the PR4000 boots, the following messages should appear (two boards are shown
in this example):
DSP Cards Detected . . . . . . . . . . . . OK
8-DSP CARD on DIMM 1
8-DSP CARD on DIMM 2
Loading modem 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13,
14, 15, 16 . . . done
If there is a problem with the board or if the messages shown above (for the correct
number of modems) do not appear, call Cyclades’ Technical Support.
NOTE: The board should be connected to the PR4000 only by its presence in the slot.
The terminals on the opposite side of the board are not intended to be used for a
connection.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Cyclades Europe
Munich, Germany
Cyclades Corporation
41934 Christy Street
Fremont, CA, USA - 94538
phone (510) 770-9727
fax (510) 770-0355
e-mail: [email protected]
e-mail: [email protected]
Cyclades Brasil
São Paulo, SP, Brasil
Download from Www.Somanuals.com. All Manuals Search And Download.
|