9. Do not use on a soft surface such as a bed,
where openings may be blocked.
10. Turn switch to “OFF” position and unplug cord
before replacing light bulbs.
11. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
IMPORTANT SAFETY
INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR
HOUSEHOLD USE. WHEN USING
ELECTRICAL APPLIANCES, BASIC
12. Do not place in or drop into water or other
liquid.
13. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
Use on any 120 volt 60 hertz AC electric outlet
(ordinary house current). Do not use it on any other
electrical outlet.
Screw for
SAFETY PRECAUTIONS SHOULD ALWAYS
bulb access
BE TAKEN, INCLUDING THE
FOLLOWING:
Bottom Cover
INSIDE VIEW
(Fig. 2)
WARNING–To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. Read all instructions before using the appliance.
(Fig. 1)
SAVE THESE
INSTRUCTIONS
2. To protect against electrical hazards, do not
use while bathing or in the shower.
3. Close supervision is necessary when any appli-
ance is used by or near children or by invalids.
TO INSTALL BATTERIES
A.C. ADAPTER
1. Remove battery cover..
NOTE: UNIT SUPPLIED WITH A UL LISTED
3.6VAC ADAPTER. FOR MORE INFORMATION,
PLEASE CONTACT A CONAIR SERVICE CENTER.
2. Install 3 “AA” new batteries as indicated on battery
box. (Fig. 2)
3. Replace battery cover by snapping it into place.
4. Unplug the appliance from outlet when not in
use and before cleaning. Do not leave appli-
ance unattended when it is plugged in. Keep
cord away from heated surfaces.
5. Do not operate this appliance with a damaged
cord or plug or if the appliance malfunctions or
has been dropped or damaged in any manner.
Return appliance to nearest service facility for
examination, electrical or mechanical adjust-
ment, or repair. No repairs should be attempted by
the consumer.
6. Use appliance only for intended use as
described in this instruction book. The use of
attachments not recommended or sold by
Conair may cause hazards.
7. Do not use outdoors or operate where aerosol
(spray) products are being used, or where oxy-
gen is being administered.
MAINTENANCE
OPERATING
TO REPLACE BULB
Your lighted mirror is designed for household
use and is virtually maintenance-free. No
lubrication is needed.
INSTRUCTIONS
CAUTION: TURN OFF POWER
AND UNPLUG. ALLOW TO
COOL AT LEAST 3 MINUTES
BEFORE REPLACING BULB.
1. Your lighted makeup mirror is 6” in diameter with
5X and 1X magnification. (Fig. 1)
If cleaning becomes necessary, disconnect the
appliance from the power source and wipe exterior
with a damp cloth. Clean mirror surfaces with a glass
cleaner. Do not light until you are certain mirror is
completely dry.
If any abnormal condition occurs, unplug the lighted
mirror, allow it to cool, and return it to an authorized
service center for repair.
2. This unit operates on 3 “AA” batteries (not
included) or an adapter (included). Plug into any
standard wall outlet (120 Volt AC). Turn switch to
the “ON” position.
3. After use, always turn switch to the “OFF” position
and unplug the adapter from the wall outlet.
4. The beauty and design of this Classique™
Collection mirror complement any decor.
Therefore, you may wish to leave the mirror dis-
played. However, if you choose to store the mir-
ror, see “STORAGE” for detailed information.
5. “DO NOT MIX OLD & NEW BATTERIES”, DO NOT
MIX ALKALINE, STANDARD (CARBON-ZINC) OR
RECHARGEABLE (NICKEL CADMIUM) BATTERIES.
NOTE: Do not use bulbs other than those supplied
by Conair. Contact a Conair service center for
replacement bulb information.
1. Unscrew the two side screws on the
mirror head.
2. Carefully take out the removable mirror head
housing.
3. Unscrew light bulbs and replace with new
light bulb.
4. Replace mirror head by lining up the screw
holes and screw into place.
8. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause
fire.
Download from Www.Somanuals.com. All Manuals Search And Download.
|