INSTANT SHELTER
MODEL 2000002251
®
4. Secure sides of shelter top to frame
with large, rectangular, hook & loop
fasteners provided (2 on each side)
(Fig. 4). The shelter top has been
designed to have a tight fit over
the frame.
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property
damage or personal injury.
Fig. 4
5. Secure all remaining hook & loop
fasteners, located on underside of
shelter top, to shelter frame. (Fig. 5)
Fig. 5
• For best results in windy conditions, position narrow end of
shelter into the wind.
• Do not drop shelter bag or pole.
• Do not bounce shelter bag on its end to remove shelter, as these
actions may damage the shock-cord and/or pole ends.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF
TWO PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
Adjust the Height
Post
1. Adjust desired height by sliding
post upward until push button locks
into place. Raise each post one
notch at a time, making sure all four
posts are level before proceeding to
the next notch. (Fig. 6 & 7)
Notches
Push
Button
Replacement Parts List
Description
Shelter Top
Screen House
Sun Wall
Part Number
5010000666
5010000667
5010000668
Fig. 6 Fig. 7
NOTE: If installing the screen house
panels to your shelter, skip the following
steps and proceed to “Install the Screen House”on the back page.
Stake the Shelter
Extend the Shelter Frame
1. Secure shelter by driving nail stakes through
the holes located on the metal base of each
frame post. (Fig. 8)
1. Select a smooth, level site for your shelter.
2. With two persons standing at diagonal corners of the struc-
ture, grab the leg, and pull out to unfold frame. (Fig. 1)
NOTE: Do not unfold frame completely. This will allow easier
fit for draping shelter top over frame.
2. Stretch elastic strap on shelter post cover;
then insert metal hook into hole on post.
Repeat for remaining three posts. (Fig. 9)
3. If shelter is set at shorter heights, secure
post covers with metal stake through metal Fig. 8
grommet on each. (Fig. 10)
If shelter is set at maximum height, secure post covers with
metal stake through web strap on end of each. (Fig. 11)
Fig. 1
Set Up the Shelter
Fig. 10
Fig. 11
Fig. 9
1. Drape shelter top over frame. (Fig. 2)
2. Attach hook & loop fasteners, located on corners of shelter
top, to four corners of frame post. (Fig. 2A)
Secure the Guylines
1. To secure guylines, find the guyline plastic slider and look for
the portion, forming a loop (works just like a slip knot!).
Extend guylines to ground until taut; then stake through the
loops to secure. (Fig. 12, 13, & 14).
Fig. 2
Shelter Top
Fig. 12
Shelter Top
2A
Shelter
Post
Cover
Fig. 3
3. After fitting each corner of
shelter top to frame, pull up
sliding mold located on
upper portion of leg until
push button snaps into
place (Fig 3 & 3A).
Push
Button
Fig. 13
Shelter Post
Cover
3A
Fig. 14
This will ensure fame is
fully extended.
(See other side for installing the screen house)
Download from Www.Somanuals.com. All Manuals Search And Download.
|