TM
EVANSTON 6 TENT
MODEL 2000001589
9. Attach frame clips along edges of tent
Fig. 3
Before you begin
to the black & grey Main Poles.
(Fig. 3)
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or sharp
objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning strikes
or falling tree limbs in inclement weather.
10. Stretch tent until taut, then secure metal loops
located on both sides and four corners of tent
with stakes. (Fig. 4)
• Secure with all stakes and guylines provided to prevent property damage
or personal injury.
• For best results in windy conditions, position narrow end of tent into
the wind.
• Enlist the help of at least one other person to assist you when it is time
to assemble the tent.
Fig. 4
Pole Descriptions
To Attach Rainfly
Pole
Pole
Pole
1. Drape Rainfly over tent with dark blue vestibule flaps located at the
front of the tent. (Fig 5).
Description
Qty. Dia.
Repair Kit Replacement Kit
NOTE: Hook and loop fasteners, located on seams of underside of
Rainfly, should be centered over black & grey Main Poles.
2. Insert the long, black, Rainfly Pole with through sleeve in underside
of Rainfly above front door of tent. (Fig. 5)
Main Pole, black
2
1
1
1
11mm 501000539
11mm 501000539
11mm 501000539
6.9mm 501000542
501000549
Main Pole, grey
501000549
501000549
501000552
Rainfly Pole, black, long
Awning Pole, black, short
Sleeve with Grey Trim
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with the door
facing the desired direction. (Fig. 1)
Rainfly
Black, Shock-corded
Rainfly Pole
2. Assemble all poles by interlocking the shock-corded, sections
together.
3. Insert black Main Poles through the black trimmed sleeves on top
of tent forming an X”.
Door
4. Insert grey Main Pole through grey trimmed sleeve, in front of tent.
Make sure grey Main Poles overlap the black Main Poles. (Fig. 1)
Front of Tent
Vestibule Flaps
Fig. 5
Fig. 1
Sleeves with Black Trim
3. Insert short, black, thin Awning Pole through sleeve in underside of
Rainfly above window at back of tent. (Fig. 6)
4. Insert metal tip into grommet on tent seam at back of tent (Fig. 7).
Go to opposite end of Awning Pole and gradually apply pressure to
pole forming an arch; then insert metal tip into grommet.
Grey, Shock-corded
Main Pole
Sleeve with
Grey Trim
Door
Rainfly Sleeve
Awning Pole
Front of Tent
Black, Shock-corded Main Poles
Grommet
5. Insert end of each black Main Pole into pins located in the corners
of the tent. (Fig. 2 & 2A)
6. Go to opposite end of each black Main Pole and gradually apply
pressure to each forming arches. Insert the pin into each pole end
at the corners of tent. (Fig. 2 & 2A)
Awning
Pole
Back of Tent
Fig. 7
Fig. 6
7. Insert end of the grey Main Pole into pin located on the sides of the
tent. (Fig. 2 & 2B)
8. Go to opposite end of the grey Main Pole and gradually apply pres-
sure to form an arch. Insert the pin into pole end at the side of tent.
(Fig. 2 & 2B)
5. Insert end of each black Rainfly Pole into
pin on either side of front door. (Fig. 8)
6. Go to opposite end of Rainfly Pole and
gradually apply pressure to form an arch.
Insert the pin into pole end at other side of
the door. (Fig. 8)
7. Locate all hook & loop fasteners on under
side of Rainfly and wrap around all Main
Poles, Awning & Rainfly Pole to secure.
(Fig. 9)
Fig. 2
Fig. 8
Fig. 9
NOTE: Make sure longer hook & loop
fastener on Rainfly is secured around grey
and black Main Poles where they cross.
(Fig. 10)
Door
Fig. 10
Front of Tent
2A
2B
(continued on other side)
Download from Www.Somanuals.com. All Manuals Search And Download.
|