TM
EVANSTON 14’ X 12’
MODEL 2000000144
To Set Up Tent (continued)
Before you begin
8. Assemble the
interlocking
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
shock-corded,
gray, shorter pole.
9. Slide pole through
sleeve on front of
tent. (Fig. 5)
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
Fig. 5
10. Pull down on pole and
insert into center pin
location on side of tent.
(Fig. 6)
11. Go to opposite side of
tent and gradually apply
pressure to the pole to
form an arch. Insert the
pin into the pole.
Parts and Components
Description
Part Number
Main Poles (2)
Side Poles (2)
Rainfly
9163-1101
9163-1111
5010000505
Fig. 6
Vertical Hinge Door Pole, Black, short with
plastic cap tips (1)
9163-1121
9163-1171
12. Attach frame clips along edges of tent
Hinge Door Pole, Black, long with
plastic cap tips (1)
to frame poles. (Fig. 7)
To Set Up Tent
Fig. 7
1. Unfold tent and spread out on a clean, level surface with the
door facing the desired direction. Unzip door.
2. Assemble main tent poles by interlocking both longer, black
shock-corded, poles.
To Attach Rainfly
1. Assemble remaining interlocking
shock-corded rainfly pole (gray pole).
2. Drape rainfly over tent. Make sure
end with two flaps is centered over
the door.
3. Insert black poles through sleeves in top of tent forming an
“X” as shown. (Fig. 1)
Fig. 1
3. Slide gray pole through sleeve in
rainfly. (Fig. 8)
Fig. 8
4. Insert one end of each rainfly pole
into remaining pin in front corner
of tent. Gradually apply pressure
to other end of pole to form an
arch & insert into other front pin.
(Fig. 9)
4. Insert one end of each black pole into
pins in rear corners of tent. (Fig. 2)
Fig. 9
Fig. 2
5. Hook clips on elastic loops of
rainfly onto rings on all four
corners of the tent. (Fig. 10)
5. Go to opposite end of each pole and gradually apply pressure
to the pole forming an arch. Insert the pin into the pole end
at the tent corners.
(Fig. 3)
6. Stretch corners of
tent until floor is taut
then hammer stakes
through loops to
secure.
Fig. 10
6. Secure rainfly with velcro hook & loop ties located on
underside of fly. (Fig. 11 & 12)
Fig. 3
7. Attach frame clips along edges
of tent to frame poles (Fig. 4)
Fig. 11
Fig. 12
Fig. 4
(continued on other side)
Download from Www.Somanuals.com. All Manuals Search And Download.
|