Code Alarm Digital Photo Keychain CATX1WAY User Manual

Model CATX1WAY  
Programming Guide  
The keychain transmitters included with the system have been pre-programmed at the factory,  
with each button pre-assigned to control a specific function of the system.  
The system will store codes from up to 8 different transmitters. If a 9th transmitter is  
programmed to the system, then the first transmitter programmed to the system will be  
erased from the system’s memory.  
To program new or additional transmitters, the alarm must be disarmed and out of valet mode:  
1. Open the drivers door (verify that the vehicle’s interior light turns on.  
2. Turn the ignition key to the ON or RUN position.  
3. Press and hold the emergency override button  
3a. After 10 seconds the horn will honk three (3) times. This indicates  
that the system has entered transmitter programming mode.  
4. Release the emergency override button.  
5. Press the LOCK icon button on the remote transmitter to be programmed.  
5a. The horn/siren will sound 1 time, indicating that the system has  
“learned” that remote transmitter.  
6. Repeat step 5 for any additional remote transmitters.  
Deleting Lost or Stolen Remote Controls from Your System  
If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to  
remove the control code from your system.  
1. Have all remaining remote controls available.  
2. Enter the control programming mode by following steps 1 - 5 of Adding Remote Controls  
to Your System.  
3a. If you have only one remaining remote control, press the  
LOCK button on that remote control four (4) times, pausing  
at least 1 second in between each press. The horn must  
“honk” each time you press the LOCK button.  
3b. If you have two remaining remote controls, press the LOCK  
button on each remote control two (2) times, pausing at least  
1 second in between each press. The horn must “honk” each  
time you press the LOCK button.  
3c. If you have three remaining remote controls, press the  
LOCK button on two of the remote controls one (1) time, then press the  
LOCK button on the remaining remote control twice. Pause at  
least 1 second in between each press. The horn must “honk”  
each time you press the LOCK button.  
4. Turn the vehicle ignition off to exit the programming mode. When you are finished, the lost  
or stolen remote control will no longer operate your system.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Continental Refrigerator Refrigerator R 404A User Manual
Craftsman Snow Blower 5368884 User Manual
Creative Network Card Modem User Manual
Cypress Computer Hardware CY7C1007B User Manual
Danby Microwave Oven DMW111KSSDD User Manual
Dynatech Pill Reminder Device PN 106082 115v User Manual
Dynex Network Cables DX C114191 User Manual
Electro Voice Microphone N D257A User Manual
Gateway Laptop 450RGH User Manual
GE Oven JCKP30 User Manual