SPOTLIGHT
1,000,000 CANDLE POWER
42417
ASSEMBLY & OPERATING INSTRUCTIONS
2000
Download from Www.Somanuals.com. All Manuals Search And Download.
Grounding/VoltageWarning
Common household current is 110-120 volts. As long as the outlet used with the tool is rated from 110-120V
there will be no complications using it with household receptacles. Plug the tool into a 110-120V properly
grounded outlet protected by a 15-amp, dual element time delay or circuit breaker.
NEVER try to plug a 110-120V tool into a 220-240V circuit or serious complications and possible injury to the
operator may occur. The plugs have different shapes to prevent this.
Assembly
Your Spotlight comes completely assembled.
Operation
To assist you with operating your Spotlight please refer to Figure 1 on page 4 and to the Parts List and
Assembly Diagram located on pages 4 and 5.
Charging
Your Spotlight Battery (#9) is rechargeable. To recharge your Battery (#9) your Spotlight comes with a Power
Adapter (#13).
Step 1)
Step 2)
Insert the cord end of the Power Adapter (#13) into the outlet on the back of the Spotlight.
Plug the Power Adapter (#13) into the electrical outlet.
The red light indicates the unit is properly plugged in. Leave the Power Adapter (#13) plugged
in for approximately 12 to 14 hours until the Spotlight is fully charged. The red light will shut off
automatically when the battery is fully charged. Recharging time is 8 to 10 hours. Always
unplug the Power Adapter (#13) from the Spotlight after the Spotlight is charged. The Spotlight
will not function properly if the Power Adapter is plugged into the Spotlight.
Note: Always recharge the Spotlight within a 24 hour period after each use.
Caution: Never completely discharge the battery. Deep battery discharge will decrease battery life.
The battery capacity will be reduced if the Spotlight is not used for 3 months. It is recommended that the
battery be re-charged at least one time every 3 months.
Note:The battery should be charged before the first use.
Car Adapter
Your Spotlight comes with a Car Adapter (#14). To operate your Car Adapter follow the steps listed below.
Step 1)
Insert the cord end of the Car Adapter (#14) into the outlet on the back of the Spotlight. Plug
the plug end of the Car Adapter Car Adapter (#14) into your car’s lighter -see Figure 1 on
page 4. Leave the Car Adapter (#14) plugged in for approximately 9 to 12 hours until the
Spotlight is fully charged. Recharging time is 5 to 8 hours.
Step 2)
Note:
Always unplug the Car Adapter (#14) from the Spotlight after the Spotlight is charged. The
Spotlight will not function properly if the Car Adapter is plugged into the Spotlight.
When charging the Spotlight, only place the Spotlight on a non-flammable surface.
Tripod Adapter
Step 1)
Your Spotlight can be screwed onto a tripod or workstand (neither is included). At the bottom
of theTrigger Grip Handle there isTripod Adapter (#6). Screw the tripod or workstand into
thisTripod Adapter.
#42417
Rev 11/00
REV 10/02
REV 11/02
REV 05/03
REV 06/03
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
On/Off with LockingTrigger Hold
Your Spotlight is equipped with a Trigger Hold to allow you to have the Spotlight on while leaving your hands free
for work.
Step 1)
To turn on your Spotlight, press down on theTrigger (#11). Pressing down on theTrigger (#11)
will engage the LockingTrigger Hold (#10)-see Figure 1. Note:Never leave Spotlight unattended
with the Locking Trigger Hold left on.
Step 2)
To release the Trigger Hold (#10), push in on the left side of the Locking Trigger Hold button
(#10) -see Figure 1.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO NOT OPERATE THE TOOL.
ABS Housing (1)
Lamp Lid (5)
Car Adapter (14)
Locking Trigger Hold (10)
Trigger (11)
Hanging Strap (12)
Tripod Adapter (6)
Figure 1
Unpacking
UNPACK AND CHECK CONTENTS
When unpacking your Spotlight-1,000,000 Candle Power check to make sure the following parts are included. If
any parts are missing or broken, please call HARBOR FREIGHTTOOLS at 1-800-444-3353.
Parts Listing
Part #
Description
ABS Housing
Reflector Plastic
Bulb
Glass
Lamp Lid
Quantity Part #
Description
Switch
Battery
LockingTrigger Hold
Trigger
Hanging Strap
Power Adapter
Car Adapter
Quantity
1
2
3
4
5
6
7
1
1
1
1
1
1
1
8
9
1
1
1
1
1
1
1
10
11
12
13
14
Tripod Adapter
Circuit Board
Warning - Battery Disposal
The Spotlight is powered by a battery which will have a long life span. When the battery is no longer
functioning, it should be removed from the Spotlight and properly recycled. Many states require
recycling. Contact your local solid waste authority for information on recycling.
Before disposing of the battery, wrap exposed terminals with heavy tape to prevent a shorting condition,
which could cause fire and/or injury.
NEVER EXPOSETHE BATTERYTO HIGH HEAT OR FIRE; BATTERY MAY EXPLODE UNDERTHESE
CONDITIONS.
#42417
REV 11/02
REV 05/05
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly Diagram
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
12
13
14
PLEASE READTHE FOLLOWING CAREFULLY
THE MANUFACTURERAND/OR DISTRIBUTOR HAS PROVIDEDTHE PARTS DIAGRAM INTHIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OFANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKEANY REPAIRS TO THE PRODUCT ORTHAT HE OR SHE IS QUALIFIED TO REPLACEANY PARTS
OFTHE PRODUCT. IN FACT, THE MANUFACTURERAND/OR DISTRIBUTOR EXPRESSLY STATESTHAT
ALL REPAIRSAND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIEDAND LICENSED
TECHNICIANSAND NOT BYTHE BUYER.THE BUYERASSUMESALL RISKAND LIABILITYARISING OUT
OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR
ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
#42417
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
|