Continuous Ink Supply System
for
Canon IP 1000
Installation Instruction
For ST Prefilled Version
This Version of the Continuous Ink Flow System comes with Prefilled
Cartridges. You just need to fill the Reservoir bottles and print! The
whole operation is very easy. It’s really an effective tool to save your
money.
3、Installation Procedures:
Step1 Preparation
Put the CISS on the left side of the printer.
and place all the tubes at correct position.
Pull out the small rubber plug from the
air hole as the picture shown above.
Place 4 pcs of air filters into air holes.
Step 2 Take out the original cartridges
Turn on power
Open the printer cover, move the cartridge
Carriage to “cartridge replace position”,
And take out the original cartridges
Then turn off the printer and unplugg
Step 3. Set up the Continuous Ink Supply System
Close the cartridge cover
Remove the cartridge bottom cap. And put Fix the supporting arm as the picture shows.
the CIS cartridges into cartridge Carriage. Measure 11 cm from the right edge of printer,
1 cm from the below edge, which forms an
angle of 60°.
Place the tube through supporting arm. Move the cartridge car to left end and right end. Make sure that the tubes are not too tight or too
loose.
Insert a scrip in the proper position of printer Close the front cover with a sticky tap and Installation is finished.
top cover as the picture shown above.
avoid the tube being clamped tightly.
4. Refill ink
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the picture shown above,
please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the ink refill holes (There
is possibility of ink spattering. Pls be careful.) Refill ink according to the colors. Then re-cap the rubber. (Please keep
the printer and the reservoir bottles at the same horizontal line during the process of refilling ink.)
5. Attention for Maintenance:
Take out the CISS including the inner cartridges and other components. Then remove support arm from printer, and
re-install original cartridges. Please inquire local dealer before sending to maintenance.
6. Notice:
1. Please don’t take out cartridge at random after installing the CIS system. Keep the reservoir bottles on the same
level with the printer.
2. Try to keep at least 1/2 inch of ink in the bottles.
3. Don’t place the Reservoir Bottles too much higher or lower than the printer.
4. Suggested using in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight.
5. Don’t reverse or lean the continuous ink supply systems during shipping. Please make sure all the ink filling holes
and ventilation holes are closed tightly during transportation. Otherwise, the ink may leak.
6. Don’t sway the cartridge frequently. It may cause ink leakage.
7. Don’t pull out the connector of cartridge and don’t tear off adhesive tape at the bottom of cartridge.
7. Warning:
1. Not drinkable; keep it out reach of children.
2. Avoid exposure to direct sunshine and don’t keep it in high or freezing temperature.
3. Avoid collision and fallen down.
|