EF-S17-55mm f/2.8 IS USM
ENG
Download from Www.Somanuals.com. All Manuals Search And Download.
Instruction
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes or
modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. Tse limits are designed to provide reasonable protection
againshmful interference in a residential installation. This
ment generates, uses and can radiate radio frequency
y and, if not installed and used in accordance with the
inructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
a Safety Precautions
• Do not look at the sun or a bright light source
through the lens or camera. Doing so could
result in loss of vision. Looking at the sun directly
through the lens is especially hazardous.
• Whether it is attached to the camera or not, do
not leave the lens under the sun without the
lens cap attached. This is to prevent the lens from
concentrating the sun’s rays, which could cause a
fire.
Handling Cautions
• If the lens is taken from a cold environment i
a warm one, condensation may develoon th
lens surface and internal parts. To prevnt
condensation in this case, first put the lens ito n
airtight plastic bag before taking it from a cold to
warm environment. Then take out the lens after it
has warmed gradually. Do the same when taking
the lens from a warm environment into a cold one.
• Do not leave the lens in excessive heat such as in
a car in direct sunlight. High temperatures can
cause the lens to malfunction.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
This Class B digital apparatus complies with Canadian ICES-003.
ENG-2
Download from Www.Somanuals.com. All Manuals Search And Download.
Nomenclature
Zoom position index (→ 5)
Focusing ring (→ 4)
Hood mount
(→ 9)
Distance scale (→ 5)
Filter mounting
thread (→ 8)
Focus mode switch
(→ 4)
Zoom ring (→ 5)
Contacts (→ 4)
Lens mount index (→ 4)
Image stabilizer switch (→ 6)
For detailed information, reference page numbers are provided in parentheses (→ **).
ENG-3
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting and Detaching the Lens
Setting the Focus Mode
1
2
See your camera’s instructions for details on
mounting and detaching the lens.
To shoot in autofocus (AF) mode, set the focus
mode witch to AF.
¡After detaching the lens, place the lens with the
rear end up to prevent the lens surface and
electrical contacts from getting scratched.
¡If the contacts get soiled, scratched, or ave
fingerprints on them, corrosion or faulty
connections can result. The camera and lens
may not operate properly.
use nly manual focusing (MF), set the focus
de switch to MF, and focus by turning the
focusing ring. The focusing ring always works,
regardless of the focus mode.
After autofocusing in ONE SHOT AF mode, focus
manually by pressing the shutter button halfway
and turning the focusing ring. (Full-time manual
focus)
¡If the contacts get soiled or have fingerprints on
them, clean them with a soft cloth.
¡If you remove the lens, cover it with the dust
cap. To attach it properly, align the lens mount
index and the ¢ index of the dust cap as shown
in the diagram, and turn clockwise. To remove
it, reverse the order.
ENG-4
Download from Www.Somanuals.com. All Manuals Search And Download.
Zooming
Infinity Compensation Mark
3
4
Infinity Compensation Mark
Distance index
To zoom, turn the lens’ zoom ring.
To compensate for shifting of the infinity focus
point tht results from changes in temperature.
infinty position at normal temperature is the
pnt at which the vertical line of the L mark is
alined with the distance indicator on the
distance scale.
Be sure to finish zooming before focusing.
Changing the zoom ring after focusing can affect
the focus.
For accurate manual focusing on subjects at
infinity distance, look through the viewfinder while
rotating the focusing ring.
ENG-5
Download from Www.Somanuals.com. All Manuals Search And Download.
Image Stabilizer
5
You can use the image stabilizer in AF or MF mode.
Set the STABILIZER
When you ss the
1switch to
2shutteuttn
.
¡If you are not going to
use the image stabilizer
function, set the switch to
.
halfwe Image
Stabilizer will start
operating.
¡Make sure the image in
the viewfinder is stable,
then press the shutter
button the rest of the
way down to take the
picture.
The image stabilizer in this lens
is effective for hand-held shots
under the following conditions.
¡
In semi-darkened areas such
as indoors or outdoors at night.
In locations where flash
¡
photography is prohibited, such as
art museums and theater stages.
¡In situations where your
footing is uncertain.
¡
In situations where fast shutter
settings cannot be used.
ENG-6
Download from Www.Somanuals.com. All Manuals Search And Download.
Image Stabilizer
¡The Image Stabilizer cannot compensate for a
blurred shot caused by a subject that moved.
¡When you use a tripod, the Image Stabilizer
should be turned off to save battery power.
¡The stabilizer is equally effective for hand-held
photography and photography with a monopod.
¡The image stabilizer function also operates
when the lens is used with an Extension Tube
EF12 ll.
¡Set the STABILIZER switch to
when you
are taking pictures using the Bulb setting (long
exposures). If the STABILIZER switch is set
to
, the image stabilizer function may
introduce errors.
¡The Image Stabilizer might not be fully effective
in the following cases:
¡Pictures may look distorted after being taken
depending on the camera, but this doesn't affect
shoting.
¡If yu set the camera’s Custom Function to
change the assigned button to operate the AF,
the Image Stabilizer will operate when you press
the newly assigned AF button.
• You move the camera for a panned shot.
• You shoot while riding on a bumpy road.
¡The Image Stabilizer consumes more power
than normal shooting, so fewer shots can be
taken if you use the function.
¡The image stabilizer operates for about wo
seconds even when your finger is off the shuter
button. Do not remove the lens while the
stabilizer is in operation. This will cause a
malfunction.
ENG-7
Download from Www.Somanuals.com. All Manuals Search And Download.
Filters (Sold Separately)
Extension Tubes (Sold Separately)
6
7
You can attach filters to the filter mounting
thread on the front of the lens.
You can attach Extension Tube EF12 II for
magnified shots. The shooting distance and
magnification are shown below.
¡Only one filter may be attached.
¡If you need a polarizing filter, use the Canon
Circular Polarizing Filter (77mm).
¡To adjust the polarizing filter, first remove the
lens hood.
Camera-to-Subject
Magnification
Distance (mm)
Near
Far
Incompatible
334 0.45×
Near
Far
17mm
55mm
EF12 II
205
0.23×
Althogh Extension Tube EF25 II can be attached,
it is not recommended because the lens-to-subject
distance will be very short.
Manual focusing is recommended for accurate
focusing.
ENG-8
Download from Www.Somanuals.com. All Manuals Search And Download.
Hood (Sold Separately)
8
The EW-83J hood can keep unwanted light out of the lens, and also protects the lens from rain,
snow, and dust.
To attach the hood, align the hood’s attachment posmark with the red dot on the front of the
lens, then turn the hood as shown by the arroil te lens' red dot is aligned with the hood's stop
position mark.
The hood can be reverse-mounted on the lens for storage.
¡Part of the picture may be blocked if the hood is not attached properly.
¡When attaching or detaching the hood, grasp the base of the hood to turn it. To prevent deformation, do not
grasp the rim of the hood to turn it.
ENG-9
Download from Www.Somanuals.com. All Manuals Search And Download.
Close-up Lenses (Sold separately)
9
Attaching a 500D (77mm) Close-up Lens
enables close-up photography.
Magnification will be 0.23× – 0.03×.
¡Close-up Lens 250D cannot be attached
because there is no size that fits the lens.
¡Manual focusing is recommended for accurate
focusing.
ENG-10
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
10
Focal Length/Aperture
Lens Construction
Minimum Aperture
Angle of View
17 – 55 mm f/2.8
12 groups, 19 elements
f/22
Diagonal: 78° 30’ – 27° 50’
Horizontal: 68° 40’ – 23° 20’
0.35 m/1.2 ft.
0.17 × (at 55 mm)
approx. 207 × 310 – 88 × 131 mm/8.1 × 12.2 – 3.5 × 5.2 inch
Vertical: 48° – 15° 40’
Min. Focusing Distance
Max. Magnification
Field of View
Filter Diameter
Max. Diameter and Length
Weight
77 mm
83.5 × 110.6 mm/3.3 inc
645 g/22.7 oz
Hood
Lens Cap
EW-83J (Sold sely
E-77U/E-7 II
Case
LP1219 (Sold separately)
¡Equivalent to 27-88 mm in the 35mm film format.
¡The lens length is measured from the mount surface to the front end of the lens. Add 21.5 mm to include the
E-77U lens cap and dust cap, and 24.2 mm for the E-77 II.
¡The size and weight listed are for the lens only, except as indicated.
¡The EF1.4X II/EF2X II extenders cannot be used with this lens.
¡Aperture settings are specified on the camera.
¡All data listed is measured according to Canon standards.
¡Product specifications and appearance are subject to change without notice.
ENG-11
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
0812Ni © CANON INC. 2006
CT1-8502-010
|