Bradley Smoker Printer Accessories S19 220DCPT User Manual

Installation  
S19-220DCPT  
Wall-Mounted Eyewash with  
Dust Cover  
Table of Contents  
Pre-Installation Information . . . . . . . . . . . . . . . .2  
Installation Instructions . . . . . . . . . . . . . . . . . . . .3  
Assembly of Components . . . . . . . . . . . . . . . . . .4  
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4  
215-1255 Rev. D; EN 06-532G  
© 2007 Bradley Corporation  
P.O. Box 309, Menomonee Falls, WI USA 53052-0309  
PHONE 1-800-BRADLEY FAX (262) 251-5817  
Page 1 of 4  
4/30/07  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
S19-220DCPT  
Installation Instructions  
NOTE: Flush the water supply line  
before beginning installation.  
4-5/8"  
(119mm)  
8-1/4"  
(210mm)  
Supplies Required:  
• (3) 3/8" wall fasteners and bolts  
• Pipe sealant  
13-5/8"  
(346mm)  
• Piping to 1/2" IPS water supply inlet  
on unit  
• Sign-mounting hardware  
Ø10-3/4"  
(273mm)  
Step 1: Install inlet drain fittings  
21-1/2"  
(546mm)  
NOTE: Top of eyewash heads should be  
33"-45" (838mm-1142mm) from floor.  
17-1/4"  
(438mm)  
1. Position the inlet drain fitting over  
the 1-1/4" drain outlet pipe from  
wall.  
2. Using the inlet drain fitting as a  
template, mark the bolt hole  
locations on wall OR install three  
suitable fasteners (supplied by  
installer) for 3/8" bolts in the wall  
at the marked hole locations (see  
Figure 1).  
8-3/4"  
(222mm)  
4"  
(102mm)  
2-1/4"  
(57mm)  
5/16"  
(8mm)  
MTG.  
5-1/4"  
133mm)  
3. Bolt the inlet drain fitting to the  
wall or wall fasteners using 3/8"  
bolts (supplied by installer).  
HOLE  
Step 2: Assemble eyewash  
1. Assemble eyewash components as  
shown in Figure 2 on page 4.  
• Apply pipe sealant (supplied by  
installer) to all male-threaded  
pipe joints.  
• Use a strap wrench around pipes  
when tightening to prevent  
marring.  
36" (914mm)  
Suggested  
Height  
To Floor  
Step 3: Connect water supply  
30-1/2" (775mm)  
Suggested  
Height  
8-3/4"  
(222mm)  
1. Connect the water supply piping  
(supplied by installer) to the 1/2"  
IPS inlet on the eyewash.  
To Floor  
14"  
(357mm)  
2. Connect the P-trap and tailpiece to  
the 1-1/4 IPS drain outlet on the  
eyewash.  
Figure 1  
3. Mount the safety sign to a wall or  
pipe using sign-mounting hardware (supplied by installer).  
4. Open the water supply lines. Test for leaks and adequate water flow.  
Bradley Corporation • 215-1255 Rev. D; EN 06-532G  
4/30/07  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
S19-220DCPT  
Installation  
Assembly of Components and Parts List  
1.6  
7
1.5  
Flow Control  
This End  
P
.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA  
TEL: 1-800-BRADLEY FAX: (262-251-5817)  
114-051  
1.4  
1
8
1.9  
R
P
.O. Box 309, Menomonee Falls, WI 53051  
1.7  
TEST THIS UNIT EACH WEEK  
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.  
ESSAI HEBDOMADAIRE  
Test-operate valve(s) each week and sign below.  
Report any malfunctions immediately.  
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt  
durch Unterschrift. Jegliche Störung sofort melden.  
Test le fonctionnement des valves chaque semaine et  
signe en bas. S'il  
y
à
quelque chose qui ne va pas fait  
un rapport immédiatement.  
Date  
Datum  
Date  
Signed  
Unterschrift  
Signe  
Date  
Date  
Date  
Signed  
Signed  
Signed  
1.3  
1.8  
1.2  
1/2" IPS  
Supply Inlet  
1.1  
HANDLE NOTE:  
Close the cover and  
put the pin through  
the clip to keep closed.  
4.1  
1-1/4" IPS  
Drain Outlet  
4.3  
2
3
4.4  
4.2  
5
4.11  
NOTE: Items 1.1 -1.9 come presasembled as Item 1.  
Figure 2  
6
Item Part No.  
Qty  
1
Description  
Item Part No.  
Qty  
1
Description  
Elbow 1/2" IPS Street  
1/2" Valve/Handle Prepack  
1/2" Ball Valve with Nut  
Nut only  
1
S90-301  
111-061  
124-028  
S90-009  
173-009  
S21-071  
S05-091  
269-447  
161-025  
113-1159  
113-006LQ  
Dust Cover /Receptor Assembly  
Inlet-Drain Fitting  
Gasket  
3
4
169-025  
S30-072  
S27-282  
1.1  
1.2  
1.3  
1.4  
1.5  
1.6  
1.7  
1.8  
1.9  
2
1
1
1
4.1  
1
1
Dust Cover Assembly  
Cup Strainer  
4.11 110-215  
1
1
4.2  
4.3  
4.4  
5
S08-056  
142-002DA  
153-372R  
269-167  
269-142  
114-051  
1
Handle Assembly  
Lockwasher  
1
Supply Stem  
1
1
Eyewash Yoke  
Bumper  
1
Adapter  
1
1
Tailpiece  
1
Hex Nut  
6
1
Trap  
1
Spacer, Drain  
7
1
Safety Sign  
1
Pipe 1/2" IPS x 3-1/2" Long  
8
204-421  
1
Emergency Tag  
Prepack S30-087 includes items 4.11, 4.2, 4.3, 4.4  
4
4/30/07  
Bradley Corporation • 215-1255 Rev. D; EN 06-532G  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Blanco Indoor Furnishings 501 113 12 User Manual
Boca Research Network Card M73 APO01 810 User Manual
Bosch Appliances Boiler 14 19 User Manual
Boss Audio Systems Car Stereo System RV 70 User Manual
Brinkmann Smoker 810 5503 S User Manual
Canon Calculator MP27D User Manual
Canon Printer 220 User Manual
Carrier Furnace 58EFA User Manual
Casio Calculator fx 570MS User Manual
Casio Digital Camera YC 430 PJ User Manual