Black Widow Security Automobile Alarm BW 1500 User Manual

BW-1500  
CHALLENGER  
PLUS  
VEHICLE SECURITY SYSTEM  
CHALLENGER PLUS will also lock when arming and unlock  
when the system is disarmed in either manual or passive  
operation.  
USER INSTRUCTIONS  
CONGRATULATIONS on your purchase of the CHAL-  
LENGER PLUS remote vehicle alarm. You now own the most  
reliable security system available today, utilizing the latest state  
of the art technology. It is American made, designed and engi-  
neered by leading experts in the security industry.  
The CHALLENGER PLUS comes with two 2-button code  
learning remote transmitters, flashing L.E.D., electronic sensor,  
and many additional features. It can be programmed as a manual  
or passive system.A number of these safety and convenience  
features can be programmed into your system either by the  
installing dealer, or in some cases yourself (explained below).  
With minimum care and upkeep, this alarm will give you many  
years of service and protection. Read the following information  
carefully. It will help you get the best from your system.  
2) Your system can be programmed by the dealer not to  
lock in the passive mode. In this case your system will arm  
passively, but you must press the left button to lock the  
vehicle.  
3) Your door locks can also be programmed by your deal-  
er to lock when the ignition is turned on and to unlock  
when the ignition is turned off.  
If you have questions, ask your dealer to explain these very conve-  
nient features to you.  
D) AUDIO-VISUAL WARNING INDICATORS –  
When disarming, if you hear 3 chirps (instead of the normal  
2) and the L.E.D. is flashing rapidly, it means either an entry  
violation was attempted or your vehicle was bumped hard  
enough to cause the alarm to trigger (check your vehicle to  
make sure everything is working and there is no damage).  
A) MANUAL OPERATION  
1) TO ARM – Press the left button.You will hear 1 chirp,  
parking lights will flash 1 time, and the L.E.D. will flash slow  
ly after button is pressed.This indicates your system is  
armed.  
E) REMOTE PANIC An important safety feature on your  
CHALLENGER PLUS system is a remote panic which will trig-  
ger your alarm a substantial distance away. Press left button  
for 3 seconds until siren sounds.To stop the siren, press the  
left button.  
2) TO DISARM Press the left button.You will hear 2  
chirps, parking lights will flash 2 times and the L.E.D. will no  
longer flash indicating the system is disarmed. If doors are  
not open before 30 seconds, alarm will re-arm itself.  
F) STARTER INTERRUPT As added protection, the  
CHALLENGER PLUS has a built-in starter interrupt.When the  
system is armed, the vehicle cannot be jump started, hot  
wired, or started with a key.This makes it extremely tough  
on any theft attempt.When you use your transmitter to  
disarm the system, the vehicle can then be started normally.  
B) PASSIVE OPERATION  
1) TO ARM If your installing dealer has installed the  
CHALLENGER PLUS as a passive system, the alarm will  
arm automatically approximately 30 seconds after the last  
door is closed. (Note: you can also arm immediately by  
pressing the left button as in #1 above).  
(Continued on Reverse Side)  
2) TO DISARM Disarm system same as in #2 above.  
3) VALET Your dealer installed a valet (push button)  
switch in a convenient location in the dashboard area.To  
activate the valet, push for 5 seconds prior to turning off  
the engine.The L.E.D. will stay on (non-flashing) while the  
vehicle is inValet.You can now leave the vehicle without  
arming the system.While in valet, with the alarm inactive,  
you can still lock/unlock your doors with the remote trans-  
mitters. See section C.To deactivate from the valet mode,  
turn on the ignition and press the valet switch for 5 seconds.  
Please Keep For Future Reference  
TO USETHE CODE LEARNING  
SEQUENCE FOLLOWTHIS PROCEDURE:  
1. Turn the ignition switch ON/OFF 3 times, leave  
ignition ON the 3rd time.The SIREN will chirp  
once and the Door Locks (if connected) will  
LOCK.  
2. Within 5 SECONDS, press and HOLD theValet  
Switch for 5 seconds, the SIREN will Chirp 3  
Times and the L.E.D. will turn SOLID.The System  
is now in Code Learning Mode.  
C) DOOR LOCK AND UNLOCK  
1) If your vehicle has electronic (automatic) door locks,  
and your dealer connected them to the alarm, the  
Download from Www.Somanuals.com. All Manuals Search And Download.  
(Continued on Reverse Side)  

Black Decker Hot Beverage Maker JKC810 User Manual
Bosch Appliances Washer WFMC6401UC User Manual
Brother All in One Printer MFC J625W User Manual
Canon Film Camera EOS 1000 F User Manual
Carson Automobile Alarm SA 400 Classic User Manual
Casio Clock Radio SCR 100 1 User Manual
Cateye Home Gym EC C400R User Manual
CDA Refrigerator PC85SC User Manual
Christie Digital Systems Projector DHD555 GS User Manual
Chromalox Electric Heater PG434 3 User Manual