Eureka Tents Tent Apex XT User Manual

C
B
With the tent secure, drape the fly over the tent body. The fly only fits  
on the tent one way. Position the fly over the tent with the vestibule  
wing sections over the doors and with the ! section over the all mesh  
end of the tent. Reach under the fly and connect the hook and loop  
tabs to the tent poles. See fig. 7.  
ASSEMBLY INSTRUCTIONS  
APEX XT TENTS:  
Connect the four corner buckles on the fly to their mates on the tent  
webs. Do not fully tighten down any of the webs just yet.  
See fig 8.  
Component List:  
1 Tent Body, 2 Tent Poles, 1 Carry Bag,  
1 Tent Fly, 1 Stake Bag/ Stakes  
D
A
fig. 3  
Unroll and unfold the tent with the floor on the ground.  
Remove the fly and set it aside. Do not stake the tent down  
yet. In windy conditions, we recommend that the mesh end  
should face into the wind and that you stake down one  
corner of this end.  
Start at the front of the tent at  
the end of the pole in one hand and the  
web loop in the other. Push the pole from  
D, grasp  
fig.7  
fig.8  
D
to  
B
creating an arc. Insert the pin into  
Join the shock-corded poles together. Try to prevent pole  
sections from snapping together, as this can damage the  
pole ends. NOTE: Make certain each insert end has seated  
firmly into each plain end.  
the pole ferrule to tension the tent across  
the seam line. Repeat with the other pole;  
At the front of the tent, pull the stake out loop on the vestibule taut and  
stake it down. Make sure that the vestibule is tight across the door.  
Repeat with the other vestibule at the rear of the tent.  
See fig.9.  
C
to A. See fig. 3 and 4.  
fig. 4  
Raise up the tent poles and attach the peak of the tent to them.  
Capture both poles where they cross, with the tent clips. Then  
attach all remaining clips to the poles.  
C
B
Your tent is now free-standing, place it in location that has enough  
room for the fly and stake it down through the corner rings. Stake  
the opposite corners while applying tension to smooth the floor  
wrinkles. NOTE: General purpose stakes are included but snow or  
sand stakes can be purchased at a Eureka! dealer.  
See fig 5 and 6.  
D
fig. 1  
A
At the front corner of the tent-  
A,  
fig.9  
slide the rubber tip of one of the the  
fiberglass poles into the rod sleeve.  
Angle the pole to the opposite  
With the vestibule wing sections staked down and tight, go to the  
open side of the tent, pull out the vent and hold in place with the hook  
and loop tab. Then adjust and tighten all the remaining side release  
buckles.  
fig. 6  
fig. 5  
corner;  
with the second pole and sleeve;  
to  
A
to  
C. At corner B, repeat  
B
D.  
Your tent is now ready for use.  
See fig. 1 and 2.  
NOTE:  
fig. 2  
In strong winds, tie extra ropes to the storm loops on the fly and stake  
down so that the ropes are tight.  
REV C 4.09  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Aastra Telecom Frozen Dessert Maker 2827 006 User Manual
Abocom Network Router FM56CC User Manual
Abocom Switch FE1200 User Manual
AEG Vacuum Cleaner Z6160 User Manual
Aiphone Musical Table AI SSV User Manual
Allied Telesis Switch AT FS708 xx User Manual
ATN Binoculars Ranger Eye 800 User Manual
Audiovox Remote Starter PRO9276TW User Manual
BC Speakers Portable Speaker DE950TN User Manual
Beko Refrigerator kqe 1050 User Manual