Read all instructions BEFORE assembly and USE of product.
KEEP INSTRUCTIONS FOR FUTURE USE.
Model # 8181BT
Nursery Center & Playard
Instruction Manual
Convenience through Innovation and thoughtful design
03.04
Download from Www.Somanuals.com. All Manuals Search And Download.
FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE ASSEMBLING THE PLAYARD, BASSINET AND CHANGING AREA
TO ASSEMBLE PLAYARD
Before you begin: The Baby Trend Playard is designed so that, when
properly setup, the fabric of the playard places pressure on the 4 top rails
making them nearly impossible to unlock. This safety feature is activated
when you push down on the playard floor to lock the bottom rails. When
setting up the playard, if you allow the bottom rails to lock before locking
the top rails, the fabric pressure will not allow you to lock the top rails.
Please see (Fig. 3.) for the proper position of the bottom of the playard
when locking the top rails.
Figure 1.
1. Unzip bag and remove Playard frame (Fig. 1). Undo the 3 Velcro
straps and set mattress aside (Fig. 2).
Figure 2.
2. Stand Playard on legs keeping feet of playard close together as shown
in figure 3. Pull up on top rails until all rails “click” and “lock”.
* READ IMPORTANT: In order to continue, the handle in the
center of the floor of the Playard MUST remain raised in order
for the rail to lock (approx. 45.7 cm or 18 inches). The feet of the
playard should almost touch each other. All 4 bottom rails must
be pointed upward in order to LOCK top rails.
3. Push down on center of Playard floor until it is flat and locks into
position (Fig. 4). The center lock mechanism will lock automatically.
The center lock will rotate clockwise about 90 degrees as it locks.
NOTE: Test rails to make sure they are locked. Push down on each
rail making sure they are rigid and in a set position.
Figure 3
WARNING:All top rails MUST be
straight and locked in position or child may
become entrapped and suffocate.
See figure 5 and 6.
Figure 4
Figure 5
Figure 6
4. Place mattress in Playard with padded side up (Fig. 7).
NOTE: DO NOT insert mattress if using bassinet feature. Go to
bassinet instructions.
5. Feed the 6 Velcro straps (found underneath the mattress), 3 on each
end of the mattress pad, through the slots on the bottom of the sides
of the Playard. Fasten the Velcro tabs to the underside of Playard to
prevent the mattress from moving (Fig. 8) (Fig. 9).
WARNING: To prevent child from
suffocating, Velcro straps MUST be secured
to underside of Playard.
6. Attach the organizer, to any side of the playard, by pushing the plastic
clips down over the top rail. (Fig. 10). The maximum weight capacity
of the organizer is 3 pounds.
3
Playard assembly is now complete and ready to use.
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
FOLDING PLAYARD
To operate the brakes on the wheels, press downward on the brake lever
as shown in figure 11. To release, lift upward on the lever.
1. Undo the 6 Velcro straps holding mattress from underneath Playard
floor. (If mattress is not used in the bassinet). Remove mattress and
set aside.
2. Grasp the center floor lock handle pushing down . Rotate the handle
counter-clockwise about 90 degrees and lift upward until handle is
as high as the top rails. Gather the four feet of the playard together
so that they nearly touch each other. See figure 1 and 2.
Figure 1
NOTE: TOP RAILS OF THE PLAYARD ARE STILL IN THE
“LOCKED” POSITION.
3. Locate release button on the center of the bottom of each top rail.
Lift slightly while squeezing button until the rail clicks. Push down
on rail (while still holding release button in) until side forms a “U”.
Repeat for remaining sides (Fig. 3).
NOTE: If top rail(s) do not form the “U” completely do not force.
Check the floor of your Playard to make sure all bottom rails are
unlocked and pull up on middle handle of floor again. Repeat
step 3.
Figure 2
4. Pull up on handle in center of Playard (Fig. 4). Gather legs of
Playard together.
5. Wrap mattress around Playard frame with padded side facing in.
6. Secure the 3 Velcro straps by feeding through loops on end of
mattress and folding back onto itself (Fig. 5).
7. Place Playard in carry bag so handle comes through opening
between zippers and wheels come through opening in the end
of bag.
Figure 3
WARNING: NEVER LEAVE
INFANT IN PRODUCT WITH SIDES
DOWN. Infant may roll into space be-
tween pad and loose mesh side causing
suffocation.
Figure 4
Figure 5
4
Download from Www.Somanuals.com. All Manuals Search And Download.
PLAYARD BASSINET/CHANGING AREA
03.04
WARNING:
FAILURE TO FOLLOW THESE WARNINGS AND THE
ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY OR DEATH FROM ENTRAPMENT, STRANGULATION,
SUFFOCATION, ETC.
•
•
•
•
•
Adult supervision is always necessary when using your bassinet.
Your playard, including side rails and bottom pad, must be fully erected prior to use.
Top rails must be locked.
Bottom rails must be in flat, locked position.
SUFFOCATION HAZARD: To help prevent suffocation from entrapment, use only the mattress provided
by Baby Trend®. Never use additional mattress or padding. Never use plastic shipping bags or other plastic
film as mattress covers not sold and intended for that purpose. Avoid SUFFOCATION HAZARD caused by
a loose sheet. A fitted sheet is recommended. The fitted sheet must fit the mattress tightly.
STRANGULATION HAZARD: DO NOT place items with a string around childʼs neck, such as hood
strings or pacifier cords. DO NOT suspend string over bassinet or attach strings to toys.
DO NOT add padding or other objects inside your bassinet which will permit a child to climb out.
To prevent your child from falling out of the bassinet discontinue using your bassinet when your child is too
active, able to climb out, weighs over 15 lbs.. (6.8 kgs.), or is over 4 months old.
DO NOT use a water mattress with this bassinet.
•
•
•
•
•
•
•
•
•
•
Use your bassinet with only one child at a time.
Keep bassinet away from stoves, heaters, campfires and other hazards.
Never place a child under the bassinet.
DO NOT store the bassinet in the playard.
The bassinet must be fully assembled and installed, including top rails and bottom pad, before using.
Before each use or assembly, inspect the playard and bassinet / changing area for damaged hardware, loose
joints, missing parts or sharp edges. DO NOT use playard or bassinet if any parts are missing or broken. Call
our Customer Service department at (800) 328-7363 for replacement parts.
To protect your child from falls and other injuries: always use safety belt when child is on the changing table,
always stay within armʼs reach of your child when using the changing table, never leave child unattended.
•
Baby Trend, Inc.
1567 S. Campus Ave.
Ontario, CA 91761
Customer Service Hot Line:
(800) 328-7363
8:00 A.M. to 4:30 P.M. Pacific Standard Time
5
Download from Www.Somanuals.com. All Manuals Search And Download.
TO ASSEMBLE YOUR BASSINET
NOTE: Playard MUST be in a locked set-up position before
installing and using the bassinet feature.
CONTENTS (Fig. 1):
2 Right corner supports
2 Left corner supports
1 Nylon bassinet insert
2 Long metal tubes
2 Medium metal tubes
2 2 Short metal tubes
Figure 1
Figure 2
ASSEMBLY
1. Insert 1 short tube into a medium tube lining up the snap button
and the hole opening. Make sure the snap buttons are exactly fitted
into the holes (Fig. 2). Repeat for the second set of tubes.
2. Unroll the nylon bassinet fabric. Insert one set of the connected
tubes into each long side of the bassinet sleeve (Fig. 3).
NOTE: The printed warning label should be facing toward the
inside of the bassinet and is readable.
3. Insert 1 long tube into the short side of the bassinet sleeve. Repeat
for remaining side.
4. Slide the corner supports onto the ends of each tube (Fig. 4). The
corner support with a hole is used for the mobile. Place this corner
support on the end opposite the changing table.
5. Place assembled bassinet onto the Playard. Push down each of the
corner supports (Fig. 5).
Figure 3.
NOTE: The corner supports are designed to rest on long side of the
Playard (40 in. rail) and wrap around the short side of the Playard
top corner pieces.
6. Place the Playard mattress into the bassinet with the padded
side facing up (Fig. 6). Place corners of mattress into sleeves in
bassinet. (Fig. 7)
Figure 4.
Figure 5.
Figure 6.
Figure 7.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
USING BASSINET/CHANGING AREA
WARNING: Avoid serious injury
or death:
• Always use restraint belt to prevent falls
(Fig. 1).
• Use changer with infant whoʼs weight is less
than 8.2 kg (18 lbs....) and is less than 63.5
cm (25 inches) tall.
• Discontinue use of changer if infant
can push up on hands and knees or sit
unassisted.
Figure 1
• DO NOT carry bassinet/changing area with
infant in it.
• NEVER leave bassinet/changing area on top
of Playard with a child in Playard.
REMOVALAND FOLDING BASSINET/CHANGING AREA
1. Remove mattress from bassinet (Fig.1).
2. Lift bassinet out of Playard (Fig. 2).
3. Remove corner pieces and slide metal tubes from fabric sleeves
(Fig. 3).
4. Separate tubes by pressing on snap buttons and pull apart.
The bassinet is now ready for storage.
Figure 1
NOTE: Store bassinet and changing area with folded Playard in
carry bag.
Figure 3
Figure 2
7
Download from Www.Somanuals.com. All Manuals Search And Download.
TO ASSEMBLE MOBILE
CONTENTS (Fig. 1):
1 Mobile lower arm
1 Mobile upper curved arm
1 Mobile tri-shaped arm
3 Toys
Figure 1.
Always attach the mobile securely to the playard according to these
instruction. Check frequently.
1. Insert the Mobile upper curved arm into the Mobile lower arm until
locked together (Fig. 2)
2. Snap the Mobile tri-shaped arm onto the end of the upper curved arm
(Fig. 3). Connect each of the three toys to the mobile by threading the
string into the slot at the end of each arm.
3. Remove the screw through the battery compartment door, located on the
inside of the lower mobile arm. Insert two AA Batteries as shown in the
diagram (Fig. 4).
Figure 2.
WARNING: Old and new batteries
should not be mixed. Alkaline, standard car-
bon-zinc, and rechargeable nickel-cadmium
batteries should not be mixed. Remove batter-
ies before storing mobile for a prolonged period
of time.
Figure 3.
4. Insert the bottom of the lower mobile arm into the hole in the corner
fitting of the play yard (Fig. 5). To remove the mobile, squeeze the two
plastic tabs that protrude through the bottom of the corner fitting while
pulling upward. The mobile will rotate out of the way for ease in placing
or removing the baby from the bassinet.
WARNING: This mobile is designed
to be used from birth to 5 months. A mobile
is intended for visual stimulation and is not
intended to be touched by the child. Possible
entanglement injury: keep out of the babyʼs
reach. Do Not place your baby directly under
the mobile. Remove mobile from playard when
baby begins to push up on hands and knees.
Figure 4.
WARNING: Do not add additional
strings or straps to attach to a crib or
playpen.
Figure 5.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATION OF THE MUSIC AND NIGHT LITE
The mobile features a three position switch:
Off, Voice, and Manual.
Center-All Off
Left-Music+Light Voice
Activation
Manual Operation Button
Push 1 time for light
Push 2 times for music + light
Push 3rd time to turn off
Right-Manual Operation
for Music+Light
Figure 6.
The night light and music may be activated manually or by voice. Place the on/off
switch in the desired setting. (See figure 6.)
The manual setting requires that you press the manual operation button as shown in
Figure 6 to operate the music and night light.
The voice activated setting will turn both the night light and music on when the baby
cries. The light and music will remain on for 40 seconds.
The music will play:
1. Rock a by Baby
STOP
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT, PLEASE CONTACT OUR
CUSTOMER SERVICE DEPARTMENT AT (800) 328-7363 BETWEEN THE HOURS OF 8:00A.M.
AND 4:30P.M. PACIFIC COAST TIME FOR ASSISTANCE.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
|