The Power of Being There®
Quick Installation Guide
®
SwitchView SC4 UAD
DVI/USB Switch with Audio
The following will help you install your
SwitchView SC4 UAD switch easily.
Should you require further assistance, please
contact Avocent Technical Support.
To install the SwitchView SC4 UAD switch
Connecting local peripherals
1
4
Turn off all servers that will be part of your
SwitchView SC4 UAD switching system. Locate
your USB keyboard, DVI monitor, USB mouse,
speakersandmicrophone.Plug yourDVI monitor
cable into the appropriate CONSOLE port on
the left side of the back of yourswitch. Plug your
USB keyboard cable and yourUSB mouse cable
into the keyboard and mouse ports respectively.
Plug your speaker cable and microphone cable
into the corresponding ports.
Optional
RF ground
(not required for
safety)
2
3
1
2
Connecting your servers
Locate your first cable set consisting of one USB
cable, one DVI cable and two audio cables. The
SwitchView SC4 UAD switching system has four
port sets labeled A-D on the rear of the unit. Plug
the USB cable, the two audio cables (speaker
and microphone) and the DVI cable (monitor)
into the corresponding ports on your server.
Plug the otherends into any of the available server
port sets on your SwitchView SC4 UAD switch.
Repeat this process until all servers are properly
attached to the SwitchView SC4 UAD switch.
switch. Plug one end into the IEC power connector on
the SwitchView SC4 UAD switch. Ensure the power
switch is off, then plug the other end of the power
cord into an AC wall outlet. Turn on your switch first,
then turn on all attached servers.
Environmental
Operating Temperature: 41˚ (5˚C) to 104˚ (40˚C)
Storage Temperature: -4˚ (-20˚C) to 122˚ (50˚C)
Input Power: 60 W; Operating Voltage 100-240 VAC
Power Frequency: 50-60 Hz
Supported Hardware
Switching your servers
4
Server: IBM, Sun, PC/AT, USB and 100% compatibles
Video Modes: VGA, SVGA, XGA, SXGA, UXGA,
WVGA, WSVGA, WXGA, WSXGA, WUXGA,
and HDTV
Press the appropriate front panel button labeled A-D to
access servers in your SwitchView switching system.
LEDs
Eachtargetport(A-D)hasasinglebi-colorLEDonthefront
panel.The LED will be green when the target device is on
andconnectedtotheswitch.TheLEDwillchangetoamber
when the target device is selected (KVM session).
Mechanical
Maximum resolution: Single link DVI up to
1920 x 1200 @ 60Hz (monitor and video card support
for the maximum resolution will vary and should be
verified for compatibility)
NOTE: Cable sets without audio cables are
available if you do not require speaker and
microphone support.
Peripherals: USB keyboard, USB mouse and
IntelliMouse (USB only)
3
Powering your system
H x W x D = 1.75” x 11” x 11” (4.44 x 27.94 x 27.94 cm)
Weight = 4.9 lbs (2.2 kg)
Locate the power cord that came with your
Avocent, the Avocent logo, The Power of Being There, the Cybex logo and SwitchView are registered trademarks of Avocent Corporation or its affiliates. ©2007 Avocent Corporation. All rights reserved.
Download from Www.Somanuals.com. All Manuals Search And Download.
590-609-501B
|