Model AS 9076C
Owner’s Manual
Remote Start
Upgrade Module
FEATURES :
♦
♦
♦
♦
♦
♦
♦
♦
Remote Start Safety Control Switch
Selectable Automatic Timed Start Mode (2 Or 4 Hours Selectable intervals)
On-Board Start Relay
On-Board Accessory Relay
On-Board Ignition 1 Relay
On-Board Ignition 2 Relay
Ignition 2 Relay Selectable On or Off During Cranking
On-Board Parking Light Relay
♦ Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
♦ Tach Signal Learning Circuitry
♦ Two ( + ) and Two ( - ) Safety Shutdown Circuits
♦
♦
Alarm By-Pass Outputs
Selectable Steady or Flashing Parking Lights for Run Indication
♦ Selectable 10 or 15 Minute Run Time
♦
Factory Keyless Upgrade Inputs (Allows Starting From Factory Keyless Entry
Unit)
♦
♦
4 Auxiliary Outputs To Allow Control Of A Factory Alarm
Diesel Glow Plug Preheat Mode select
WARNING!
Be certain that the vehicle is outdoors before using this or any re-
mote vehicle starting device. A running engine produces dangerous
carbon monoxide fumes which can be harmful or fatal if prolonged
exposure occurs. DO NOT remote start the vehicle if the car is ga-
raged.
128-8780
1 of 4
Download from Www.Somanuals.com. All Manuals Search And Download.
To Remote Start The Vehicle:
Press and release the proper button or combination of buttons on your keychain
transmitter to activate the remote start system, typically Lock, Unlock, Lock in
sequence. The vehicle will start and remain running for the pre-programmed
time up to 60 minutes. As a visual indication, the parking lights will flash or turn
on dependent on the programming setup by your installation center.
When you arrive at your vehicle, unlock the vehicle by pressing and releasing the
unlock button of your keychain transmitter or by use of the vehicle key. Enter the
vehicle and turn the ignition key to the on position.
CAUTION! Do not turn the key to the start position. This will cause the starter motor
to engage with the already running engine which could result in dam-
age. Step on the brake pedal to disengage the remote start unit. The
vehicle will continue to run on it's own power.
NOTE: The engine will stop running before the expiration of the pre-pro-
grammed run timer if you complete any of the following:
1. Pressing the proper button or buttons of your keychain transmitter while run-
ning under control of the remote start system will turn the vehicle off.
2. Depress the brake pedal.
3. Open the hood.
4. Move the red handled control switch to the off position.
5. Race the engine to above 4000 RPM.
OPERATING ONAUTOMATIC START UPTIMER MODE
The system has the ability to automatically start the vehicle every 2 or 4 hours
over a 48 hour period. This feature is especially useful in cold climates where
the only means to keep the engine and engine fluids warm is to periodically start
the engine.
WARNING! Be certain that the vehicle is outdoors before using this or any remote
vehicle starting device. A running engine produces dangerous carbon mon-
oxide fumes which can be harmful or fatal if prolonged exposure occurs.
DO NOT remote start the vehicle if the car is garaged.
Page 3
128-8780
3 of 4
Download from Www.Somanuals.com. All Manuals Search And Download.
TO BEGIN THEAUTOMATIC START UPTIMER
1. Turn the ignition key on then off.
2. Within 10 seconds, activate the RF start command two times.
The parking lights will flash 4 times indicating the timed start mode is activated.
The vehicle, on a 2 or 4 hour interval basis, will automatically start, run
for the pre-programmed time (10 of 15 minutes), and then shut off. This will
continue for 48 hours.
NOTE: The automatic start up timer can also be initiated from the keychain trans-
mitter.
To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the
remote start transmitter button'(s).
2. Shut off the vehicle using the keychain transmitter by pressing and releasing
the remote start transmitter button'(s).
3. Within 10 seconds of step 2, activate the RF start command two times.
The parking lights will flash 4 times indicating the timed start mode is activated.
CANCELING THEAUTOMATIC START UPTIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the
brake pedal.
2. Remote start the vehicle using your keychain RF transmitter.
And then
3. Shut off the vehicle using the keychain RF transmitter.
FUNCTION SETTING CHART
To be completed by installer
Lights
Run Time
Steady
___ Min.
Pulse
©2010 Audiovox Electronics Corp., 150 Marcus Blvd. Hauppauge, N.Y. 11788
Page 4
128-8780
128-8780
4 of 4
Download from Www.Somanuals.com. All Manuals Search And Download.
|