Atmel Network Router AT91CAP7E User Manual

CAPTM CUSTOMIZABLE MICROCONTROLLERS  
AT91CAP7E  
AT91CAP7E is an ARM7™-based MCU with a direct FPGA interface, six-layer advanced high-speed  
bus (AHB), peripheral DMA controller and 160 Kbytes of on-chip SRAM. It offers seamless migration to  
AT91CAP7 customizable MCUs for ARM7-plus-FPGA designs. It includes on-chip peripherals such as  
USB 2.0 full speed device, SPI master and slave, two USARTs, three 16-bit timer counters, an 8-channel/  
10-bit analog to digital converter, plus a full-functioned system controller including interrupt and power  
control and supervisory functions.  
The FPGA interface on the AT91CAP7E provides the FPGA with direct access to the AT91CAP7E’s  
on-chip AHB and peripheral DMA controller. This architecture eliminates FPGA-induced bus contention,  
off-loads MCU-to-FPGA communications from the CPU, and frees up the external bus interface for  
external memory access.  
Interfacing an ARM7-based MCU to an FPGA has traditionally been done through the external bus  
interface (EBI) or programmable I/O. Either arrangement requires that the CPU transfer data to and from  
JTAG  
System Controller  
PLL  
Main  
OSC  
ICE  
PLL  
EBI  
WDT  
PMC  
PIT  
AIC  
FPGA Interface  
Static Mem.  
CF  
ARM7TDMI  
NAND Flash  
SDRAM  
32K OSC  
RC OSC  
SHWDC  
RTT  
POR  
SRAM SRAM  
GPBREG  
96KB  
64KB  
POR  
6 -layer AHB Matrix  
AT91CAP7E  
Peripheral DMA  
Controller  
ROM (256KB)  
AMBA Bridge  
APB  
USB  
FS  
Device  
PIO  
x32  
Timer  
x3  
SPI  
USART  
USART  
ADC  
the FPGA one word-at-a-time, basically stealing CPU cycles that should be conserved for processing and  
limiting access to external memory during FPGA operations.  
The FPGA interface on Atmel’s AT91CAP7E provides the FPGA with two AHB masters, four AHB slaves,  
a special direct AHB slave interface to an external RAM through the FPGA, and a programmable ROM  
that remaps the external RAM to emulate and debug the ROM code. Fourteen advanced peripheral bus  
(APB) slaves, two full-duplex DMA channels and 32-bit programmable I/O may be hardware selected to  
share I/O. An on-chip priority interrupt controller provides up to 13 encoded interrupts and two additional  
un-encoded interrupts for DMA transfers.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

2Wire Network Router 3800HGV B User Manual
Acer Computer Monitor ETWS0HPA01 User Manual
Acer Personal Computer Veriton 3300 User Manual
American Audio DJ Equipment PPA 210 User Manual
American Standard Door 3232STE2 User Manual
Audiovox Car Stereo System AVD300T User Manual
Avenview Switch SW HDSDI 8X1 User Manual
AVerMedia Technologies DVR LX5000 User Manual
Baldor Grinder 280F User Manual
BB Electronics Network Card MESR9xx User Manual