Installation
Instructions
3985 Series
T M
DECK-MOUNT
BATH FILLER
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
U.S. Patent No. 5,819,789; D405,165
M968236 Rev.1.2
Required Tools
ADJ. 6-1/2 TO 12
Flat Blade Screwdriver
6-5/8
4-3/4
*Hex key
MOUNTING
SURFACE
Adjustable Wrench
1-1/4
MAX.
1-1/8 D.
3
7-1/4
4
Channel Locks
*Supplied with Fitting
SPOUT ASSEMBLY
3/4-14 MALE
N.P.T. INLETS
1-1/16 D.
(H)
(C)
PREPARE TUBE AND TEE ASSEMBLY
1
2
CAUTION
Turn off hot and cold water supplies before beginning.
Prepare TUBE and TEE ASSEMBLY (1) to fit center to center
VALVE (2) location (between 6-1/2" and12"). If necessary,
cut and/or bend TUBING carefully. Make sure tube bend is
close to the TEE (1) so that it will not effect the compression
joint at the VALVE CONNECTION.
Insert SPOUT SHANK (1) through center hole of MOUNTING LEDGE.
Make sure that the RUBBER RING (2) is properly seated in RECESS
at base of SPOUT (3).
Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto
SHANK (1). From underside of ledge secure SPOUT (3) into position
with LOCKNUT (6).
Remove COUPLING NUT (3) and FERRULE (4) from each
VALVE (2) and slide onto TUBING (5).
4
3
1
5
3
4
3
1
RECESS
2
MOUNTING
LEDGE.
4
2
5
6
ADJ. 6-1/2 TO 12
NOTE
Download from Www.Somanuals.com. All Manuals Search And Download.
VALVE inlet is 3/4-inch NPT male connector.
|