DISTRIBUTION AMPLIFIERS
DA103-110
DA103-107
MANUAL PART NUMBER: 400-0449-005
DA103-107 & DA103-110
SIDEKICKER®
WITH 2 VIDEO OUTPUTS
USER’S GUIDE
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
PRECAUTIONS / SAFETY WARNINGS
1
·
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
Please read this manual carefully before using your
DA103-107/110. Keep this manual handy for future
reference. These safety instructions are to ensure
the long life of your DA103-107/110 and to prevent
fire and shock hazards. Please read them carefully
and heed all warnings.
equipment is operated in
a
commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
1.1 GENERAL
·
Qualified ALTINEX service personnel or their
authorized representatives must perform all
service.
1.2 INSTALLATION
·
To prevent fire and shock, do not expose this
unit to water or moisture. Do not place the
DA103-107/110 in direct sunlight, near heaters
or heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can
harm internal components.
·
Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.
·
·
Handle the DA103-107/110 carefully. Dropping
or jarring can damage the unit.
Do not pull any cables that are attached to the
DA103-107/110.
1.3 CLEANING
·
Clean only with a dry cloth. Never use strong
detergents or solvents, such as alcohol or
thinner. Do not use a wet cloth or water to clean
the unit. Do not open the unit to clean.
1.4 FCC NOTICE
·
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
400-0449-005
2
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
ABOUT YOUR DA103-107/110
2
MECHANICAL
DA103-107
Material/Color
Height
DA103-107/110
DA103-107/110
SIDEKICKER WITH 2 VIDEO
OUTPUTS
Steel/Silver
0.78 in (20 mm)
4.23 in (107 mm)
1.74 in (44 mm)
0.38 lb (0.17 kg)
Width
Depth
The DA103-107/110 provides
transmitting computer or component video to two
different displays from a single computer.
a
means of
Weight
DA103-110
Material/Color
Height
ABS Plastic/Black
0.92 in (23.4 mm)
4.25 in (108 mm)
1.68 in (42.7 mm)
0.16 lb (0.07 kg)
The DA103-107/110 is compact and easy to use.
It offers a female 15-pin HD input and 2 female
15-pin HD output connectors.
Width
Depth
The Sidekicker is capable of being powered from
one of three different sources. The first uses the
+5V on pin 9 of the computer’s 15-pin HD video
connector (VESA standard). If the computer or
video cable does not provide power to the
DA103-107/110, then the second option obtains
power from the computer’s USB port if available.
The video cable provided with the DA103-107/110
has a USB connector on one end for use with this
option. If there is no USB port available, the third
option is to use the +9V adapter.
Weight
DA103-107/110
T° Operating (T° Max)
Humidity
10°C-35°C (50°C)
90% non-condensing
40,000 hrs
MTBF (calculations)
Table 2. DA103-107/110 Mechanical
ELECTRICAL
DA103-107/110
Input Video Signal
Analog Signal Level
Impedance
1.0 Vp-p max
75W
TECHNICAL SPECIFICATIONS
3
Input Sync Signal
H & V SYNC
Specifications are subject to change.
TTL
Impedance
10 kW
FEATURES/
Output Video Signals
Analog Signal Level
Impedance
Output Sync Signals
H&V Sync Levels
Impedance
DA103-107/110
DESCRIPTION
0dB +/- 0.3dB
Inputs
75W
Video
15-pin HD female (1)
2.5mm DC jack (1)
Power
TTL
Outputs
75W
Power
RGBHV/YPbPr
Compatibility
15-pin HD female (2)
Computer/USB Port (+5VDC)
+9V Adapter
140 mA
(0.7 W)
150 mA (1.35 W)
Video Signal
Resolutions
VGA through UXGA,
480p through 1080i
640x480@60Hz
250 ft (76 m)
Accessories Included
Video Cable with USB
2 ft (0.61 m)
9 VDC, 1 A
6 ft (2 m) min.
VGA:
Max. Cable Length
(using ALTINEX cable
CB37200MR)
Power Adapter
UXGA: 1600x1200@60Hz
200 ft (61 m)
Table 3. DA103-107/110 Electrical
Table 1. DA103-107/110 General
400-0449-005
3
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
PRODUCT DESCRIPTION
4
DA103-107
POWER 9V, 1A
POWER/SIGNAL PRESENT
RED = POWER
GREEN = SIGNAL PRESENT
VIDEO INPUT
VIDEO OUTPUT 1
VIDEO OUTPUT 2
DA103-110
POWER 9V, 1A
POWER/SIGNAL PRESENT
RED = POWER
GREEN = SIGNAL PRESENT
VIDEO INPUT
VIDEO OUTPUT 1
VIDEO OUTPUT 2
400-0449-005
4
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
APPLICATION DIAGRAMS
DIAGRAM 1: TYPICAL SETUP
5
The DA103-107 is shown in the diagram below, but
both the DA103-110 and DA103-107 have the save
functionality.
400-0449-005
5
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
DIAGRAM 2: INTERNAL VIEW
The block diagram for both the DA103-107 and the
DA103-110 is shown below.
SIGNAL
POWER
DETECT
POWER
2.5mm
9V, 1A
R1
G1
R
G
VIDEO
15-PIN HD
OUTPUT 1
VIDEO
15-PIN HD
B
B1
INPUT
H
H1
V1
V
PLUG AND PLAY
R2
G2
VIDEO
B2
15-PIN HD
OUTPUT 2
H2
V2
400-0449-005
6
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
INSTALLING YOUR DA103-107/110
6
OPERATION
The DA103-107/110 requires no adjustments for
proper performance. Once set-up, the
DA103-107/110 will work trouble-free without user
intervention.
7
Step 1. Connect the input of the DA103-107/110
to the video output of the computer using
the cable provided. The Signal Present
LED should be on. The LED will be red if
there is power and green if a video signal
is present.
TROUBLESHOOTING GUIDE
8
We have carefully tested and found no problems in
the supplied DA103-107/110. However, we would
like to offer suggestions for the following:
NOTE: The
DA103-107/110
derives
power from the video output
connector of the computer. If the
computer does not supply power
at the video connector, it is
necessary to connect the USB
connector (from the video cable
provided) to an unused USB port
on the computer. If there is no
USB port available, proceed to
Step 2 and use the external
adapter.
8.1 THE LED IS NOT RED.
Cause 1: There is no power.
Solution: Verify
the
DA103-107/110
is
connected to the proper power
adapter or USB port.
Solution 2: Make sure the adapter is plugged
into a working outlet and that power
is on.
Step 2. Skip this step if the LED is on.
Cause 2: The cables are loose.
Solution: Verify the power plug from the AC
adapter is plugged all the way into
the DA103-107/110.
Connect the DA103-107/110’s power jack
to an AC power adapter and plug the
adapter into a working outlet.
Cause 3: The
DA103-107/110
has
a
Step 3. If the power is on, the LED on the
DA103-107/110 should be on and red;
green if a signal is present.
problem.
Solution: If there is still no power, the
DA103-107/110 may require
Step 4. Connect VGA-type cables from the
15-pin HD output connectors on the
DA103-107/110 to the display devices.
service. Please call ALTINEX at
(714) 990-2300.
Step 5. The DA103-107/110 is now operational.
Verify the picture quality on the receiving
monitor is equivalent to the quality as
displayed on the local monitor.
400-0449-005
7
Download from Www.Somanuals.com. All Manuals Search And Download.
DISTRIBUTION AMPLIFIERS
8.2 THERE ARE NO REMOTE IMAGES.
Cause 1: The source has a problem.
ALTINEX POLICIES
9
9.1 LIMITED WARRANTY/RETURN POLICIES
Solution: Connect the output of the computer
directly to each monitor and verify
the quality is good. If the images are
good, see Cause 2.
Please see the ALTINEX website at
www.altinex.com for details on warranty and
return policies.
9.2 CONTACT INFORMATION
ALTINEX, Inc.
Cause 2: Cable connections are wrong.
Solution: Verify
the
input
of
the
592 Apollo Street
DA103-107/110 is connected to the
output of the computer using the
cable provided.
Brea, CA 92821 USA
TEL: 714 990-2300
Solution 2: Verify that the Signal Present LED
on the DA103-107/110 is on and
green. If the LED is on and green,
check the connections from the
receiver to the displays.
TOLL FREE: 1-800-ALTINEX
WEB: www.altinex.com
E-MAIL: [email protected]
Solution 3: If the LED on the DA103-107/110 is
red, there may be a problem. Please
call ALTINEX at (714) 990-2300.
400-0449-005
8
Download from Www.Somanuals.com. All Manuals Search And Download.
|