SPEAKER SYSTEM
SX-AVR30
En (English)
E (Español)
OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MODE D’EMPLOI
F (Français)
D (Deutsch)
I (Italiano)
BEDIENUNGSANLEITUNG
ISTRUZIONI PER L’USO
GEBRUIKSAANWIJZING
NÁVOD K OBSLUZE
NL (Nederlands)
Cz (Česky)
M (Magyar)
Po (Polski)
HASZNÁLATI UTASÍTÁS
INSTRUKCJA OBSŁUGI
8C-AS2-906-01
020320ACK-H-FO
EZ
Download from Www.Somanuals.com. All Manuals Search And Download.
Damage Requiring Service
TABLE OF CONTENTS
Have the unit serviced by a qualified service technician if:
- The AC power cord or plug has been damaged
- Foreign objects or liquid have got inside the unit
- The unit has been exposed to rain or water
PRECAUTIONS ........................................................................ 2
BEFORE USE .......................................................................... 4
SPECIFICATIONS .................................................................... 4
POSITIONING .......................................................................... 5
CONNECTION.......................................................................... 6
OPERATING SUB WOOFER ................................................... 7
- The unit does not seem to operate normally
- The unit exhibits a marked change in performance
- The unit has been dropped, or the cabinet has been damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.
En
Check your system and accessories
SX-AVR30
Sub woofer: SX-AVR30 (1)
Satellite speakers
Front: SX-AVR30F (2)
Centre: SX-AVR30C (1)
Rear: SX-AVR30R (2)
Sub woofer connecting cord : 1
Speaker cord : 1, 30 metres of 20 gauge
Operating instructions, etc.
ENGLISH
3
Download from Www.Somanuals.com. All Manuals Search And Download.
BEFORE USE
SPECIFICATIONS
[Sub woofer: SX-AVR30]
This speaker system consists of a sub woofer and satellite
speakers (front, centre and rear speakers).
The satellite speakers have the same appearance. See the back
of the speakers to check the sort of the speakers, front, centre
and rear.
Input terminal:
INPUT jack
Input sensitivity/impedance:
1 V/33 kohms (at 100 Hz)
Power output:
55 W (4 ohms, T.H.D. 1% at 100
Hz)
60 W (4 ohms, T.H.D. 10% at 100
Hz)
[SUB WOOFER]
117 W (DIN MUSIC POWER)
20 Hz - 450 Hz
Bass reflex, magnetically shielded
200 mm cone
AC 230 V, 50 Hz
55 W
On AC voltage
Frequency response:
Speaker type:
Speaker unit:
Power requirement:
Power consumption:
The rated voltage of the unit shown on the rear panel is 230 V
AC. Check that the rated voltage matches your local voltage.
Howling or buzzing sound
A howling or buzzing sound may be heard if a turntable or a
stereo system is placed near the unit. Move the unit away from
the equipment or decrease the volume.
Dimension(W × H × D): 280 × 417 × 395 mm
Weight: 9.5 kg
[Satellite speakers: SX-AVR30F/C/R]
[SATELLITE SPEAKERS]
Speaker:
Full-range, 80 mm, bass reflex
type, magnetically shielded
(except rear)
Speaker’s impedance
The speaker’s impedance is 8 ohms. Make sure that the
connected receiver is equipped with 8-ohms output speaker
terminals such as AIWA AV-NW50/51 and AV-NW30/31.
Speaker’s L/R
Either of the two front and rear speakers can be connected to R
(right) or L (left) terminals.
Impedance:
Maximum input power: 100 W (peak)
Dimension (W × H × D): 98 × 143 × 115 mm
Weight:
8 ohms
0.7 kg
Accessory:
Sub woofer connecting cord (1),
Speaker cord, 30 metres of 20
gauge (1)
[COMMON]
Using the unit near a TV set
Although the unit is magnetically shielded (except rear speakers),
there may be cases in which the picture on some TV sets may
become magnetically distorted.
- If the TV picture is distorted, turn off the power of the TV set
and turn it on again after 15 to 30 minutes.
- If there seems to be no improvement, move the unit further
away from the TV set.
Specifications and external appearance are subject to
change without notice due to product improvement.
- Furthermore, do not place magnets or objects using them,
such as audio racks, toys near the TV set.
These may cause magnetic distortion due to interaction with
the unit.
Keep away magnetic items
Keep cassette tapes, personal credit cards etc. using magnetic
cording away from the unit. The recorded information may be
damaged or some noise may be added.
4
ENGLISH
Download from Www.Somanuals.com. All Manuals Search And Download.
POSITIONING
En
Position the speakers according to the following
recommendations to maximize your Home Theater experience.
Refer to the operating instructions of the receiver as well.
Using a speaker mounting kit (not
supplied)
Each speaker (except sub woofer) is equipped with a "M5"
threaded insert on the back. When attaching a part of the
mounting kit, such as a ball shaft, insert and rotate it into the
threaded female insert.
For best surround sound quality
Sub woofer: Can be placed just about any place in the listening
room without being heard as a distinct source, because very low
frequencies are non-directional in nature.
A typical location for the sub woofer is somewhere along the
front wall, near the TV or one of the front speakers, or any of the
room corners with excellent results.
Centre speaker: Should be placed on top of or below the
television.
Rear speakers: Can be placed either behind the listening position
or to the side depending on your furnishings and the shape of
your room. They can be placed on stands or mounted on the
rear walls using brackets commercially available.
Alternatively they can be mounted on the side walls.
The ideal height for the rear speakers is 60 - 90 cm above the
listening position.
For further information, refer to the instructions of the mounting
kit.
AIWA disclaims any responsibility for injury to persons or
other accidents caused by not fitting the speakers properly
or if the place of the installation is not suitable.
Left and right front speakers: Can be placed directly beside or
up to 90 - 120 cm on either side of the television.
ENGLISH
5
Download from Www.Somanuals.com. All Manuals Search And Download.
CONNECTION
Right
Left
Front speakers
B
Sub woofer
A/V receiver (AV-NW30)
A
ANTENNA
COAXIAL
(VIDEO 2)
AM LOOP
FM 75Ω
(COAXIAL)
OPTICAL
(VIDEO 1)
OPTICAL
(DVD)
DIGITAL IN
PCM
/DOLBY DIGITAL
/DTS
B
SUB
VIDEO
2
WOOFER
DVD
IN
VIDEO 1/MD MONITOR
IN OUT VIDEO OUT
SURROUND
SPEAKERS
CENTER
FRONT
SPEAKERS
/LD/TV
SPEAKER
OUT
IN
R
L
R
L
VIDEO
A
0
9
0
9
0
9
0
9
L
AUDIO
R
B
IN
IN
IN
OUT
OUT
IN
IN
IN
IMP: 8Ω
IMP: 8Ω
IMP: 8Ω
VIDEO
/LD/TV
2
DVD
VIDEO 1/MD
TAPE
AUX
CD
Right
Left
Centre speaker
Surround speakers
B
B
Before connecting the speakers, turn off the power of your stereo
receiver and the sub woofer.
1 Connect the cords to the speakers.
Refer to the operating instructions of the receiver as well.
[ASUB WOOFER]
Connect the INPUT jack on the sub woofer and the SUB
WOOFER output jack on the receiver with the supplied
connecting cord.
To make sure that the all channels are connected with the
same polarity, connect the cords as follows.
Blue striped cords: to the red or blue + terminals
Clear cords: to the - black terminals
[BSATELLITE SPEAKERS]
Before connecting the speakers, cut the supplied speaker cord
to the desired length and strip approximately 10 mm of insulation
from each wire.
2 Connect the other ends of the cords to the
speaker terminals on the receiver.
10 mm
Front speaker cords: to the FRONT SPEAKERS terminals
Centre speaker cord: to the CENTER SPEAKER terminals
Rear speaker cords: to the SURROUND SPEAKERS terminals
Note that the blue stripe cords should be connected to the +
(red) speaker terminals on the receiver (and the clear cords
to the - (black) terminals).
6
ENGLISH
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATING SUB WOOFER
AUTO POWER
VOLUME
POWER
TURN OVER
POWER: Turns the power on and off.
NOTE
After using, press POWER to turn off the power.
If the sub woofer will not be used for a long time, unplug the AC
cord from the outlet.
VOLUME: Adjusts the volume of the sub woofer.
- The volume level should be balanced with that of all other
channels.
En
- If the sound is distorted, turn VOLUME down on the sub woofer
or lower the sub woofer level on the receiver.
- To avoid overloading the sub woofer, do not set the volume of
the receiver so high that the sound becomes distorted.
AUTO POWER: Switches AUTO POWER function on and off.
When the function is set to ON:
- The power is automatically turned off and the unit enters the
standby mode when receiving no signals for about 12 minutes.
- The power is automatically turned on when receiving the signal
input again.
If the level of the signal input is low, the sound may be cut or the
unit may not turn on again by this function.
TURN OVER: Adjusts the output sound range between "300 Hz
and under" and "40 Hz and under".
Turning it clockwise changes the output sound range wider and
reproduces comparatively high frequency sound as well.
Adjust it to suit your preference and a playback source.
ENGLISH
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
|