Addonics Technologies Computer Drive ADSAIDE44 User Manual

ADDONICS TECHNOLOGIES  
Model: ADSAIDE44  
Installation Guide  
Front View  
2. Connect the converter board to the SATA connector of  
the hard drive.  
44-pin IDE Connector  
3. (Optional) Connect the IDE ribbon cable to the 44-pin  
connector on the converter. The red edge of the ribbon  
cable needs to line up to pin 1 marker of the 44-pin  
connector. The other end of the ribbon cable will be  
connected to your motherboard’s 44-pin IDE channel.  
SATA Power and  
Data Connector  
Master, Slave &  
Cable Select  
Jumpers  
Pin 1 Marker  
Jumper Settings  
Master  
Note:  
Slave  
Cable Select  
To set the SATA hard drive as a Master Device  
when connected to an IDE channel, you need to  
short the top pins located on the converter by  
placing a jumper. As a Slave Device short the  
middle pins.  
1. Locate the SATA connector of your 2.5” SATA drive.  
TECHNICAL SUPPORT  
15-pin SATA Power &  
7-pin Data Connector  
Email:  
Internet:  
Technical Support (8:30 am to 6:00 pm PST)  
Phone:  
Email:  
408 573-8580  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Adesso Computer Keyboard WKB 4400UB User Manual
AEG Clothes Dryer T65179AV User Manual
AEG Cooktop 33620 DK M User Manual
Aiphone Film Camera GFK PS User Manual
Aiphone Speaker System LAF 10S User Manual
Aiwa Car Stereo System CT X410 YU User Manual
Allied Telesis Network Router AT TN7100 User Manual
Ativa Chipper CS2171 User Manual
BB Electronics Barcode Reader 232OPSDA User Manual
Beko Microwave Oven D 6674 T User Manual