®
NetVanta 1335 Series
P/N 1700515E2
Quick Start Guide
NETVANTA 1335 FRONT PANEL LAYOUT
GETTING STARTED
3. Insert the connector of the provided power cord into the power interface on the rear panel of
the unit, and plug the cord into a standard electrical outlet.
Two configuration methods are available for your NetVanta 1335 Series units:
•
•
Web-based GUI
4. Once the unit is powered up, open a VT100 terminal session using the following settings:
AOS Command Line Interface (CLI)
9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the AOS CLI.
The GUI lets you configure the main unit settings and provides online guidance and explanations for
each setting. However, using the AOS CLI may be necessary for more advanced configurations.
5. Enter enable at the > prompt. Enter the enable password when prompted. The default
password is password.
ACCESS THE GUI
You may access the web-based GUI from any web browser on your network by following these
steps:
The configuration parameters used in the examples outlined in this
document are for instructional purposes only. Please replace all
underlined entries (example) with your specific parameters to configure
your application.
1. Connect the switch to your PC using any of the 24 Ethernet ports on the front of the unit.
2. Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’s IP address, you
will need to change the unit’s IP address using the CLI. (Refer to the next two sections for
instructions.)
CONFIGURE THE UNIT’S IP ADDRESS
3. Enter the unit’s IP address in your browser address line. The default IP address is 10.10.10.1.
The following steps create an IP address and subnet mask for the virtual interface vlan 1. If you
are not sure what IP address to assign, please contact your network administrator.
4. You will then be prompted for the username and password (the default settings are admin and
password).
1. At the # prompt, enter config terminal.
5. The initial GUI screen appears.
2. At the (config)# prompt, enter interface vlan 1 to access the configuration parameters for
the virtual LAN (VLAN) interface.
ACCESS THE CLI
3. Enter ip address 10.26.12.12 255.255.255.0 to assign an IP address to the VLAN interface
Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the
NetVanta unit’s CONSOLE port, you need the following items:
using a 24-bit subnet mask.
4. Enter no shutdown to activate the virtual interface to pass data.
5. Enter exit to return to the Global Configuration mode.
•
•
VT100 terminal or PC (with VT100 terminal emulation software)
Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate
interface for your terminal or PC communication port on the other end
1. Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear panel
of the unit.
2. Connect the other end of the serial cable to the terminal or PC.
Quick Start Guide, 61700515E2-13A, November 2006
Copyright © 2006 ADTRAN, All Rights Reserved
Download from Www.Somanuals.com. All Manuals Search And Download.
|