MCD 288
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Component video cables (red/
Remote control with two AAA
batteries
A/V cord (R/W/Y)
blue/green)
Quick Start Guide
1
15-pin D-Sub cable (with one
External video box
FM wire antenna
Quick start guide
end fixed on the main set)
2
User Manual
AC power cord
Stand
User manual
Setting the clock
IMPORTANT!
– To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER 2 on the set for
3 seconds or more to switch to normal standby mode first before proceeding with the procedures
below.
1
In standby mode, press and hold CLOCK/RDS on the remote.
2
When the hour digits flash, press VOLUME-/+ (VOL+/- on the remote) to set the hours.
3
Press CLOCK/RDS again and the minute digits flash.Then press VOLUME-/+ (VOL+/-
on the remote) to set the minutes.
4
Press CLOCK/RDS again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connectedTV does not support progressive
signals or the cables are not connected accordingly, see the user manual for proper progressive
scan setup or deactivate the progressive scan feature as below:
1)Turn off yourTV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM MENU on the remote to exit the system menu and then DISC to exit
progressive scan.
DIVX(R) VOD
Tip
See chapters "Preparations" and "System
Menu Options" in the User Manual for
detailed descriptions.
Playing a disc
1
Insert a disc into the slot loader.
e
i
Pr
➜ Make sure the label side is facing you.
➜ Make sure you have removed any other disc from the slot loader.
S
i
n
d
t
e
2
Playback will start automatically. If not pressÉÅ.
3
To stop playback, press 9.
Programming and tuning to radio stations
1
Press SOURCE (TUNER on the remote) to select tuner source.
2
Press PROGRAM for more than two seconds to program all available stations in order of waveband.
3
Press PRESET ¡ / ™ until the desired preset station is displayed.
Playing a USB mass storage device
With the Hi-Fi system, you can use USB flash memory (USB 2.0 or USB1.1),
USB flash players (USB 2.0 or USB1.1), memory cards (requires an additional card reader to
work with this Hi-Fi system).
1
Insert the USB device’s USB plug into the socket
on the set.
2
IMPORTANT!
Slide down to
expose some
Press SOURCE once or more to select USB (or USB/CARD on the remote control).
buttons and jacks on
the front panel!
3
Play the USB’s audio files as you do with the albums/tracks on a CD,
Tip
Detailed playback features and additional functions are
described in the accompany owner's manual.
GB
PDCC-JS/JW-0611
|