Read Me First
for the ProCurve Wireless Edge Services zl Module (J9051A) and
ProCurve Redundant Wireless Services zl Module (J9052A)
Contents
Switch Software and Documentation Updates. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1
Radio Port Bootloader Code Updates for Layer 3 Adoption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1
Compatibility. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2
Changes to Dynamic Frequency Selection (DFS) in the 5 GHz Band . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2
Customers in the U.S. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2
Customers in the European Union and Selected Countries/Regions* . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2
Switch Software and Documentation Updates
ProCurve Wireless Edge Services zl Modules and ProCurve Redundant Wireless Services zl Modules support
ProCurve zl switches (such as 8200zl and 5400zl series) running software version K.12.43 (or later).
Radio Port Bootloader Code Updates for Layer 3 Adoption
A Wireless Edge Services zl Module (or a Redundant Wireless Services zl Module) may adopt a ProCurve Radio
Port in a different Layer 2 domain if the Radio Port has a proper bootloader code version installed. This feature,
“Layer 3 Radio Port adoption”, is discussed in the Management and Configuration Guide for the ProCurve
Wireless Edge Services zl Module and ProCurve Redundant Wireless Services zl Module. See the “Radio Port
Adoption” section of the manual for more information.
A Radio Port ships from the factory with a pre-installed bootloader code version. Depending on the software
version running in a Wireless Edge Services Module and the bootloader code version in the Radio Port, a
compatible version of bootloader code may be automatically downloaded from the Module to the Radio Port
when it is adopted.
Caution
Bootloader code may be automatically downloaded to the Radio Port whenever a module adopts it.
DO NOT unplug the Radio Port until it has been adopted or the LEDs indicate an error. Unplugging
a Radio Port during its adoption may render it unusable.
Preparing Radio Ports for Layer 3 Adoption
To support Layer 3 adoption, a Radio Port must have a proper version of bootloader code installed. The zl Module
will automatically download a proper version during adoption. However, if the current version of bootloader
code is prior to version 01.00-1918R, the adoption must be done by first adopting the Radio Port in the same
Layer 2 domain, either by connecting it directly to the Wireless Services-Enabled zl switch, or by connecting it
to an infrastructure switch in the same Layer 2 domain.
Note
The installed bootloader code version may not be easily identified. The version may be obtained prior to Radio
Port adoption by gathering Radio Port LLDP information while it is connected to a supported switch. However,
if the bootloader code version cannot be identified, you should adopt the Radio Port in the same Layer 2 domain
(as described above) to ensure that the proper bootloader code version is installed.
|