Interference Information
Introduction
Installing the Handset Battery
Registration
Intercom Operation
Battery Safety Precautions
Quick Set-Up Guide
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference; and (2) This device must accept
any interference received, including interference that may cause undesired operation.
CAUTION: When using telephone equipment, there are basic
NOTE: You must connect the handset battery before use.
YOU MUST REGISTER THE HANDSET TO THE MAIN BASE BEFORE USE!
The intercom feature allows you to have a conversation with another registered
handset without tying up the telephone line, allowing you to still receive incoming
calls.
• Do not burn, disassemble, mutilate, or puncture. Like other batteries of this type,
toxic materials could be released which can cause injury.
safety instructions that should always be followed. Refer to the
IMPORTANT SAFETY INSTRUCTIONS provided with this product and
save them for future reference.
After the optional handset has charged for 12 hours on the extra charger, HANDSET
NEEDS REGISTRATION shows in the display.
CAUTION: To reduce the risk of fire or personal injury, use only the
Thomson Inc. approved Lithium battery model 5-2770 or 5-2762,
which is compatible with this unit.
for Optional/Additional
Model 28106 Slim DECT 6.0
Cordless Handset
• To reduce the risk of fire or personal injury, use only the Lithium battery listed
in the User’s Guide.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
1. Press the menu ok/mute button. HOLD BASE PAGE FOR 5 SECONDS, THEN PRESS
HANDSET MENU OK shows in the display. (Your handset should be held near the
base during registration process.)
2. Press and hold the page button on the base unit until the in use indicator flashes.
Press the handset the menu ok/mute button. REGISTERING shows in the display.
HANDSET X REGISTERED shows in the handset display, where X is the handset
number. You may now rename your handset.
Making an Intercom Call
IMPORTANT: Because cordless phones operate on electricity, you should
have at least one phone in your home that isn’t cordless, in case the
power in your home goes out.
1. Locate battery and battery door which are packaged together inside a plastic bag
and are separate from the handset.
2. Locate the battery compartment on the back of the handset.
3. Plug the battery pack cord into the jack inside the compartment.
NOTE: To ensure proper battery installation, the connector is keyed and
can be inserted only one way.
1. Make sure the handset is OFF (not in talk mode).
2. Press the del/conf/intercom button on the handset.
3. Use the touch-tone pad to select the handset you want to page.
NOTE: To cancel page, press the del/conf/intercom button again or the
end button on the sending handset.
4. Wait for the person at the receiving handset to press the del/conf/intercom button.
NOTE: If the receiving handset does not answer within two minutes, the
intercom call is automatically canceled. The originating handset displays
NO ANSWER.
5. When finished, press the end button or del/conf/intercom button on either
handset to deactivate the intercom.
NOTE: The system is expandable up to 6 handsets (by purchase of
optional Model 28106 handset with recharge cradle). When 6 handsets
are registered, the system can handle 2 separate intercom operations
at once, for example, 1st handset intercoms with 2nd handset while 3rd
handset intercoms with 4th handset.
If you have purchased an extra handset apart from your original
purchased unit you may find a detailed description of its functions in the
User’s Guide provided with your original purchased unit.
NOTE: The RBRC seal on the battery used in your Thomson Inc. product
indicates that we are participating in a program to collect and recycle the
rechargeable battery (or batteries).
or call 1-800-8-BATTERY or contact a local recycling center.
Privacy of Communications may not be ensured when using this product.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna (that is, the antenna for radio or television that
is “receiving” the interference).
• Reorient or relocate and increase the separation between the telecommunications
equipment and receiving antenna.
• Connect the telecommunications equipment into an outlet on a circuit different from that
to which the receiving antenna is connected.
If these measures do not eliminate the interference, please consult your dealer or an
experienced radio/television technician for additional suggestions. Also, the Federal
Communications Commission has prepared a helpful booklet, “How To Identify and Resolve
Radio/TV Interference Problems.” This booklet is available from the U.S. Government Printing
Office, Washington, D.C. 20402. Please specify stock number 004-000-00345-4 when ordering
copies.
If you have purchased an extra handset that is not of the same type as
your original handset you may still use the original User’s Guide to help
explain the new handsets basic functions and options.
Naming the Handset
1. Use the touch-tone pad to enter a name (up to 15 characters).
NOTE: If you make a mistake, use the del/conf/intercom button to
backspace and delete one character at a time.
Service
2. Press the menu ok/mute button to save your name. You will hear a confirmation
tone and the handset name shows in the display.
If trouble is experienced with this equipment, for repair or warranty information, please
contact customer service at 1-800-448-0329. If the equipment is causing harm to the
telephone network, the telephone company may request that you disconnect the equipment
until the problem is resolved.
De-Registration
De-registration cancels registration. During the de-registration
This product may be serviced only by the manufacturer or its authorized service agents.
Changes or modifications not expressly approved by Thomson Inc. could void the user’s
authority to operate this product. For instructions on how to obtain service, refer to the
warranty included in this guide or call customer service at 1-800-448-0329.
Or refer inquiries to:
Thomson Inc.
Manager, Consumer Relations
P O Box 1976
Indianapolis, IN 46206
Attach your sales receipt to the booklet for future reference or jot down the date this product
was purchased or received as a gift. This information will be valuable if service should be
required during the warranty period.
Purchase date _________________________________________
Name of store _________________________________________
process, keep the handset near the base.
Receiving an Intercom Call
From the Handset Setup Menu:
When you receive an intercom call, your handset beeps. To answer the call press the
del/conf/intercom button, talk or speaker button.
1. Press the vol/CID ( 6 or 5) button to scroll to the DEREGISTRATION sub-menu.
2. Press the menu ok/mute button to enter the menu. DEREGISTRATION 1YES
42NO shows in the display The default setting is 2NO.
3. Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the vol/CID
( 6 or 5) button to scroll to 1YES or 2NO.
WARNING: It is not recommended that a handset be de-registered unless
absolutely necessary because once a handset is de-registered, that
handset’s telephone features cannot be used until the handset is re-
registered.
Notice: The changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Advanced Intercom Features
Receiving an Incoming Call During an Intercom Call
If you receive a telephone call during an intercom call, the intercom call is
immediately terminated and both handsets ring. Either handset user may press the
talk or speaker button to answer the call.
4. Insert the battery pack.
5. Close the battery compartment by pushing the door up until it snaps into place.
Hearing Aid Compatibility (HAC)
This telephone system meets FCC standards for Hearing Aid Compatibility.
Extra Charging Cradle
for use with Systems
28115 and 28118 Series
FCC RF Radiation Exposure Statement
1. Plug the AC power converter of the extra charging cradle into the electrical outlet.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body. This transmitter must not be co-located or
operated in conjunction with any other antenna or transmitter.”
NOTE: This power adaptor is intended to be correctly orientated in a
vertical or floor mount position.
Using Intercom with External Telephone Calls
4. Select NO, if you do not want to de-register.
5. If you select YES, press the menu ok/mute button and MOVE NEAR TO BASE
displays for 2 seconds, then CONFIRM? 1YES 2NO appears in the display.
6. Press the touch-tone pad to select 1 for YES or 2 for NO, or use the vol/CID ( 6 or
5) button to scroll to 1YES or 2NO.
7. If you select YES, press the menu ok/mute button to confirm. DE-REGISTER...
shows in the display. You will hear a confirmation tone. Then HANDSET X
DEREGISTERED shows in the display to confirm the handset is deregistered.
NOTE: When you complete the de-registration process, HANDSET
NEEDS REGISTRATION shows in the display. To use the handset,
you MUST re-register the handset using the Registration process.
During a telephone call, you may use the intercom/paging function to page another
handset and have an off line, private (two-way) intercom conversation. You may also
have a three-way conversation between the external caller and the handsets, or you
may transfer the external telephone call to another handset.
Parts Checklist
2. Place the handset in the extra charging cradle. The charge indicator turns on,
verifying the battery is charging.
3. Allow the phone to charge for 12 hours prior to first use.
Make sure your package includes the items shown here.
NOTE: Before you intercom/page another handset, you must decide
whether you want to create a two-way or a three-way conversation.
Two-Way Calling
1. During an external call, press the del/conf/intercom button, and use the touch-
tone pad to enter the handset number you want to call.
NOTE: The receiving handset presses the del/conf/intercom button to
answer the intercom call. Both intercom users may speak privately. The
external caller will not hear the intercom conversation.
Global De-registration
Charge
Handset
Cradle
If one or more handsets becomes lost, you should de-register all handsets to ensure
proper system operation. Follow the steps below to de-register all handsets at the
same time.
battery pack
2. When finished, press the end button to end the intercom call, return to the talk
mode, and resume your original telephone conversation.
Three-Way Calling
WARNING: It is not recommended that a handset be de-registered unless
absolutely necessary because once a handset is de-registered, that
handset’s telephone features cannot be used until the handset is re-
registered.
1. During an external call, press the del/conf/intercom button. LINE ON HOLD
Battery
EXTENSION? shows in the display.
2. Use the touch-tone pad to select Handset #. You will hear a paging tone and
PAGING shows in the originating handset’s display.
compartment
cover
Handset
1. Disconnect power from the base by pulling the plug out of the back of the unit.
2. Press and hold the page button and while holding the page button reconnect the
power.
3. Continue to hold the page button until the in use indicator flashes rapidly.
4. Release the page button.
5. Press and release the page button on the base once. All handsets are de-
registered and HANDSET NEEDS REGISTRATION shows in the display.
NOTE: PAGING FROM... shows in the display on the receiving handset,
and the receiving handset presses the del/conf/intercom or talk button
to answer the intercom.
CAUTION:
RISKOFELECTRICSHOCK
DONOTOPEN
3. When the receiving handset connects, press the del/conf/intercom button
on the originating handset to conference with the receiving handset and
the external caller. CONFERENCE shows in the display on the originating and
receiving handsets.
NOTE: A handset can enter conference mode directly by pressing talk or
speaker on the second handset during a call.
THE EXCLAMATION
POINT WITHIN THE
TRIANGLE IS A
THE LIGHTNING
CAUTION: TO REDUCE THE
FLASH AND ARROW RISK OF ELECTRIC SHOCK, DO
WARNING:TO
HEAD WITHIN THE NOT REMOVE COVER (OR
WARNING SIGN
ALERTING YOU OF
IMPORTANT
BACK). NO USER
PREVENT FIRE OR
ELECTRICAL SHOCK
HAZARD, DO NOT
EXPOSETHIS
PRODUCT TO RAIN
OR MOISTURE.
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
“DANGEROUS
VOLTAGE” INSIDE
THE PRODUCT.
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
Thomson Inc.
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
10330 North Meridian Street
Indianapolis, IN 46290
© 2007 Thomson Inc.
Model 28106
00019389 (Rev. 0 Dom E/S)
07-15
SEE MARKING ON BOTTOM / BACK OF PRODUCT
Trademark(s) ® Registered
Marca(s) Registrada(s)
Printed in China
|