Eizo iSound L2 User Manual

SAFETY SYMBOLS  
This manual uses the safety symbols below. They represent critical information. Please read  
them carefully.  
E
Failure to abide by the information in a WARNING may result in serious injury  
and can be life threatening.  
WARNING  
Failure to abide by the information in a CAUTION may result in moderate injury  
CAUTION and/or property or product damage.  
Indicates a prohibited action.  
Copyright© 2000 by EIZO NANAO CORPORATION. All rights reserved. No part of this manual may be  
reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical,  
or otherwise, without the prior written permission of Eizo Nanao Corporation.  
Eizo Nanao Corporation is under no obligation to hold any submitted material or information confidential  
unless prior arrangements are made pursuant to EIZO’s receipt of said information.  
Although every effort has been made to ensure that this manual provides up-to-date information, please note  
that EIZO speaker unit specifications are subject to change without notice.  
i×Sound is a trademark of Eizo Nanao Corporation.  
EIZO is a registered trademark of Eizo Nanao Corporation.  
1
CONTENTS  
• The EIZO i·Sound L2 should only be used as a sound unit for the  
new range of ultra-slim-besel incorporate EIZO LCD monitors.  
PRECAUTIONS ............................................................................................................................3  
INTRODUCTION ...........................................................................................................................5  
1.  
2.  
3.  
4.  
5.  
INSTALLATION .............................................................................................................................9  
TROUBLESHOOTING ................................................................................................................13  
CLEANING ..................................................................................................................................14  
SPECIFICATIONS.......................................................................................................................15  
LIMITED WARRANTY ..........................................................................................................................17  
2
PRECAUTIONS  
E
General  
CAUTION  
• Remove the sound unit whenever moving the monitor.  
Lifting the monitor by the sound unit is dangerous. It may result in injury or equipment  
damage.  
• When adjusting the viewing angle of the monitor, do not do so by the sound unit.  
Adjusting the monitor by the sound unit may dislodge it from the LCD monitor or result in accidental  
pinching of the skin. Be careful not to drop or tip over the LCD monitor when removing the sound  
unit from the monitor.  
3
Cleaning  
WARNING  
• Keep liquids away from the monitor and the sound unit. Spillage into the unit may result in fire,  
shock, or equipment damage.  
CAUTION  
To ensure safety, always unplug the monitor before cleaning the sound unit. Failure to do so  
may result in electric shock.  
• Never use thinner, benzene, or other strong solvents or abrasive cleaners to clean the unit, as  
these may cause damage to the unit.  
WAX  
Others  
• The sound unit is shielded to prevent creating a magnetic field. However, it is advisable not to  
place any magnetic items (ex. recorded cassette tapes, watches, cash cards, floppy diskette,  
etc.) near the unit to avoid any ill-affects to the items.  
• The EIZO i·SoundL2 should only be used as a sound unit for the new range of ultra-  
slim-bezel incorporate EIZO LCD monitors. It should not be used for any other purposes.  
Please ask the EIZO dealer for more information.  
4
1. INTRODUCTION  
AboutThis Manual  
E
This manual explains the precautions, features, specifications, and operation of the EIZO  
i·Sound™ L2 sound unit.  
Package Contents  
i·Sound L2 Sound Unit .................. 1  
• Stereo Mini-jack Cables ................ 1  
• Users Manual ............................... 1  
• If any of the above-listed items is missing or damaged, please contact your local  
dealer for assistance.  
• We recommend that you retain the original packing materials in case of future need.  
5
Features  
The EIZO i·Sound L2 sound unit for LCD monitor is specifically designed for the new range  
of EIZO LCD monitors to make them complete multimedia units. This unit has two speakers  
that produce clear stereo sound and a volume control. It also accepts audio input from  
different audio devices such as a sound board, CD and cassette player.  
Easy clip-on installation and a sleek professional look  
No need for an AC power cord. The unit is connected through a direct power supply  
connector (DC IN) from the monitor. When the monitor enters into a power saving  
mode, the speakers will turn off.  
Two LINE INs to connect two PCs. Each output sound will be mixed from the speakers  
or from the headphone.  
Volume Control  
6
Controls and Connectors  
Top  
LINE IN  
E
HOOK  
HOOK  
DC IN  
Front  
VOLUME  
HEADPHONE  
SPEAKERS  
7
Front / Top  
• DC IN: Power supply from the monitor  
After combining the monitor and the speaker unit, the DC IN connector allows for an  
automatic power supply of the speaker unit through the monitor.  
• HEADPHONE: Headphones jack  
A set of headphones is a great tool to work without disturbing people within a close range.  
When using the headphones, the speakers will not channel any audio information.  
• VOLUME: Volume control dial  
A volume control dial is provided to alter the sound level from the speakers or the head  
phones.  
• LINE IN: External input jack  
Please use this connection for external devices such as audio peripherals, computers, sound  
boards to input sound to be heard through the speakers or headphones.  
8
2. INSTALLATION  
Always switch the monitor off before installing or removing the sound unit and whenever  
connecting or disconnecting any other devices to the sound unit.  
E
How to connect external audio devices and the computer  
1.Remove the power terminal cover of the LCD monitor.  
Turn off the LCD monitor and remove the power terminal cover as shown below. Pull up the  
power terminal cover with your finger, and gently slide the power terminal cover into the  
groove of the LCD monitor. The Power terminal cover stays open. Do not touch the power  
terminal with your finger.  
Rear  
Pull up the power terminal cover with your finger, and  
gently slide the power terminal cover into the groove  
of the LCD monitor.  
Cover  
Power Terminal  
9
2. Connect the sound unit to the LCD monitor.  
1.Attach the sound unit to the LCD monitor. Place the sound unit under the monitor screen  
and insert the hooks ‘a’ on top of the unit into slots ‘a’ located at the bottom of the rear  
of the monitor.  
2.Slide the unit into place by pulling softly from side to side, and hook ‘b’ will snap into  
slot ‘b’.  
To remove the sound unit from the monitor, please hold the unit and press on hook ‘b’  
and slide the sound unit softly with both hands.  
10  
3. Connect the cable of the peripherals to the sound unit.  
• Please use the enclosed Stereo Mini-jack Cable (or another cable with the same  
specifications) for connecting audio devices or computers to the unit. When connecting  
two audio devices to the unit, please purchase another Stereo Mini-jack cable.  
E
1. Connect the headphone jack (or a line out jack) of the device (or a computer) to the LINE  
IN jack of the sound unit using the Stereo Mini-jack Cable.  
2. Insert the power cord and signal cable into the cable holder of the height adjustable stand.  
To Computer  
or Graphics  
Board  
Cable Holder  
11  
Speakers and sound control  
1. Besides the speakers on its unit, audio performance is available by connecting the  
headphones to the i×Sound L2 unit (When headphones are connected, no sound can  
be heard from the speakers.)  
HEADPHONES  
2. Please use the volume control to adjust to the desired sound level.  
DECREASE  
INCREASE  
12  
3. TROUBLESHOOTING  
This page presents problems that can be corrected by the user. If a problem persists even after  
applying the suggested remedies, contact an EIZO dealer.  
E
Problems  
No sound  
Points to check with possible solutions  
Check that the monitor is turned ON.  
Check that the power terminal covers on the monitor are removed.  
Check that the sound unit is correctly connected to the monitor.  
Check that the PowerManager function of the monitor is not in effect.  
Check that the audio devices are correctly connected to the sound unit.  
Check that the connected audio devices are turned ON.  
Check that the volume is set at an audible level.  
If you connect a set of headphones, please remember that no sound will  
come out from the speakers. Check that the headphones are correctly  
connected to the appropriate jack for a good sound quality.  
13  
4. CLEANING  
WARNING  
• Keep liquids away from the monitor and the sound unit. Spillage into the unit may result  
in fire, shock, or equipment damage.  
CAUTION  
To ensure safety, always unplug the monitor before cleaning the sound unit. Failure to do  
so may result in electric shock.  
• Never use thinner, benzene, or other strong solvents or abrasive cleaners to clean the  
unit, as these may cause damage to the unit.  
WAX  
Periodic cleaning is recommended to keep the sound unit looking new and to prolong its  
operational lifetime.  
To remove stains, wipe the unit with a soft, lightly moistened cloth using a mild detergent.  
Do not spray wax or cleaner directly onto the case.  
14  
5. SPECIFICATIONS  
Electrical Specifications  
E
Speaker Unit  
4 x 2.8 cm (two)  
Bass Reflex type  
2.0 W + 2.0 W  
200 Hz ~ 20 kHz  
Volume Control (speakers or headphones if hooked)  
DC 15 V (supplied from monitor)  
Speaker System  
Amplifier Output (max.)  
Frequency Response  
Control  
Power Supply  
Power Consumption (max.) 6.0 W  
Input Connector  
Output Connector  
External Line In Audio: stereo mini-jack  
Headphone: stereo mini-jack  
Mechanical Specifications  
Dimensions  
306 mm (W) x 81 mm (H) x 55 mm (D)  
12,0” (W) x 3,2” (H) x 2,2” (D)  
430 g (0,9 lbs.)  
Weight  
Operating Environmental Specifications  
Temperature  
Operating: 0 °C ~ 35 °C ( 32 °F ~ 104 °F)  
Storage: -20 °C ~ 60 °C (-20 °F ~ 140 °F)  
30% ~ 80% R. H. Non-condensing  
Humidity  
15  
DIMENSIONS  
mm  
SIDE VIEW  
FRONT VIEW  
16  
LIMITED WARRANTY  
Eizo Nanao Corporation (“EIZO”) and EIZO’s authorized distributors warrant to the original purchaser that the product  
shall be free from defect in material and/or workmanship for a period of three (3) years from the date of purchase.  
In the event of malfunction during the warranty period attributable directly to faulty material and/or workmanship, EIZO  
and EIZO’s authorized distributors will, at their option, either repair or replace the faulty product with the same or similar  
model. EIZO and EIZO’s authorized distributors shall have no obligation under this warranty, however, in the following  
cases:  
E
(a) Any defect caused by freight damage, modification, alteration, abuse, misuse, accident, incorrect installation, disaster,  
faulty maintenance or improper repair by third party other than EIZO and EIZOs authorized distributors.  
(b) Any deformation, discoloration, warping or whatsoever due to normal deterioration of the product.  
(c) Any incompatibility of the products with subsequent technical innovations or regulations.  
(d) Any defect of the product caused by external equipment.  
(e) Any defect of the product on which the original serial number has been altered or removed.  
To obtain service under this warranty, the original purchaser must deliver the product, freight prepaid, in its original package  
or other adequate package affording an equal degree of protection, assuming the risk of damage and/or loss in transit, to your  
local EIZO authorized distributor. The original purchaser must present proof of purchase establishing proof and date of  
purchase of the product when requesting warranty service.  
Once the warranty period has expired, the warranty on any replaced and/or repaired part also expires.  
EIZO AND EIZO’S AUTHORIZED DISTRIBUTORS MAKE NO FURTHER WARRANTIES, EXPRESSED OR IMPLIED,  
WITH RESPECT TO THE PRODUCT AND ITS QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR  
ANY PARTICULAR USE. IN NO EVENT SHALL EIZO AND EIZO’S AUTHORIZED DISTRIBUTORS BE LIABLE FOR  
ANY SPECIAL, CONSEQUENTIAL, INCIDENTAL OR OTHERS DAMAGES (INCLUDING, WITHOUT LIMITATION,  
LOSS OR PROFIT) WHETHER OR NOT EIZO AND EIZO’S AUTHORIZED DISTRIBUTORS HAVE BEEN ADVISED OF  
THE POSSIBILITY OF SUCH DAMAGES, ARISING OUT OF ANY BREACH OR REPUDIATION OF CONTRACT, OR  
WARRANTY, NEGLIGENCE, OR OTHERWISE. THIS EXCLUSION ALSO INCLUDES ANY LIABILITY WHICH MAY  
ARISE OUT OF THIRD PARTY CLAIMS AGAINST THE ORIGINAL PURCHASER. THE ESSENCE OF THE PROVI-  
SION IS TO LIMIT THE POTENTIAL LIABILITY OF EIZO AND EIZO’S AUTHORIZED DISTRIBUTORS ARISING OUT  
OF THIS AGREEMENT AND/OR SALES.  
17  

GE PT970SMSS User Manual
Dacor SGM464 User Manual
Dacor MILLENNIA ETT304 1 User Manual
Cres Cor CO151H189B Q1 User Manual
Clarity XLC Cordless 3 5HSB User Manual
BT SYNERGY 4100 User Manual
Black Decker CTO100 Series User Manual
BenQ Computer Monitor G2020HD User Manual
Asus P4P800 X User Manual
Asus MOTHERBOARD P8H61 m2 User Manual